AP HREAP NOT WORKING - NO DHCP, NO INTERNET

Question

Current Setup
WLC > WAN < AP
AP is in HREAP mode
The Wireless SSID shows up at the remote site
Clients can associate to the SSID on the AP (HREAP)
But it's not handing out DHCP address
From the AP (HREAP mode) I cannot ping the WLC (connected via WAN link)
From the AP (HREAP mode) I cannot ping any network on the remote site.
I can access the WLC remotely.
From the WLC i can ping default gateway for the AP dhcp server
From the WLC i cannot ping the AP
On the WLC i cannot see any AP
AP2-1262#show capwap reap association
SSID: WirelessWLAN on Dot11Radio1
bssid: f4ea.67c1.618e Mode: 0x192, WLAN: 2 , VLAN name: 002 VLAN ID: 66
Key Mgmt 12, Reap flags 0x1, Guest Yes, Current Users 0, Open Auth
SSID: WirelessWLAN on Dot11Radio0
bssid: f4ea.67c1.6181 Mode: 0x192, WLAN: 2 , VLAN name: 002 VLAN ID: 66
Key Mgmt 12, Reap flags 0x1, Guest Yes, Current Users 0, Open Auth
Please HELP
Thanks!

Answer 1

Kelly,
You post is confusing.
1. How was your AP able to dowload it's code if there was no connection to the WLC?
An AP firstly gets an IP via dhcp or statically configured and then it searches for a WLC. If the AP doesn't see any WLC, it can never come up. The status lights will keep flashing red and orange.
Since your clients have a layer 2 connection, then that means the AP is up and working with the connection to the WLC. Your problem is solely layer 3.
Check you local vlan mapping on the HREAP AP to ensure that the client vlan is correct. Also check your routing table by using 2 commands on your router: 1.Show ip protocols
                                                 2. Show ip route