Apple logo just blinks will not do anything else.
ipod just blinks apple logo will not do anything else
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar
Similar Messages
-
I accidently disconnected to cord in the middle of updating software on my iphone4. it now has apple logo and blank loading line below. it will not do anything else. can't even switch off please help
Connect the iPhone to the compter you usually sync with
and use iTunes on that computer to do the restore. -
My iPhone 4s is stuck on the apple logo page and will not start up is there anything i can do to fix this problem ?
If you can't update or restore your iPhone, iPad, or iPod touch - Apple Support
-
iPhone 5 won't reboot past Apple logo. It will not show up in iTunes to perform a restore.After the logo appears the phone will get switched of by its own. I updated my phone 2 days before.
The iPhone can only be serviced in the country where it has been bought, and it can't be shipped internationally to Apple Support, you'll or somebody else have to bring it personally. If you registered the phone with your Apple ID, you might not need the receipt, Apple Support should have your data.
Did you try to set it back to factory settings without using any backup afterwards?
Use iTunes to restore your iOS device to factory settings - Apple Support -
Did an update on my phone and now I have the itunes symbol and usb symbol on my screen and my phone will not show anything else, what do i do?
http://support.apple.com/kb/ht1808
-
Ipod only showing the apple logo and will not do anything else. 1st GEN
my ipod will only show the apple logo when plugged in to my computer i have a dell running xp but i have tried other computers and it will not do anything but show this symbol. my computer does not recognise that it is plugged in. ive tried the apple support fix-it but it does not do anything period. the buttons do not work when plugged in or not. the only thing it does is light up when plugged in. my other ipod works perfectly no problems so this leads me to believe that its not the computers i have used. just think the ipod has had it
Mine did the same thing last week after trying to update it via wi-fi. I then spent 11 hours Sunday updating my itunes on the laptop then restoring my ipod. Now all it does is beep as if it is just plugged in and flash the white apple logo. It beeps constantly. My computer at first didn't recognize it, then it did but said I needed to unlock it,(since I can't get the home screen up, I can't.) and now it doesn't recognize it at all. I've tried both computers.
-
My IPOD Touch 3G is frozen on the apple logo. It will allow me to reset it. The computer no longer will recognize it. I have tried on several Macs and it seems as though the problem is with the IPOD and not the computer since none of my MACs will recognize it.
You can try to put it on Recovery mode then restore it..
Press or Hold the power and home keys 10 seconds.
Screen goes black, now release the power button
Make sure you do not release the Home key until
your iTunes says "We have detected an itouch
in recovery mode."
After this its simple all you
got to do is a simple restore using your iTunes -
I have a disc an a cord comming up on my screen will not do anything else whats up with it
I have a disc and a cord on my ipod screen an will not do anything ?
1) Connect to iTunes on the computer you usually Sync with and Restore
http://support.apple.com/kb/HT1414
2) If necessary Place the Device into Recovery mode...
http://support.apple.com/kb/HT1808
Note on Recovery Mode.
You may need to try this More than Once... Be sure to Follow ALL the Steps... -
My iPad began by demanding I sign into iCloud. (I had recently changed my Apple account password.) I entered the password and then iMessage demanded my password for the same account. It would not accept my password and it keeps popping up, not allowing anything else to operate on the iPad. How do I fix this?
Content and Apple IDs -
Content is forever tied to the Apple ID that bought it. Apple does not transfer content from one Apple ID to another. Apple does not merge Apple IDs. You will never be able to access your content bought with another Apple ID with a new Apple ID. -
I have an iPhone 4 . Just last night it was asking me to update my system. So I did now my phone won't turn on or do anything all it does is show a picture of the charger and a iTunes . Please help
Hi Alljays2002,
Thanks for visiting Apple Support Communities.
If you only see the "connect to iTunes" screen on your iPhone, first try to reset it:
Turn your iOS device off and on (restart) and reset
http://support.apple.com/kb/ht1430
To reset, press and hold both the Sleep/Wake and Home buttons for at least 10 seconds, until you see the Apple logo.
If you are not able to reset the iPhone or it returns to the "connect to iTunes" screen, you may need to restore your iPhone using the steps found here:
If you can't update or restore your iOS device
http://support.apple.com/kb/ht1808
Best Regards,
Jeremy -
IPhone 3G stuck at the Apple logo screen and will not boot!
Hello
i have a problem i was using one of my iphones and i needed to restore him
When i have done that restore and updated it it will not bootup anymore.
He installed 3.1.3 then it all started.
I have tried many things and restored alot off times
I have tried DFU mode Restore
I have tried Recovery mode Restore
I have tried another usb / port
I have tried a mac book pro and Restore mode(s) Recovery mode
I have tried installing 3.1 / 3.1.2 no succes.
And i have done a few more things and it's still not booting up
This is whats happening now.
{power on}
Black screen with apple logo in the middle
{few minutes later}
The spinning wheel in the middle then its stuck the spinning wheel is not spinning
{alot of minutes later}
You will see a flash and then he starts all over again
This also happens after restoring or recovering.
Could anyone help out with this one..
Thanks in advanced.Hey i kind of have the same issue.
I bought a iphone about 1 year ago and about 2 months ago i was not able to see any wifi connections in the area or connect to any even though i was sure that there was a wifi nearby and my fellow coleauges could connect to it with their iphone. I thought that this might have something to do with the "restrictions" so i went to turn the restrictions off but realised that it had a passcode that i had forgotten. I wasnt able to restore it within the iphone so i restored it from my computer. Once i had finished the iphone had a " connect to itunes " on the screen and it said that there was no sim car installed, even though there was. I tried cleaning the sim card and everything else, i tried connecting it to itunes but it just said no sim card installed. Now i cannot use my iphone or cant even activate it. I have also tried to restore it in recovery mode but ended up with the same problem. Please Help.! Thanks -
My iPod is stuck on a screen that shows me to connect to iTunes and it wont do anything else...What can I do?
Try:
- First
Connect to computer and restorer via iTunes
For how to restore:
iTunes: Restoring iOS software
If still problem
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
My iPod Classic which I rarely uses. I try to refresh it and put new song into it.
As I try with iTunes, it runs very slow and show that it had problem, need to restore it.
When I tried, it will not and hangs, also slows my HP Win 7 system immensly.
I tried to reset, pressing the middle and menu botton, now it hangs on the apple screen and remains there forever.
What is the problem and how can I solve it?The screen is telling you to connect the iPod to your computer and restore via iTunes.
iTunes: Backing up, updating, and restoring iOS software -
My iPhone 4 is locked with the apple logo displayed it will not turn off - any ideas please
My iPhon4 is screen locked and will not turn off for me to start over. I have connected to iTunes and held down the button but to no effect. It does appear to be connected to I tunes because IT IS LISTING MY MUSIC. any ideas please
Try Recovery Mode... http://support.apple.com/kb/HT1808
Note you'll lose everything since the last sync, thus the reason to sync often. -
My Ipad says disabled it wont funtion it wont go any further
Hey there koolup,
It sounds like your iPad will not unlock because the passcode lock has been forgotten. This article will help you with that named:
iOS: Forgotten passcode or device disabled after entering wrong passcode
http://support.apple.com/kb/ht1212
There are different instructions depending on whether or not you have synced the device to your iTunes library, so be sure to follow the correct ones.
If this is not the issue, would you mind telling me the exact message that is appearing and when it appears?
Thank you for using Apple Support Communities.
All the best,
Sterling
Maybe you are looking for
-
Limitation on Session Size (8K) with Clustering
Hi. Is there a limitation on the session size for a clustered environment. i'm not sure whether its true or not. can anyone please clarify. Also is it for the entire session object or per user. Thanks
-
How to create a folder in which email forms are stored which cab be used and usen again
Hi folks of the free software comunity, in the olden days I used to use a mail program made by MARINET in England. This received an sent emails via a sattelite connection an nothing else. The program had a feature called pre-formed mails: In a specia
-
I can no longer add a scanned document to a pages document since the recent pages upsoftware update . Any ideas on how to resolve this ?
-
Hi All, I have a small doubt regarding Sender sFTP Adapter. This is what we have done to connect with one of Vendor 1. Basis created a SSH key in NWA for Vendor and sent to them. 2. They linked the SSH key with user name and asked me to use t
-
Web Deploy error - "This method is not supported by this class"
I have an MVC project which I am trying to deploy to one of our internally-hosted web front end servers via a TFS build process. Our server hosts the MS Deploy service, and other solutions deploy without problems to the same box. The parameters for t