Apple TV usb port

Set up new Airport router with new name and now Apple TV will not reset. Just keeps cycling for date and time settings. Trying reset with remote does not work. Any way to restore to factory settings?

You can grab a micro usb and restore via iTunes
http://support.apple.com/kb/HT4367?viewlocale=en_US&locale=en_US

Similar Messages

USB ports no longer working after 10.4.7 update

Hi, I ran the latest update (10.4.7) on my machine which is a G4 Quicksilver PowerPC. I have an Apple 17 inch flat screen display that has two USB ports attached. I had my keyboard plugged into one of the USB ports on my flat screen. After the update both USB ports on the flat panel no longer work! I can use the USB ports directly off the G4 itself and it works fine. Has anyone seen this issue? I guess I am stuck now until Apple decides to fix this?
Thanks,
Rob

In my experience, the USB ports on the back of an Apple monitor can be re-enabled simply by unplugging and plugging back in the device in question. You might also check to see that the USB Monitor hub shows up in System Profiler. My Apple monitor USB ports experienced no changes in moving to 10.4.7.
bd

ATV USB Port - How do I Save files to & from ATV

How do you save files to and from the Apple TV USB port?
Can you plug a USB drive to the ATV to save and transfer files?
Thx much to anyone who can help

How do you save files to and from the Apple TV USB port?
There is no official use of that port by anyone outside of Apple.
Can you plug a USB drive to the ATV to save and transfer files?
You can't without hacking it.
(38670)

Some USB ports no longer working after installing Mountain Lion?

Some of my USB ports are no longer working after installing Mountain Lion onto my 21' 2011 iMac. I used to plug in my iphone 4S and charge it, or transfer files onto my iPad but none of the ports no longer work to do this. Funnily enough, other equipment plugged into the works. I have tried changing the cable. Any ideas?

In my experience, the USB ports on the back of an Apple monitor can be re-enabled simply by unplugging and plugging back in the device in question. You might also check to see that the USB Monitor hub shows up in System Profiler. My Apple monitor USB ports experienced no changes in moving to 10.4.7.
bd

Apple USB keyboard does not work with one internal usb port

Hi everyone,
hope someone can help me to solve my problem. I have a MPB13 retina late 2013 since something like 3 months. I have additional screen (dell), usb wired keyboard (apple) and BT magic mouse.
Since a few days, my usb keyboard does not work well. It only want to work properly when plugged to the rights side usb port internal port and not anymore on the left one. It also work on a usb external concentrator. Before, I had no problem, it worked perfectly. There was no problem such as cofee on it...
After searching the web on such problem, I tries a few things such as:
I tried the keyboard on another computer (windows): works fine
I tried usb stick and external DVD reading on the left internal usb ports: works fine
I switch the MPB off and turn it back on: the usb keyboard still does not work on the left usb port
I tried the SMC and PRAM reset : nothing
Any idea ??
Thanks
Guillaume

I'm facing the same problem, found any solutions ?

My ipod touch is connected to my USB port, it sais it's charging although... it doesn't show on itunes that i have plugged my device in, once i turn my ipod on the apple icon appears but then loses battery streight away and starts off all over again.

although it is doing what i asked it to do, i want it to charge, ok so it does it... although when i turn it on it's as if it's either not charged at all but only enough to have the apple icon on my ipod, once it's had enough (which is like, a minute) it switches itself off and carries on charging, sometimes it switches itself on but this just takes it back to step one. also, when i connect my device to the USB port itunes does not recognise it for some reason, i've updated the newest version of itunes recently and i've tried annother ipod on annother computer with the same USB cable, so it's either the newest version of itunes, my ipod or my computer. please help
P.S,
i do have the required version of windows for this to work, my computer isn't a mac, it's a pc, hope this helps...

how long have you had your ipod? mine did the same but after a while you need to get a new one because of the battery...

I have an Apple MacBook Pro with 2 USB ports and a MiniDisplay Port. I also have an HDTV with a HDMI port. How can I use the TV as a display without any tethering wires between my computer and the TV?

I have an Apple MacBook Pro with 2 USB ports and a MiniDisplay Port. I also have an HDTV with a HDMI port. How can I use the TV as a display without any tethering wires between my computer and the TV? I have a MiniDisplay Port to VGA adapter, but there are two issues with it: The new display doesn't have a VGA port, and even if it did, I wouldn't want to have my mac constantly attached to the display by a cable. I was looking for a way to use the TV as a display without any wires. Is there some type of bluetooth setup I could use? Please let me know if you have any suggestions.

As I wrote above, I think you should look into the Apple TV yourself. The best place to find information about what it can and can't do and to ask your own specific questions is probably in the Apple TV forum, here:
https://discussions.apple.com/community/appletv/appletv

Non operational USB ports and stuck on grey apple start up screen

Two problems
1. USB ports are non operational. I believe I fried them by accident. When hooking up an external USB hub, I may have connected an incorrect power supply. Now the USB ports on the front and back of my tower are non operational/do not work. As a work around, I bought a USB pci card and installed it. This has been working for my keyboard, mouse and external hard drives but my iPhone will not sync. My ilok is recognized in system profiler but I cannot download anything to it.
Anyone know how to fix this? Is it possible I fried my main USB port?
2. I was reading different threads and a possible solution to the USB port problem was to reset my PMU. I have no clue why or if this would fix it but I gave it a try. Disconnected power supply and everything else after shutting down the computer. Found the pmu button on logic (or is it the motherboard or is it the same thing?). Pressed it, waited 20 seconds, put computer back together, connected power supply mouse and keyboard and tried to power up. The computer would not power up and the front power light was on but would not power up/boot. In a dumb panic, I opened up the tower and pressed the pmu button again without disconnecting the power. This seemed to work bcause my computer powered up! A red light on the logic board turned on and I got to the grey apple screen. This is where it froze. Hard reset, powered up, same problem. Unplugged power supply and tried again. Same problem. Tried pmu reset (unpluged power this time) and a repeat of the first pmu attempt. I tried starting up with cmd opt o p (I forget the exact letters but it was a reset with starting chimes), then I tried reinstalling with boot DVDs. It would get through the first DVD then restart and get stuck. Finally, I got it to accept second Boot DVD and finish installing and tried starting in safe mode. Got to safe mode and went to disk utility and checked first aid. No reported repairs necessary. Copied all files needed from HD and shut down. The computer did not shut down properly (this has been an ongoing problem before all these current problems and it has had problems booting fulling with hard resets needed once and a while). From here I tried restarting, pulling power supply, staring again and it keeps gettin stuck on grey apple loafing screen. The spinning wheel spins and then gets stuck, fans increase in speed and nothing. I can get back to safe mode either.
I'm very wordy I guess but more info the better, right?
The tower is very very very dusty. I will compress air it to clean it and attempt to clean connectors with alcohol. I will let it sit over night disconnected an then try powering it up.
What could the possible problems be? What can i do? Any suggestions on proper cleaning. I know how to ground properly and not to use a vacuum. I might have pressed the pmu button more than once. I'd the battery dead? Could it be a power supply problem. ****, I'm out of ideas and I really tried solving without posting but I'm poor and need my computer! Help!

Welcome to the forums. Lots of good information and help to be had here.
OK, first, let us know more specifically which of five flavors of Power Mac G5 you have. Find the serial number on the build plate on the inner bottom panel just below the CPUs and use this site to get the exact configuration:
http://www.chipmunk.nl/klantenservice/applemodel.html
In the meantime, assuming that you haven't replaced the PRAM battery in quite a while or ever, that would be a good thing to do.
Getting dust out of the system is a must. The power supply is especially prone to dust buildup. You might want to deal with that by taking the machine outside, as it can get pretty thick coming out.

USB port power management issue on apple aluminium wired keyboard after upgrade to 10.8.5

Hi there,
Since I upgraded my imac (late 2012) from 10.8.4 to 10.8.5 today, i can't plug any usb flash drive, or my iPhone, to the USB port of the wired keyboard anymore; I have a power management message asking to plug the usb device to the imac directly!!
It was working perfectly just before the upgrade, is it a bug, any idea?

FYI...
I tried reporting the bug but so far have had no luck being able to do so.
I went to the developer center as Eric suggested and signed in with my Apple ID.
Once there I clicked on "Bug Reporting".
That took me to a Bug Reporting page with the heading "Submitting Bugs and Feedback".
On the side of that page is a little box that says "Apple Bug Reporter: Sign in with the Apple ID you used to register as an Apple Developer to submit a bug."
(This step seems somewhat ridiculous since I had to sign in with my Apple ID just to get this far. Now it wants me to sign in again.)
When I click the the "Sign in" button I get this:
An error has occurred. Please report the error to Apple Inc. by emailing the error detail to [email protected]
So, it seems the bug reporter doesn't work. This has been going on since the time of my last post here.

Ipod 4 is displaying blue frozen screen and black screen with apple logo. I try to turn power off but as soon as it goes out it automatically reboots. Plugged it into the usb port on my mac and it doesnt do anything. It doesnt appear in Itunes. Help?

ipod 4 is displaying blue frozen screen and black screen with apple logo. I try to turn power off but as soon as it goes out it automatically reboots. Plugged it into the usb port on my mac and it doesnt do anything. It doesnt appear in Itunes. Help?

Let the battery fully darain. After charging for an least an hour try a reset and restore. Use Recovery mode if necessary.
If not successful, then time for an appointment at the Genius Bar of an Apple store.

HT1476 when i plug my phone into the usb port with the apple charger that came with my phone i get an error msg say charging not supported by this device. But when i use a gigaware (radioshack brand) usb charger, no error msg. Why?

when i plug my phone into the usb port with the apple charger that came with my phone i get an error msg say charging not supported by this device. But when i use a gigaware (radioshack brand) usb charger, no error msg. Why?

- Try restoring the iPod, first from backup and then try to factory settings/new iPod to rule out a software problem.
- Look at the dock connector on the iPod. Look for abnormalities like bent or corroded contacts, foreign material and broken or cracked plastic.
- Could you have damaged something when you took the iPod apart and replaced the Home button?

I am a senior citizen newbie to apple. I have just downloaded my pictures from my camera. How do i remove my usb port from my mac pro without damaging anything?

I am a senior citizen newbie to apple. I have just downloaded my pictures to my Mac Pro. How do I remove the usb port without damaging anything. I know I shouldn't just pull it out.

The iphone is a "plug and play" device. It is safe to unplug it without "ejecting it". If you want to be sure it is safe open itunes and under devices next to your iphone you should see the eject symbol like a line with an up arrow above it, click that. Once you no longer see the iphone listed under devices it'll be safe to remove.

HT2801 Apple Store said that the USB SuperDrive would work with my iMac that already has an internal optical drive to be used as a secondary drive, but I can't get it to work when I plug it in the usb port.

Apple store said the USB SuperDrive would work as a secondary drive with my iMac.
After plugging into my USB port, I find it doesn't work. Has anybody else tried this.

Which USB Superdrive are you referring to? If this is the one:
http://store.apple.com/us/product/MD564ZM/A/apple-usb-superdrive
it states it works with Macbook Air, Mini, or MBP with Retina display. If they told you differently, take it back for a full refund and show them their own website.

Recharging my iPod (3rd gen.) on my 2010 iMac goes extremely slowly (via usb port at the back). This is mainly because recharging stops when my mac goes to sleep. I just can't believe that Apple doesn't have a sollution for this, but I haven't found itth

Recharging my iPod shuffle (3rd gen.) on my 2009 iMac (OS 10.5.8) goes extremely slowly (via usb port at the back). This is mainly because recharging stops when my mac goes to sleep. I just can't believe that Apple doesn't have a sollution for this, but I haven't found it yet... What's the most efficient way of recharging?

Purchase a wall charger for it instead.
B-rock

Apple store says ipod mini not working b/c not using usb port 2.0 - true?

My ipod mini (a year old) is frozen/can't be charged. Apple store guy said because I've been using usb port 1.1 and that it is supposed to be used with usb port 2.0. Tells me won't send in for replacement (out of warranty anyway) unless I first update my computer with USB 2.0 card. Is this true?

It's better to use 2.0 because it's faster.
Try resetting it, hold the center [select] button and the menu button until the Apple logo appears. or let the battery die, and then plug it in.

Apple TV usb port

Similar Messages

Maybe you are looking for