ASR - 1002 and Ip radius

Question

hi all,
my customer trying to remove the aaa and tacacs server from the device and fails.
router#conf t
Enter configuration commands, one per line. End with CNTL/Z.
router(config)#no ip radius source-interface Loopback0 vrf DATA
router(config)#no ip radius source-interface Loopback0 vrf Mgmt
router(config)#do sh run | se radius
ip radius source-interface Loopback0 vrf BB2DATA
ip radius source-interface Loopback0 vrf Mgmt-intf
router(config)#no ip radiu
router(config)#no ip radius sou
router(config)#no ip radius source-interface loo
router(config)#no ip radius source-interface loo
router(config)#no ip radius source-interface loop
router(config)#no ip radius source-interface ?
<cr>
router(config)#no ip radius source-interface
router(config)#do sh run | se radius
ip radius source-interface Loopback0 vrf DATA
ip radius source-interface Loopback0 vrf Mgmt
we also tried removing the ip radius without the interface and still shows up with the above results.
rebooting is not an option as this is on a production environment.
currently he is on  Cisco IOS Software, IOS-XE Software (PPC_LINUX_IOSD-ADVIPSERVICESK9-M), Version 15.2(1)S, RELEASE SOFTWARE (fc1)and I could not find any bug/s on cisco tools.
with kind regards,
Lance

Answer 1

Hi Lance,
Can you try like this as mentioned in the below command. This might solve your problem.
conf t# default ip radius source-interface Loopback0 vrf DATA
I made this attempt in a lab scenario it worked out.
R1(config)#do sh runn | in blue
ip vrf blue
ip radius source-interface Loopback0 vrf blue
R1(config)#def
R1(config)#defa
R1(config)#default ip radius source-interface loopback 0 vrf blue
R1(config)#do sh runn | in blue
ip vrf blue
R1(config)#ip vrf
Hope this helps
Regards
Karthik