Audigy 2 ZS + Hercules 5.1 (front right speaker very fai

I dont know if this has been bought up before (i didnt notice it in the first 5 pages) but, After installing the card and drivers, i have noticed that my right channel is very very soft (nearly un detectable). I have run through both the channel and noise tests and all the other speakers work fine, its just the right speaker being very very dull. The same thing happens when im using headphones.
I was wondering if there was a setting that can be changed to fix this?
ThanksMessage Edited by MrEnforcer on 08-04-2005 06:53 PM

check the speaker settings in speaker setup/advanced and replace the rca plug from the PC to the amp

Similar Messages

Front Right Speaker Very Very Quiet!!

Hello,
I have a Creative Inspire P5800 (5.1) Speaker System & my sound card is Creative Sound Blaster Live 24-Bit. All purchased about Septemeber this year, all has been working fine until today when the front right speaker has gone very very quiet!? All other speakers work fine, Can anyone help?
Cheers,
Oidest

I am having the exact same problem and there is no reply to any post on this issue what so ever on the internet.
I have all the other speakers working perfectly. I have tested the speakers on another 5.1 source and they all work fine.
This is such a pathetic problem, which is definitely routed somewhere in the drivers.
I have absolutely no idea where to go.
I used to be able to turn off the Hardware Acceleration to zero and then all 5 speakers would magically work. However now when I do that it is only coming out of speaker (Centre front).
Can't you fix your drivers Creative? I am sending this back to you for creating sub-standard drivers for your hardware.

Front Right Speaker Sometimes not Making a Sound, P5800

Hi,
I have the Creative Inspire P5800 Speakers. Every so often, the sound that my front right speaker makes is very faint. It happens all of a sudden, the only way to fix it is to calibrate my speakers from my Sound Card settings a couple of times before it returns to normal and then it does the same thing again later. My Sound Card is Creative Audigy 2 ZS. This has only started happening when I had to disconnect my cables from the back of my computer as I had to install a new hard drive and install Windows XP and drivers again. My cables are properly connected as I did a Speaker Channel Test and the calibrator reports no miswired cables. Does anyone know how I can fix this?
Thanks in advance.
Message Edited by Cypher_489 on 08-20-2005 07:57 PM

Follow basic troubleshooting found in your user Guide for your phone.
http://manuals.info.apple.com/en_US/iphone_user_guide.pdf

Sound from front right speaker not working, playing out of le

I have a Soundblaster X-Fi Fatalty and it'ss a little under year old with all current drivers. The front right speaker plays no sound but the front left speaker plays what is supposed to come out of the front right. I have it set on the 5. surround sound but it doesn?t work on any other settings. A week ago everything was working fine I have not installed anything new since then. I'm not sure if this is a hardware problem or something set wrong on my computer. Does anyone have a solution or know what may be causing this? Also I checked the speakers, they work fine.Message Edited by Nowise0 on 0-04-2006 03:52 PM

I ghave this same problem with an XFi Elite pro card and a 5. speaker system. To get sound coming out all 5 correct speakers and subwoofer i have to select 7. speaker set up then 5., then 6. and finally 5. again then it works fine - I have to do the selection in THX from game consule mode to get it to work.

GigaWorks G550W Front Right Speaker jack.

I've had my G550W speakers for just over a month now, and for some reason the front right speaker is getting no sound even when the rest are. I've tried a few tests, checked all the software and connections. It seems to me that the problem is the actual speaker conenction jack on the Subwoofer. When I swapped my two front speakers the right speaker (which I initially thought was the issue) worked fine. The speaker cable is also in fine working order.
I don't know why this has happened, the wires have been under no strain, nothing has happened to the subwoofer, so why would this fault occur?
I'm pretty annoyed/worried now because it seems to be a hardware fault and I'm not too pleased.

If it still vibrates after switching btw speakers and when the vol is down, it is probably dc leakage from the amplifier circuit in the sub. It better to let someone to service it before the dc burns your spk voice coil.

Pavilion DV6 (6C35TX) front right speaker sounds terrible

front right speaker makes a crackling sound, how much is it to repair ,replace this speaker
out of warranty

Hello onlinejames,
Starting on Page 91 from the HP Pavilion dv6 Notebook PC Maintenance and Service Guide will show you how to remove and replace the speaker(s) in your HP Pavilion dv6-6c35tx Entertainment Notebook PC.
Speaker Kit (includes left and right speakers and cable).
Spare part number: 665340-001
If you have any issues with finding/ordering the part needed, follow this link: http://partsurfer.hp.com/ContactUs.aspx
Best regards,
I worked on behalf of HP.

Help!! T6060 5.1 Front right speaker is not working properly!!

I have new Inspire t6060 5.1 speakers, but i have problems , because on riht side speaker is not working!! all speakers are working good, only one front right speaker is not working i have altec 97 (asus intergrated suond card), i have tryed to instal new audio drivers , but it has not solved the problem. there is the problem? plz help!!

Here here, you are not the only one.
Have absolutely no solution to this problem apart from sending it back and never buying anything Creative ever again.
They refuse to acknowledge this problem.

Left speaker loud...right speaker very low or not working?

I noticed this because when I hold the iphone I always cover the left speaker and can barely hear whatever is playing be it a song or phone call. I was wondering if this is something I should go into get repaired or if everyone is experiencing this with the iphone?
I cover the left speaker and barely hear anything at all. I cover the right speaker and the left speaker is fairly loud. I'm thinking my right speaker is just not working...too bad I thought I was in the clear sigh everything else is working fine.

Simply because the right grill is a mic, and the left one a speaker, doesn't make the mic grill soundproof to what's audible from the speaker. If sound leaks out of the right grill then that might simply be audio leaking from the playback of the speaker.
But to say it's not true? It says so clearly in the Apple User's Guide, in the keynote Steve himself made to introduce it, and the support videos all over the Apple website.
Call Apple and look into the issue.

Front right speaker makes brbrbr noise

I doubt that such a speaker can be repaired,so the question is,can i buy another,and how can i make the switch?
imac crt 600 blue dal Mac OS 9.2.x

If you get any third party speakers that connect to the headphone port, that would shut down the noise and allow you to have sound. In the meantime, you could plug some headphones into there to quiet things down a bit.

Right speaker very quiet...

i have a inspire 2.1 2500, i've had this for a while, and for a while now, the speaker that i plug into the right port of the subwoofer is really silent. i have the music at a "normal" volume, not too loud but loud, and id have to put the speaker i pluged into the right port right next to my ear just to hear the music playing very very quietly. i've checked all the settings on my computer, i've tried using the onboard soundcard on my mobo, i checked everything! and im pretty sure its my subwoofer thats jacked up. i unscrewed the screws behind the subwoofer and tried to take it out, but could only pull it out of the box alittle bit, somethings blocking the thing! =[ but i could see the inside half of the ports and couldnt tell if anything was wrong with them, i dont have any knowledge of speaker parts or anything though...so i could very well be wrong =/
can anyone help me out with this? =/

That is not a speaker on the right side - it is the microphone... There is only one speaker - the one that you are hearing on the left...
JB
Message was edited by: Jorge*B

Macbook pro 17" right speaker very very quiet

anybody had similar problem? have had to fix by restarting with disk utility twice -and only got the thing yesterday. Anybody know what could be causing it? haven't even installed the graphics software that i use - or any other third party software for that matter yet.
Also the volume isn't audible until the volume 'indicator' is on the fifth block even when it's software 'fixed'. Anyone any ideas?

I'm having the same exact problem, but it's the left speaker that is the quiet one on a MacBook Pro 15". I'm also having the same issue with the volume slider making the machine silent a little less than half way on the speaker display when you use the function keys. These issues seemed to start happening after the SMC firmware update.

No sound from front right/left speakers in 5.1 setting SB Audigy 2 ZS

Dimension 550/E50
XP Media Center 2005
All current Windows Updates (SP3 & all MCE updates)
5. surround sound was working fine until some software changes took place (however, I dont know which was directly related)
A) Intel Chipset update from A to 7.2.2.006, A3
1. It fixes issue with USB keyboard/mouse hang until reboot while installing.
2. It fixes yellow bang in USB controller in Device Manager on a system with USB keyboard/mouse while installing.
3. It fixes a bug where a 3rd party SMBus driver was being overwritten.
4. It fixes Installshield issue with silent mode.
5. It fixes issue in PCIUtility.sys during install on 64-bit OS.
6. It fixes untranslated language strings.
B) Some Microsoft AutoUpdates
didn't discover the loss of front speakers until several updates had run. Restored back to December 08 without any improvements.
After the chipset update, I de-installed all SB and Sigmatel drivers
Then Re-installed the SIGMATEL STAC 92XX C-Major HD Audio driver
and then re-ran the SB Installation CD
still, no front r/l sound
then, i ran the Creative AutoUpdate application and installed recommended updates.
still no sound front l/r --
i switched the rear l/r cable with front, so i know the speakers are fine.
what else can i do
how can i tell if the sound board is faulty
Message Edited by lunde on 04-8-2009 08:32 PMMessage Edited by lunde on 04-8-2009 08:34 PM

I used the Creative Diagnostic application's Speaker Test and after hitting Restore Defaults, the front right speaker is not as quiet, though still much quieter and muffled. Still no sound from the subwoofer.

"Front Left", "Front Right" from the same speak

I am having an issue I am hoping to get answered. I have Boston Acoustic speakers which I am currently using on a new computer with a SoundBlaster XiFi. I can only hear sound from the left channel (The speaker that plugs INTO the right speaker that plugs into the Subwoofer). When I go to run an diagnostics test, it says :
Speaker : Front Left... Front Right
Speaker 2: (Nothing)
Speaker 3: Rear Left
Speaker 4: Rear right.
I know that this is not a problem with the hardware as I can plug these speakers into the computer right next to me & they work fine. I see that this problem crops up very often on these forums, I hope someone can point me in the right direction.
Thanks

No jack problem at all. I have also suffered myself some problems with "speaker switching" with the X-Fi. Only a full reinstall of all creative drivers has solved it, at least for me. I have posted it some times here, but I always get silence as a response. A common problem is that front right speaker dissapears when it was working perfectly.
It's a bug, no matter what Creative says (unfortunately they say nothing), there are a lot of posts regarding this

Right speaker on Macbook Pro (with Retina) not working..

Bought Macbook Pro with retina display yesterday and just noticed sounds is only coming from the left speaker. I've checked on system preferences and when I turn the left hand speaker down there is no sound. Is this a manufacturing error or something I need to do?!

Hi,
Not a lot to go by from the lack of detail in your post, however let me try to help.
[note I may not follo up on your response - just a heads up as i'm very busy [ arent we all]]
Anyway, I bought a HP Pavilliion 500 the other day. and was stoked - awesome machine at a great price locally.
So after plugging in my Altec Lansing 6.1 surround sound speakers using the brown/black/green colour coded input plugs on the back of the PC's audio card (built in) - to correspond with the cables on thealtec lansing, I noticed that 2 speakers were working at the same time, and another speaker did work at all.
I spent about an hour or 2 pulling hair until I finally turned everything off, then plugged it in, then turned n the speakers and then the PC - voila - the speakers were working, one thing I had to do though was move them around as the front right speaker was now the middle etc, no biggy - just moved the speakers around...
PS: there was a siding button on the back n my speakers that allow full 6.1 or stereo - which I hd to change to get it to work.
Also on the altec lansing model I have I had to adjust the surround knob on the main speaker control to #10 for surround for the speakers to work individually.
I hope it helps you somewhat?
Check what inputs you are using. Check the inbuilt sound control software, in my case it was DTS Audio Settings, which allowed me to tweak things a bit.
Sometimes yes it is hardward,but when you know your have "known good speakers"as I did, and a brand new PC - which in theory should handle the speakers I am using, then it can be a combination of trial and error to get them working...
I gues you have the latest drivers, and if you dont have any great input options (ie: if you only have headphones socket) and are using stereo - ty some headphones? - as sometimes it can be the cable socket itself which is just built slightly different so the speakers dont all come thourgh like they should...
Cheers
andy

[Software] Switch Left/Right speake

Hi, I want to switch my front left and front right speaker output with software, because I am unable to switch them physically. Is there any way to do this?
If its needed I am able to switch my rear speakers physically so something that switches both front and rear would be good aswell.
I am using the Sound Blaster X-FI Xtreme Audio card with a set of X-530 Logitech 5. speakers.
Thanks in advance.Message Edited by karozkap on 2-02-200708:3 PM

Should I post this somewhere else? Or is it really utopia? Thks

Audigy 2 ZS + Hercules 5.1 (front right speaker very fai

Similar Messages

Maybe you are looking for