Battery and charger is working fine but the laptop is still not charging

my laptop is a pavilion dv4 and the battery is new and the charger is working because i tested both in another laptop and it works fine but this particular laptop is not charging. what can be the issue?

Could be bad ram or logic board. Take it to an Apple store or AASP.

Similar Messages

I use iPhone, iPad and MacPro, all works fine but the newly purchased iMac does not receive emails on time - always later than other devices. Why and how to fix?

I use iPhone, iPad and MacPro, all works fine but the newly purchased iMac does not receive emails on time - always later than other devices. Why and how to fix?

Go to Mail Preferences
Click on the General tab
Set "Check for New Messages:" to "Every Minute"
Hope this helps

Audigy 2 - Card working fine, but the drivebay-panel does not!

Hello folks
I recently installed a Audigy 2 PCI-card + drivebay-panel in my computer (Win7 x64) installed the drivers from Creatives official website and it's working fine! However that is only the ports on the card itself, i can't seem to get the front panel to work. The original correct flat-cable connects the two (also the 1394-cable) and a floppy-power connector is hooked up to the drive. The optical-S/PDIF Out lights up so it apparently gets power at least, but when i plug my headphones or a mic in i get no sound (knobs are turned up of course) and no reaction on the computer.
I looked in the manual, but there's not much info on the drive. Can't find anything in the knowledge base either, so i'm resorting to this forum
Anyone got an idea what the error might be? I don't think that the drive is physically broken as it's been handled with care and there's no sparks flying or anything Thankful for your help!
Best regards

Originally Posted by jmacguire
This is usually caused by the cable being upside down on either the sound card or the I/O bay. Rotate the cable on both at different times and see if it works
Hi! Appriciate your answer! However the cable and pins, at least on my card, are made assymetric with "missing" pins which match filled holes in the cable, so that it can not be plugged in the wrong way. I will try plugging the cable in the other way around though, but i doubt that's the error.
Would i need to re-install the driver/software package in order to make it work with the computer? Or will it just be "plug and play" once i have the PCI card drivers/software installed already? My computer is painstakingly slow with uninstalling and installing this...
Thanks for your input!

Body onUnload() is not working on Mozilla, I checked it on IE and Chrome, its working fine but on Mozilla it is not working.

I m using <body onunload()> in which I m calling some AJAX function that will affect particular row.
But as I m going to close my browser sch function is not working.
I checked the same on Internet Explorer and google Chrome it's working fine there.
But on Mozilla it is not working.

Any errors in the error console?
Please provide a public URL or reduced test case that exhibits this issue.

When I upgraded my Mac Pro HDs I lost the capcity for 2 monitors. One monitor works fine but the second one is not "seen" by the Mac Pro. Help?

My MacPro is a dual quad core 2.8 intell processor system with 6 gig of RAM and 4 HDs. I recently upgraded the HDs from 500 gig each to 2 TB each. I did that by copying each existing hard drive to a new hard drive and then inserting the new hard drive where the copied drive had been. I followed all of the instructions for the OX system that came after copying and replacing the drive with the OX on it. Unfortunately now I can no longer use the 2 monitors that I used to use on the system. One monitor works fine, the second on is not found by the OX system and simply won't respond or receive a signal from the computer. Any ideas?

Have you tried a NVRAM / PRAM reset?
Shut down your Mac.
Locate the following keys on the keyboard: Command (⌘), Option, P, and R. You will need to hold these keys down simultaneously in step 4.
Turn on the computer.
Press and hold the Command-Option-P-R keys before the gray screen appears.
Hold the keys down until the computer restarts and you hear the startup sound for the second time.
Release the keys.

I've lost a book I was writing, using pages. my mac air could not autosave it because my start up disc was full. the computer froze, i turned it off, then back on, and it was working fine but the file was gone.

ow do I recover a Pages file lost because Mac Air start up disc was full and couldn't autosave?

Unless you've done anything to change it, Google keeps every email that ever passes through their server in your All Mail folder/mailbox/label. Even if you delete stuff, they hold onto it, there. You have to go out of your way to actually delete anything permanently.

I am downloading Firefox but it does not engage. i had a prior version which worked fine but the new version is not even showing a home page.

I downloaded Firefox but it will not start. It has not opened. I do not get a home page from Firefox. I do have an icon from a prior version of Firefox but when I click it, the system takes me to MSN.com home page.

On2CO, I'm glad you have reached out to us today. Thank you so much for the very detail description on what is going on with the device. Sounds like there might be an issue with an application that might be causing these issues. The reason I say that is, when the phone is in Safe Mode you are able to access the Settings screens with no issues. While in Safe Mode that does block all 3rd party applications from running on the phone. I would suggest on trying to back up the device and perform a factory reset: http://spr.ly/6-182Vuo (you would want to make sure to uncheck Automatic Restore in step 3). Once the reset is complete try to see if you can get into Settings. Then, I would recommend on adding 3rd party applications back on to the device one by one to see if we can find what app might be causing this issue. Please keep us posted if you have any further questions or concerns. KevinR_VZW Follow us on Twitter @VZWSupport If my response answered your question please click the "Correct Answer" button under my response. This ensures others can benefit from our conversation. Thanks in advance for your help with this!!

I just replaced my iPod a week ago, and it was working fine, but when I went to go turn the screen on, it wouldn't turn on. Ive tried to put it on the charger and it wouldn't charge and it wont connect to my computer, how do i fix this?

I just replaced my iPod 5th gen. a week ago, and it was working fine, but when I went to go turn the screen on, it wouldn't turn on. I've tried to put it on the charger and it wouldn't charge and it wont connect to my computer, how do i fix this? I tried to reset the iPod, by pressing the home and power button but nothing works. It's literally a brand new iPod, I dont know what to do now. Help?

Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar

I have purchased new iphone 3gs, its usb cable and charger not working.When I plugged in usb cable to my laptop it says"usb power hub exceeded". When I use another cable I have, it works fine.But the original one not working.Any help?

I have purchased new iphone 3gs, its usb cable and charger not working.When I plugged in usb cable to my laptop it says"usb power hub exceeded". When I use another cable I have, it works fine.But the original one not working.Any help?

Are you connecting your iPhone directly to your PC or to a USB hub?

I have a pc running windows 7. I got an Airport Extreme 802.11n Wi-Fi and the printer is now plugged into the Airport. The wireless router works fine but the printer shows as offline in control panel and in word. The printer is a HP LaserJet CP1525nw.

I have a pc running windows 7. I got an Airport Extreme 802.11n Wi-Fi and the printer is now plugged into the Airport. The Airport works fine but the printer shows as offline in control panel and in word. The printer is a HP LaserJet CP1525nw.

+For now I have it set to Share Public IP address - Is this correct for my Network Setup with The Airport Extreme being the only router being used ?+
This would be the correct setting if the AirPort Extreme is connected to a simple modem (one ethernet port).
*Settings I have Enabled*
5 GHz name indicates that you have elected to use the option to assign a separate name to the 5 GHz network. This will allow you to "tell" compatible computers to connect to that network, rather than the slower 2.4 GHz network
Use Wide Channels is recommended for 5 GHz operation.
Interference Robustness often does more harm than good and should not be used unless you know you are in a area with a lot of wireless networks and you feel that your network is experiencing interference issues from a nearby network.

Can you charge a macbook by any other means than the power cord? For example the usb drive? My cord works fine but the outlet on the laptop is not.

Can you charge a macbook by any other means than the power cord? For example the usb drive? My cord works fine but the outlet on the laptop is not.

The only way to charge a MBP is with a MagSafe power supply (wall or airline) try http://support.apple.com/kb/TS1713

Please can anyone help with the continuing password rejection problem with email.Ipad and other systems work fine but despite reloading my password on imac it bounces back.Apple store has been visited and I have tried everything they suggest.

Please can anyone help with the continuing password rejection problem with email on my imac.My Ipad and other systems work fine but despite reloading my password on imac it bounces back.Apple store has been visited and I have tried everything they suggest.

I use free Yahoo mail webMail access because folders I created in webmail access doesn't get set up in Apple Mail. While I was searching for post about password and keychain issues, I stumbled on several threads that complain about Mail folder issues, so I'm holding off on Apple Mail.
On the password and keychain issue that your post is all about. I've been using login keychain to save and automatical fill my login screens for a year or so successfully, with Safari and Chrome. Automatic form fill also works for Facebook login. Unfortunately, about 4 to 6 months ago, automatic password form fill stopped working with Yahoo webmail, while still worked for GMail (Safari and Chrome). I tried deleting the password entry for my two Yahoo email accounts to start fresh, but neither Safari not Chrome will even ask me if I want to save the password. I was so frustrated that I eventually installed the keypassX 0.43 (password manager) that is quite primitive sompare to OS X's keychain (when it works). Probably no surprise to you yet.
The surprise, to me at least, is that, for whatever reason, password auto form-fill from keychain started working again for Yahoo webmail login on Safari about 5-7 days ago. Still doesn't work on Chrome!
Two tips I can share, at least with webmail access:
1. Password is save only for one of my yahoo mail accounts. When I login in with my other yahoo account, I get no prompt to save the password, and form fill doesn't work when I try to log in a second time with my other Yahoo mail account.
2. On inspection of my login keychain, I see a webform password item saved for my Yahoo account that works with keychain. The name of the password is: login.yahoo.com(MyAccountName1#). When I open the password item and look in the Access Control tab, I see Safari and Chome are listed as allowed to access this password item..
I also an "Internet password" item with a name of just login.yahoo.com. When I open the the password item, it looks just like the password item created for MyAccountName#1, but the MyAccountName#2 is listed in the Account field. Inside the Access Control tab, no apps are listed in access permission. I added Safari and Chrome to the lists of allowed app, saved the password item.
Now when I bring up the Yahoo login page(by bookmark) on Safari, form fill fills in MyAccountname#1 for name and the proper password and I can login in. When I change the name to MyAccountName#2, the correct password is retrieved and I can log in! Alas, it still doesn't work on Chrome.
BTW, I changed the password item type from "Internet password" to "Web Form password" and saw no difference! I also edited the name to be "login.yahoo.com (MyAccountName#2)" to look like the web form password item that works, but it has no effect either.
From my experimentation, here's my observation:
1. A Web Form password item is created for the first account name(MyAccountName#1) for login.yahoo.com and typed as Web Form password. When I log in using MyAccountName#2, an Internet Password is created, but no applications are listed as allowed to access the password item, even when the password item was created after just logged in and logged out to yahoo with the account name and password for MyAccountName#2.
2. Manually adding Safari as an app that is allowed to use the password item works. Doesn't work with Chrome!
The version of Safari I'm using is Version 5.1.7 (6534.57.2). My installed version of Chrome is Version 21.0.1180.79 beta.

APPLE TECH TEAM SUGGESTED TO REPLACE MY MACBOOK PRO'S LOGIC BOARD FOR 2ND TIME?All the funtionality and applications is working fine but my screen backlight is off.If i expose it to direct sunlight , i can see what is running on my MAC(out of warranty)

APPLE TECH TEAM SUGGESTED TO REPLACE MY MACBOOK PRO'S LOGIC BOARD FOR 2ND TIME?All the funtionality and applications is working fine but my screen backlight is off.If i expose it to direct sunlight , i can see what is running on my MAC(out of warranty)

likely display inverter board.
did you get your inverter board replaced already?
Did you have a question?
If the diagnostic in shop indicates same, thats 1000X better than anyone can do online in "diagnosis" (not really genuine diagnosis of course)

AirDrop works fine, but the name that comes up on both my mini ipad and iPhone 5 is Selena Gomez. Why? Idk... I checked my phone name in settings and it comes up as MY name. What's going on?

AirDrop works fine, but the name that comes up on both my mini ipad and iPhone 5 is Selena Gomez. Why? Idk... I checked my phone name in settings and it comes up as MY name. What's going on?

Well, then the only answer is that you are Selena Gomez

TS1398 I updated my airport firmware and my Imac works fine, but my two Ipads won't connect to the internet now. How can I fix this?

I updated my airport firmware and my Imac works fine, but my two Ipads won't connect to the internet now. How can I fix this?

Did you check your wifi settings and do a reboot?

Battery and charger is working fine but the laptop is still not charging

Similar Messages

Maybe you are looking for