Battery problem while recording videos.

I got my ipod touch 5 1 month ago. I got a problem while recording videos. The battery was around 40 percent, but after I recorded a video for about 1-2 minutes. The 20% was popup, then it turned off automatically. While I turn on it, the battery will be about 30 percent. It happened several times. Is this normal?
Does anyone have the same problem?
Thanks!

Hi,
Please refer the below link...
http://www.sapfans.com/forums/viewtopic.php?f=27&t=20842
Kuber

Similar Messages

  • Stereo Audio Record problem (While recording video as well)

    Hi,
    I just just bought Sony Xperia C3 dual yesterday. I'm having problem with audio recording. I installed the Sony audio recorder from Google play store but while recording in stereo mode with it the gain suddenly drops after 1/2 second(s). Same problem while recording a video with stock camera app as well, video quality is fine but the audio with it is,just worst. Tried third party app like regorge pro but faced the same problem. Tried disabling the AGC with it, but no good. Recording in mono mode just works fine and I get clear record.
    Any solution?
    Thanks.

    @uliwooly  This one i recorded today morning. The audio starts good & clear at the begining but just after one second it drops & then you can hear the bus engine sounds like waterfall. Here is the youtube link https://www.youtube.com/watch?v=5H1jNxyYMlw Here's another video uploaded by a review site with the same problem https://www.youtube.com/watch?v=z3vKwydfN6U & more from youtube https://www.youtube.com/watch?v=-GLLj2ommP4  then i used a third party audio recorder with mic switch option https://www.youtube.com/watch?v=D6d4uAEZFRE as usual with the rear mic the gain suddenly drops after second & you can hear some weird sounds like a "movie bomb" sound at 00:04, "rattle snake" sound at 00:05 & 00:12 & with the front mic starts at 00:17 you can hear the difference. It's mono but so clear & sharp.  Finally, as i dont have the mic swith option while recording video, all videos i record will have the same problem. This is definitely not  the typical "sony" thing to carry on.

  • I'm having a problem while recording a video

    'm having a problem while recording a video
      When the memory card and the highest quality ..
    Stop and is working
    I recorded video works normally on the memory card.

    Nokia C5-00 5MP

  • Can we take photos still while recording videos on iphone 4s on ios 6??

    Can we take photos while recording videos on iphone 4s using ios 6??

    1. Open the camera app.
    2. Move the slider from in the bottom right from photo to video.
    3. Begin recording your video.
    4. While your video is recording, tap the camera icon in the upper right to take a photo.
    5. You'll see the shutter close on your screen each time you snap a photo.
    6. Your photos will be saved to your camera roll.
    Edit:
    Just noticed you have a 4S...iPhone 5 only, sorry.

  • While recording videos in iPhone 5, I am not getting sound playback.

    While recording videos in iPhone 5, I am not getting sound while playing it. How to resolve this issue? Please help. Thank you.

    Hi manu1982,
    Welcome to Apple Support Communities.
    It sounds like your iPhone has a no sound from the speaker issue. The article linked below provides a lot of great troubleshooting tips that may be able to resolve the issue.
    iPhone: No sound or distorted sound from speaker
    http://support.apple.com/kb/ts5180
    I hope this helps.
    -Jason

  • How long is the iPad battery last while watching video on YouTube with 3G?

    How long is the iPad2 battery last while watching video on YouTube with 3G?

    My iPad 2 battery can use only ~7 hours 15mins when surfing the web using cellular data network. Is it normal?
    I would say that's normal. Cellular uses more power than wifi. Your screen brightness is also a factor. Lower the screen brightness & battery will last longer.
    The quickest way (and really the only way) to charge your iPad is with the included 10W USB Power Adapter. iPad will also charge, although more slowly, when attached to a computer with a high-power USB port (many recent Mac computers) or with an iPhone Power Adapter (5W). When attached to a computer via a standard USB port (most PCs or older Mac computers) iPad will charge very slowly (but iPad indicates not charging). Make sure your computer is on while charging iPad via USB. If iPad is connected to a computer that’s turned off or is in sleep or standby mode, the iPad battery will continue to drain.
    Apple recommends that once a month you let the iPad fully discharge & then recharge to 100%.
    At this link http://www.tomshardware.com/reviews/galaxy-tab-android-tablet,3014-11.html , tests show that the iPad 2 battery (25 watt-hours) will charge to 90% in 3 hours 1 minute. It will charge to 100% in 4 hours 2 minutes. The new iPad has a larger capacity battery (42 watt-hours), so using the 10W charger will obviously take longer. If you are using your iPad while charging, it will take even longer. It's best to turn your new iPad OFF and charge over night. Also look at The iPad's charging challenge explained http://www.macworld.com/article/1150356/ipadcharging.html
    Also, if you have a 3rd generation iPad, look at Apple: iPad Battery Nothing to Get Charged Up About
    http://allthingsd.com/20120327/apple-ipad-battery-nothing-to-get-charged-up-abou t/
    Apple Explains New iPad's Continued Charging Beyond 100% Battery Level
    http://www.macrumors.com/2012/03/27/apple-explains-new-ipads-continued-charging- beyond-100-battery-level/
     Cheers, Tom

  • Shooting stills while recording video with the SX50

    Has anyone done this?  I was shooting some video yesterday and was happy with how it came out until I realized that pressing the shutter button while recording video actually caused the video to insert a black frame and included the shutter sound.  What is this?
    My Kodak Z990 was able to do this same function (take pictures during videos) and even though some of them would turn out a bit blurrier than I would have liked, it never insert a black frame and sure didn't stick the shutter sound in there.  Did Canon do this on purpose?  I'm going to have to try and pull this video into some video editor to remove the frame and sound and hope it works.
    Lesson learned, I guess.  I'll take pictures and video separately from now on, just in case, but it's unfortunate that Canon screwed up badly on this feature.

    Charleyhorse,
    The items you mentioned need to be set before you start the video. Once the G16 is running the video, you cannot make adjustments to white balance, ISO, etc. The people I deal with all run the video for their G16's in Auto mode and let the camera make the decisions. But like myself, they don't use video very often, so hopefully someone with video experience on the G16 can give some better insight.
    Steve M.

  • How do I mute internal microphone while recording video in new ipad

    Is it possible to mute internal microphone while recording video in new ipad

    No. There is no setting to mute the mic.

  • How to fix the delay problem while recording? Can't set the Latency to 0. Win7, CS6,Realtek,C03u Mic

    I am using Win7, with CS6, Realtek soundcard and Samson C03U microphone.
    There is a problem that's really been bothering me. When I record songs the recorded audio always comes 0.1 seconds after where it's supposed to be and I need to fix the problem every time. How to fix the delay problem while recording? I can't set the Latency to zero. The minimum is 30ms and I still get an obvious delay.
    I saw some previous discussions saying that installing ASIO would help. Is it gonna work on my PC?
    Thank you in advance guys.

    You probably should look at a more 'serious' audio interface rather than the Realtek
    Yes ASIO drivers are the way to go
    If you want zero latency you need to monitor via your audio hardware (hence the 'serious' audio interface suggestion)
    There are a heap of reasonable audio interfaces which will do the job for you that are pretty inexpensive and I'm sure that someone will jump in with a suggestion

  • Why can't I take a picture while recording video on iPhone 4S with iOS 6.0

    I have an iPhone 4S running iOS 6.0 and I've read the user guide, but cannot seem to get it to take a picture while recording video.

    1. Open the camera app.
    2. Move the slider from in the bottom right from photo to video.
    3. Begin recording your video.
    4. While your video is recording, tap the camera icon in the upper right to take a photo.
    5. You'll see the shutter close on your screen each time you snap a photo.
    6. Your photos will be saved to your camera roll.
    Edit:
    Just noticed you have a 4S...iPhone 5 only, sorry.

  • Phone call while recording video

    I realized yesterday that if I am recording a video and I receive an incoming call, my phone stops recording. Is there an option to hold all calls while recording video?

    Not that I ever heard of.
    Apple's stance is that it's primarily a phone, so those take priority over video recording.

  • I have mic problem while making video and while on loudspeaker its reduce the mic volume alot.

    i have mic problem while making video and while on loudspeaker its reduce the mic volume alot. plz help me out

    iPhone User Guide
    http://manuals.info.apple.com/en_US/iphone_user_guide.pdf

  • IOS6 unable to toggle flashlight on/off while recording videos

    Ever since upgrading to iOS 6 from 5 on my iPhone 4S I am unable to toggle flash/on or off while I am recording videos. In previous iOS versions I was able to record and toggle the flash to on or off as I see fit without having to stop the recording.
    is there something I am missing here?

    I do not hold out much hope for the popup solution.
    Popups are a problem because they have no background, and that is the only place you can put graphics that are not subject to the highlight limitations.
    But Blu-ray highlights are higher bit depth. Make sure you select rich color in menu properties. I do NOT know if this applies to popups, but I think it should.
    http://helpx.adobe.com/encore/using/button-subpictures-highlighting.html
    "Encore supports 8-bit color in subpictures for Blu-ray disc menus. You can export 256-color menu subpictures for Blu-ray. In addition, you can export full original colors for menu button highlights in Flash.
    To export subpictures in full original colors, select Export Highlights in Rich Color in the Menu Properties pane. Encore displays menu highlights with full colors in Menu Editor.
    However, Encore only displays two-bit DVD colors in the Preview panel. If you do not enable this feature, Encore exports menu highlights in two-bit colors for Blu-ray and Flash."
    What is our client really trying to do? If it is a promo piece, you would normally have the logo etc in all the time, or at particular points that are determined strategically. Perhaps he/she can't make up their mind? I would also consider a 3 video version: with, without, and strategic on/off.

  • IPod Touch/iPhone 4s in a BMW - Screen size problems while playing videos since iOS5

    Hi,
    I have an iPod Touch 4th generation 64GB that i use connected to my 2011 BMW M5 purchased with all multimedia and iPod/iPhone options available from factory.
    The car lets me play music and video playlists from the iPod and the videos can be seen on the BMW iDrive screen, when i was in iOS4 everything worked perfectly, but then i updated to iOS5 and one problem arised and then updated to iOS6 and now to iOS6.1 but the problem still persists, basically the problem consists that sometimes video size and aspect ratio of videos displayed in the car display are wrong, and some times the same videos are displayed correctly. It is just random, sometimes is OK and sometimes it is wrong, but when it starts to display wrongly, all videos following are displayed wrongly.
    After trying everything i discovered that while a video is playing with wrong size and aspect ratio, i can correct this behavior, sometimes manually unlocking the iPod and entering the "Music" app and exiting, and sometimes entering the iPod configuration and exiting, just entering and exiting, and sometimes doing both of them one after another. This is a temporary sollution because it is really disturbing to do this process while driving with the iPod inside the cradle in the armrest. I wish i could downgrade to iOS4.1 where i was before and everything worked perfectly, as there are no new features i care in iOS5 or 6.
    I tried restoring the device in iTunes... 5-6 times in total since iOS5 release, tried using an iPhone 4s with iOS6 and the same problem happens, so obviously it is a bug present in latter iOS that it is not initializing correctly the screen when requested by external accessories.
    you can see in this BMW forum other people with the same isue: http://www.bimmerfest.com/forums/showthread.php?t=602131
    I can provide photos or testing if needed
    Thanks and excuse my english.

    You say your turning it off does that mean you are holding in the sleep button and sliding the unit off or does it mean you are just locking the unit with the screen off?
    If you have the Wifi enabled and only have the IPT in standby mode then this is why it's depleting the battery so quickly. Charge the unit till it's full with the little plug showing and then eject it and turn off wifi and leave the unit in standby overnight and see if the battery depletes at all.
    I've noticed that Wifi really ***** the life out of the battery very quickly so give it a try and report back to us.

  • Getting problems while playing video files in flex player

    Hi friends,
                    Here i can able to play all video file formats like .mp4,3gp,.flv,.swf.But the problem ,i can't able to play mobile recording video files in this player even if that files are mp4 or 3gp or flv.In this scenario,can't understand what should do and where is my problem.So it would be grateful if anybody suggests and share me some idea where i am wrong.
    Regards,
    abhishek

    People use one-player-per-video because you can't reuse player objects. Player is a parent class to a whole bunch of subclasses, each subclass is capable of playing a specific kind of video. So when you create your Player object, you're actually creating some subclass type that's specific to that video type. So while it's technically possible to use a single Player subclass to play more than one video, unless all of your videos are of the same video encoding / audio encoding...you won't be able to reuse it.
    What you need to do is dispose of the last player before you create a new player (player.close), and do that over and over again. That way, you're never using more than 1 player's worth of memory...

Maybe you are looking for