BDP-N460 Blue Ray - Wanting to implement Airport Express (802.11n) as Wi-Fi

Question

Hi All,
My intention is to use my Airport Express (802.11n) as a Wi-Fi bridge for the BDP-N460 (Streaming Video). I am clearly missing a step. I have read many posts and followed what seemed like specific directions, to no avail. If anyone can help by shedding some light on this process, I would greatly appreciate it.
All the Best,
NgM

Answer 1

I may have to wait to do the tests in the same room as the Linksys. What would the tests include? Setting up the Express directly to the (cable) modem?
This was a suggestion to test signal strength. If you want to try to configure it now, here is how you would do so:
It is critically important that you know the exact type of security that the Linksys router is using. Otherwise, you will not be able to match up the settings and the Express will not connect to the Linksys wireless. It would be great if the Linksys was using no security, but I doubt that this is the case.
Hold in the reset button on the AirPort Express until you see the amber light begin to blink more quickly. Hold another second or two when you see this, then release the reset button.
Temporarily, connect an ethernet cable from your computer to the AirPort Express.
Open AirPort Utility and click Manual Setup
Click the Base Station tab (under the row of icons) to assign a name to your Express, a device password (write this down) and adjust Time Zone settings
Click the Wireless tab (under the row of icons)
Wireless Mode = Join a wireless network
Wireless Network Name = If the Express "sees" a strong enough signal from the Linksys, you will see the name of the Linksys wireless network. Click to select. If you do not see the name of the Linksys wireless network displayed as a choice, I'm afraid that the wireless signal is too weak and this will not work.
Place a check mark next to Allow ethernet clients. This activates the ethernet port
Wireless Security = Exact setting as the Linksys. This is always the most difficult part of trying to get an Express to join a wireless network. It won't pick the right setting by itself. You have to tell is exactly what to do.
Wireless Password = Password for the Linksys network if security is being used
Confirm Password
Click the Update button at the lower right of the window. Don't panic when the AirPort Express "disappears" from AirPort Utility, this is normal. As soon as you see the message that the settings have been stored to the Express, close AirPort Utility and disconnect the ethernet cable. The Express will restart and if your settings are correct, you will have a green light in 20-25 seconds.
If you don't get a green light, something is wrong with the configuration settings, probably the security setting. You'll have to start all over again with the reset of the Express and try again.
Now, test the connection by first plugging your computer in to the Express, (turn off wireless on the computer) and see if you can get an internet connection. If you can, it should be simply a matter of plug and play with the Sony, following the instructions in the manual. Almost all Audio/Video devices will connect to the internet automatically when they have an ethernet connection. No special configuration is normally required.
The success of your connection will depend on the quality of the wireless signal that is available to the AirPort Express.
Good luck, post back on your results.