Bonsoir, j'ai mon iPod qui déconne, il ne reconnaît pas les musiques de ma bibliothèques il m'affiche aucun contenu dans Musique alors que sur iTunes j'en ai 2127 qui sont dans l'iPod quand je le connecte au pc et quand il synchronise

Question

Bonsoir,
J'ai mon iPod qui déconne, il ne reconnaît pas les musiques de ma bibliothèque il m'affiche aucun contenu dans Musique alors que sur iTunes j'en ai 2127 qui sont dans l'iPod quand je le connecte au pc et qu'il se synchronise.
Quand je le branche sur le iTunes de mon copain ça fonctionne il arrive à mettre des musiques et à me mettre les musiques dans l'iPod
Que dois je faire j'aimerais de l'aide je vous en suplis je galère depuis plus de 1 semaines :'(

Answer 1

No, you cannot control Hyperterminal from
LabVIEW or any other program. You can however, use the VISA functions
in LabVIEW instead. You configure the port (baud rate, parity, etc)
with the VISA Configure Serial Port and you would send commands with
the VISA Write. The VISA Write would perform the same function as you
typing something into Hyperterminal. According to your image, the
device driver for the modem does make it appear as a serial port so you
should not need to install anything else. Open MAX (Measurement &
Automation Explorer) and see if the modem is listed. No, you cannot control Hyperterminal from
LabVIEW or any other program. You can however, use the VISA functions
in LabVIEW instead. You configure the port (baud rate, parity, etc)
with the VISA Configure Serial Port and you would send commands with
the VISA Write. The VISA Write would perform the same function as you
typing something into Hyperterminal. According to your image, the
device driver for the modem does make it appear as a serial port so you
should not need to install anything else. Open MAX (Measurement &
Automation Explorer) and see if the modem is listed.
Hello,
the mobile telephone is not detected in max as you can see on the link picture. I don't think the telephone appears as a standard serial port in hyperterminal : you have to provide a phone number in this case and not when using COM1 (see the link pictures). I think it is more complicated to establish communication with a USB connection than with a serial RS232 cable.
My goal is not to load hyperterminal with labview. Using hyperterminal is just a simple way to establish communication with a serial device (send some AT commands and check the serial device answer), then using VISA functions with Labview.
But it doesn't run in my case.
JF 
Attachments:
device_manager_nokia6680.jpg ‏147 KB
max_serial&parallel.jpg ‏84 KB
nokia_properties_hyperterminal.jpg ‏30 KB