Bouncing, recording MIDI and Audio at the same time

This is 2 questions. Thanks.
1. Each time I go to bounce a song, I have to enter the start and end again. I wish it would just remember form the last bounce. Is there hope?
2. Can I record an audio track and a MIDI track at the same time?
thanks,
fred in San Rafael, CA

Hi Fred,
I bring you my wisdom...Yes there is hope.
What you need to do is set the part you want to bounce into cycle mode. Dont worry, it will not cycle, it just knows now where to start and stop.
Audio and Midi can be recorded at the same time, as long as the midi is from an AU within the mac and not from an external source.
Good luck,
Joe
There is always hope

Similar Messages

Can't recording Midi and Audio at the same time

I'm in GREAT need of help. I can't record midi and audio at the same time. I'm using an M AUDIO project mix I/O. I know this is VERY basic stuff but I can't seem to get it to work.I can record multiple audio at once. ANd I can record midi but not at the same time. PLEASE help . Is there a setting somewhere I need to change ? Thanks
Tracy

Hi!
Enable all audio tracks (R) you wish to record. Then make sure you select the audio instrument you are using on the left of the arrange page (track list). If you here your input, hold shift, then highlight (gray) the mentioned audio tracks you wish to record on. When R is red, and the proper tracks are grey, you can record. Hope that made sense!

Recording MIDI and Audio at the same time....

I am having an issue recording a simple piano softsynth along with a guide vocal. Whenever I punch in, the audio punches fine but the MIDI/softsynth track hiccups, causing a lag in sound even though the MIDI info seems to record fine. Also, this does not happen when recording MIDI alone-everything punches in fine. Is there some setting I'm missing somewhere or is Logic not able to do this smoothly? Any help would be greatly appreciated. Thanks.
Message was edited by: dbboy

Hi Fred,
I bring you my wisdom...Yes there is hope.
What you need to do is set the part you want to bounce into cycle mode. Dont worry, it will not cycle, it just knows now where to start and stop.
Audio and Midi can be recorded at the same time, as long as the midi is from an AU within the mac and not from an external source.
Good luck,
Joe
There is always hope

How to record midi and audio at the same time?

Hello,
I have a Roland sh-201 synth and Logic 9. When I use patches from the sh-201, it will record it via audio. What if I wanted to record the audio but also have the midi information as well? How would I be able to accomplish this? My synth is connected via USB which carries both midi and audio. Sorry for my poor english, but any help would be greatly appreciated.
Thank You.

Hi
Logic will record both audio and MIDI at the same time, but you *MUST* have the Software Instrument/MIDI track selected in the Arrange Track List.
The audio track must be 'Record Ready':
HTH
CCT

Recording Video and Audio at the same time

Hi!
I just want to know whether there are video recording options within Sountrack? I'd like to record (hopefully funny) videos (via the in-built camera) and add layers of sound immediately afterwards. Is this possible?

The way I tried doing this yesterday was by starting to record from my isight in iMovie 08 and then recording the audio in garage band at the same time.
That's a good idea! And will be much more "natural" than a later lip-sync.
After I finished I exported the audio iMovie and played around with the timing for about 10 minutes until I could sync up the audio to the video of what I was playing.
I would export the GB project to an audio file and then import the resulting AIFF into iMovie to finish the movie.
In my experience, syncing shouldn't be so hard - in iMovie, you get a kind of reverb effect if you're 1 or 2 frames off and listen to both audio tracks. This reverb vanishes once you're right on time.
For easier syncing, it could be helpful to do what they do in movies with a clapboard: Have a visual/optical clue with and impulse character, like clapping your hands, and use that to align video and sound. Fine tune by aligning the two audio tracks.

How do i start video and audio at the same time in ios

How do i start video and audio at the same time in ios?
I have tried a lot of different ways but i cant figure it out?
I can get the sound and animation (timeline) to start playing.
There is no problem to start the video and the animation at the same time.
But i cant get both the video and the audio to start playing when i press a button.
It works great in OSX and on windows?
Here is an example:
// insert code for mouse click here
// Play an audio track
sym.$("_1")[0].play();
// Play a video track
sym.$("host")[0].play();
// Play the timeline at a label or specific time. For example:
// sym.play(500); or sym.play("myLabel");
sym.play("marker1");

If the game has sound in it (and possibly even if it doesn't) it may be overriding the Music app and causing it to stop playing - in which case there is nothing that you can do about it.

If I plug a guitar into iPhone GarageBand using an interface, can I still use the built in microphone to record vocals and guitar at the same time?

If I plug a guitar into iPhone GarageBand using an interface, can I still use the built in microphone to record vocals and guitar at the same time?

Hi John,
I think the only way is to get an iMic...
http://www.bhphotovideo.com/bnh/controller/home?O=&sku=797644&is=REG&Q=&A=detail s

Edit video and audio at the same time

Is it possible when I remove some of the audio to also remove the same amount of that time from the video?

Lilybiri,
We did record both the audio and video at the same time in Captivate 8.
The question is: how do we edit the audio and video at the same time?
If I want to cut out 5 seconds of audio can I or will the software cut out that same portion of the video and if so how do we do it?
Do we need to create a Demo or Software Simulation to be able to take advantage of this tool for cutting both together.
Your assistance is very much appreciated.
<http://www.eaglemetal.com/>
Mark Wyatt Customer Support specialist
Eagle Metal Products | 12300 Ford Road, Suite 110 | Dallas, TX 75234
[email protected]<mailto:[email protected]>
Toll free: 800.521.3245
Direct Line: 972.350.9898

Recording vocals and guitar at the same time, using the Alesis IO dock!

Hi there!
I have an Ipad 2 with the newest OS installed etc. And I rea the other posts in here.
I bought an IO dock from Alesis the other day and was full of exspectations, but I got a bit disappointed -> Garageband! When I bought the Ipad dock I exspected that I would be able to record (or just play and hear the inputsound from two devices) at the same time in my headphones! But I wasn't... Now I'm wondering if this is going to be fixed in an update or not? I think it would be a shame if this issue isnt adressed, due to the huge abilities the Ipad/garageband/Ipad docks withhold.
So anyone know anything? I went to my musicstore and spent about an hour or so with the tech dude there trying dfferent setups, but unfortunatly without luck! Just to clarify that I didt just plugged in my guitar and got mad that it wasnt apple intuative!
Hope someone can help :)

I am wondering if I can record audio and midi at the
same time in Logic 7 Express. I am running my guitar
thrugh a Roland GR 33, and a line out and using the
GR 33 to trigger sounds in the Logic's synth section
but cant seem to record all three tracks at once. If
any one knows how let me know. Oh and I am running
the GR Synth and Guitar into the Prosonus Fire Fox
and have the GR 33 out midi to the Fire Box as well.
So I guss the question is how do I sent up two audo
tracks and one midi track to record in real time.
Thanks Victor
Try arming the audio tracks, select one of the tracks, then while holding down the shift key, select the midi track you want to record, arming the "r" on the midi track. Press "record".....
HL

Pair iphone 4S and audio at the same time in 2011 Corolla.

My car bluetooth will only pair my phone OR my music not both. When I try to pair both I get a message on my phone: Make sure 'car multi-media' is turned on. It looks like either the car or the phone's bluetooth cannot find the other. It just keeps searching. Is this message for my phone? Toyota says I need to have the navigation system in my car to be able to pair both at the same time. I got the feeling they just said this because they couldn't answer my questions. The dealer thinks I should be able to pair both simultaneously.

If what Toyota told you, then their system is IMO, junk. Works just fine in my Kia without a nav system. Of course, there are many reports of compatibility issues with Toyota and Lexus audio systems and a number of phones. You may just need an update.

How do i delete sections of video and audio at the same time

hello, i made a video with sound and overlapping voiceover i want to know how do i delete a section of the video and the voice over without having to resynch everything again?

In Final Cut Pro X, this is easy. You drag to select all these clips. Then use the Blade Tool.
However, in iMovie, it is not as straightforward. You can edit the camcorder clip and its audio, but any music tracks, voiceover tracks, etc. will not be edited with it.
A workaround is to use the SHARE menu to SHARE/EXPORT TO QUICKTIME using Apple Intermediate Codec to retain as much quality as possible. Then import this new movie into an Event. New all the audio is married to the video and you can edit everything together.

Tap to play slideshow and audio at the same time?

I have an image sequence of people dancing that I've turned into a 12 state MSO. You currently tap to play the sequence. I'd also like a 15 sec. clip of some music to accompany it. Is there any way to get the audio to start playing when the user taps to start the slideshow?
Thanks.

Thanks Bob, yes...that's what I'm running into as well. I'll continue to experiment as well. For reference I'm attaching the first and last screens that have user actions tied to them. The slideshow plays fine, but again I can't get the audio to start when the user taps that first screen.

Can't Record Midi and audio Simultaneously

I just noticed that I cant record audio and midi simultaneously. I wanted to record a audio vocal track as I was recording a midi piano track but it wouldn't record. If I selected the audio track, the midi track wasn't heard. If I selected the midi track, I could hear the piano, but the audio wouldn't record. Weird. I had to record the midi track, and then go back and arm 2 audio tracks for recording. One for the vocal and the other to convert the midi track into a audio track. I don't understand why I can't record midi and audio at the same time. I am using a MOTU 896HD for my audio, so I can record up to 8 audio tracks at a time.
Does anyone have any clues as to how to set this up to record midi and audio at the same time?

Setup your audio and midi tracks and then hold the shift key and hit the record button on each of them. Both audio and midi will record.

Recording and playing Audio at the same time

Hi,
Having problem with a MMAPI imp.
The simplest way of doing it is to start one thread playing a audio file of any kind.. As it is playing start a other thread that start a audio recording.
As soon as the audio recording is allowed to record (Security promt) the audio playback stops. And the playerListstner sends a END_OF_MEDIA event.
So my question is: Is there a way of doing playback and recording at the same time or is this a limit on the phone or the MMAPI?
This has been tested on Nokia N90 and SE W550i with same reults
Cheers
Kenth

i also desperately need to record and play audio at the same time.. i have a term project, i am develeoping a karaoke player in j2me and it is supposed to capture the voice at the same time background song is played.. and it is also supposed to grade the singer according to the pitch of voice.. please help me about recording and playing audio at the same time...

FCP Audio and firewire at the same time?

Hi, I was pondering an idea that made me wonder this. I hope it is not a stupid one but I am sure I get an "E" for effort or a "god bless his little heart".
I will be moving my mac to a studio to work on a instructional DVD. I will be capturing from one main camera real time via firewire, I have the option of going out of the console via optical for the instrument tracks and vocal. ( whether I can only have one active audio inputed track or two doesn't matter but would like two).
This audio will be pro quality and I just want to use FCP.
I am only interested in the video without the camera audio.
I want to capture the camera video(firewire) and studio(optical) audio at the same time.
If not it's no big deal I can route audio to the 3.5mm audio mike input on the camera.
I am running FCP studio and have no budget and a chance to play. I am on a barter project. I was just hoping for a time saver and down the road I would be happy to know my limitations as I may move into the studio and "sync" up.
I have another camera that I will add later for my Picture in picture effects.

Hey X thanks for your reply
Well I talked to my friend at the studio. and we are still saving the audio on digital hard drive in case this doesn't work. ( Which I know is the right way). I only asked the question because I apparently am lazy and want to spend as little time trying to sinc up later. My solution was to be fluid. In the end the project would be available for download tutorials/lessons from his web page, which will be a whole other delivery question as I am working through the third party whose project this belongs. Given my information I am trying to cover a lot of possibles to create something better than he is asking ( A Pro Job )
I was hoping to cross from "hobbiest" to "entry pro" here. Most I get to play with are relatives videos and stills. I have two completed two paying jobs in which I have purchased the mac and Final Cut Studio.
This is more of a controlled environment and wanted to utilize as many choices as possible.
The camera I am using (Panasonic PV-DV951-K) doesn't record to tape properly or doesn't replay what was recorded on tape. My solution was to go directly to FCP via firewire as a live realtime capture.
I opted for this as having no choice and in the end. Given the amount of lessons that would have to be captured and the equipment I have conjured up I think it is my best solution.
Again I thank you X and I meant no disrespect as to who is clueless. I am the one asking the questions. I don't always ask questions until I have searched the forum for an answer and appreciate those of you who take the time to answer "patiently".
Also I am an electronic technician and in a pinch devour troubleshooting to the point of magiverism.
When this is all over and I am enjoying a pint and reaping what few dollars this creates, I'd like to buy you all a beer. Then I'll plan the next hairbrain project.

Bouncing, recording MIDI and Audio at the same time

Similar Messages

Maybe you are looking for