Bright white screen when video is paused.

Hello All,
I've looked everywhere for a solution to this problem and there has been no previous discussion. Basically, whenever the Video is paused, instead of the paused frame being shown, there is a bright white screen. It is worth nothing that this issue happens when I use the Darwin Streaming server. If I serve the video using IIS, the issue is not present.
This issue using the  Quicktime plugin is present in Chrome, Firefox, Safari, and IE.
If someone could push me in the right direction, it would be greatly appreciated.
Thanks.

Hi Brendon,
What has she done to set up AIM on her end ?
Has she enabled it though her XP firewall ?
Has she enable the ports AIM needs in her modem ?
8:38 PM Tuesday; December 19, 2006

Similar Messages

  • I have a bright white screen when turning on my ipod nano 7th gen.  Have tried resetting etc etc. Any further ideas?

    I have a bright white screen when turning on my nano 7th gen. Have tried resetting and restoring settings - no change. Any ideas please?

    Hello pipworms,
    I would be concerned too if my iPod nano's was just showing a white screen.  I recommend following the steps below:
    Display shows a white screen
    Try putting the iPod into disk mode:
    Reset the device (Reset the device by pressing the Sleep and Home buttons simultaneously until the display shows the Apple logo. This should take about eight seconds).
    When the Apple logo appears, press and hold the Volume Down and Volume Up buttons simultaneously until the device enters Disk Mode.
    While the device is in disk mode, sync it to iTunes and try to restore.
    I got this information from the following article for the 6th generation iPod nano.  The steps are the same, except I updated the reset steps with the reset for the 7th generation iPod nano:
    iPod nano (6th generation): Hardware troubleshooting
    http://support.apple.com/kb/ts3474
    How to reset iPod
    http://support.apple.com/kb/ht1320
    Putting iPod into Disk Mode
    http://support.apple.com/kb/HT1363
    Thank you for using Apple Support Communities.
    Best,
    Sheila M.

  • White Screen when FCP5 is paused

    I have recently installed Final Cut Pro 5 onto my MacBook Pro for use with both HD footage from a Panasonic HVX200 and standard DV footage. When editing, I am not able to see frame by frame in the viewer or canvas. Instead I get a white screen everytime the video is paused, making edits very difficult and frusturating. Therefore I can see the video and hear the audio when it is playing, but the screen turns white when paused. Does anyone know the reason for this? Please help! Thanks

    I'm having the same problem with the white screen on my 32 gb Touch. I connect it to my Mac Book Pro at night look at it in the morning and the screen is completely white. I have to hold down the center button and the top button to get it to restart and when it does the battery is in the red. I've exchanged it twice since September. I sent the last one to Apple and just got a cheery email from them telling me that they can't find anything wrong with it and they're sending it back with notes on troubleshooting.
    I absolutely hate it when they pretend that this is the first time they've heard of such a thing. But I have AppleCare and I'm just going to keep taking it back until I get satisfaction.

  • White Screen when Video Plays

    I am using Premiere Elements 9 software.  When i add clips to the timeline and hit play, the video does not play in playback screen, instead i just get a white screen.  Once i hit the puase button, the picture of the frame the playerhead is on goes back onto the screeen, but as soon as i hit the play button, the screen turns white again.  I have updated my graphics card drivers and the prject settings are correct.  What is causeing the issue?
    This is what i get when i hit the play button:
    tim

    Thank you for that info. You have got a pretty recent (did not check, but that might be the latest) video driver. I sort of expected to see a date about 6 - 8 mos. ago. If there IS a newer driver, I would definitely try that. Also, as over the years, both nVidia and ATI/AMD have issued drivers, that were just bad with Adobe programs, I keep older (known good) drivers on my HDD, just in case I have to roll-back.
    Do you have a Dell, HP, Lenovo or Toshiba computer? The reason that I ask is that those companies very often re-wrap the nVidia (and ATI/AMD) drivers, to work with their tweaked hardware.
    With the latest video driver, and that Canon footage, if you have the proper Project Preset, things should edit fine. The smoothness of editing/playback will be heavily dependent on your CPU's speed, but should not affect the display.
    Good luck,
    Hunt

  • White Screen when "video" chatting with PC

    My friend is running AIM 5.9 on Windows XP and when I try to video chat with her, all she sees is a white screen, but still can hear me. I have rebooted my computer, and so has she. We used to not be able to connect at all, but she rebooted and now she can hear me.
    What should I do?

    Hi Brendon,
    What has she done to set up AIM on her end ?
    Has she enabled it though her XP firewall ?
    Has she enable the ports AIM needs in her modem ?
    8:38 PM Tuesday; December 19, 2006

  • White Screen When You Click Pause in FCP

    Hello, this is probably a real simple setting that i changed... but in my viewer when editing a video now... When the video is paused (spacebar), the viewer is white (I cannot see the screenshot of where i stopped)... But when i click play, i can see the video as normal...
    Any idea on what setting i changed?

    Give yourself a green star and mark the thread as answered.
    Good on ya for solving this yourself!

  • My 17" laptop has a bright white screen and nothing works

    My 17 inch MacBook Pro (6 years old) has a bright white screen when I turn it on and nothing works. Is there a fix?

    Have you tried to boot from installation disc one that came with your computer?
    Clinton

  • White Screen When Streaming .MOV videos

    Hey everyone -
    Any thoughts as to why I'm seeing a white screen (no video) and audio when streaming a .mov file from a website?
    The computer in question has Quicktime 7.7.2, plugin is enabled and is running Windows XP SP3.
    I've tried removing and reinstalling Quicktime, upgrading to 7.7.3 and downgrading to 7.7.1 - no change.
    The issue persists using Firefox, IE 8 and Chrome.
    I can play the video fine on my MacBook Pro (running Lion) and on another Windows workstation - different PC model but everything else is the same.
    Any troubleshooting suggestions would be fabulous.
    ~Lyssa

    Went through and disabled any plugins that could be grabbing it & no joy...I can get it working on another PC that is absolutely identical (same graphics card, software installs & network configuration).  Most puzzling!
    I think we'll just download the videos from this point forward and try the plugin periodically; eventually it'll start working again.
    Thanks for your help!
    ~Lyssa

  • Bright White Screen.

    My Ipod Nano was working fine. I turned it off, and went to bed. The next morning I got up and turned it on. All that showed was a bright white screen. I reset it a couple of times, I pluged it up to the USB port, and I let it die completely. None of those things helped to fix my Ipod. It was not dropped and it did not get wet. All I did was set it down. When plugged up to the computer the computer will recognize it, but then it won't, yet after that it accepts it again. Does anybody have any words of wisdom? Does anybody think Apple will fix it?
    Message was edited by: brillant_egomaniac

    Try this:
    When your iPod comes up with the white screen, hold the center and menu buttons simultaneously until the screen goes black, then immediately hold the center and left (rewind) buttons. A menu should come up that shows you a few options. If this menu comes up, it might just mean that your internal storage is dead. If nothing comes up, then you might have a total hardware failure. If it is just the storage, the repair should cost less than buying a new nano or having an Apple Genius go in and repair multiple components. You might be able to attempt the repair yourself, but I really do not recommend that.
    TheMacKid

  • IPhone frozen/no brightness/white screen

    So yesterday it start with my iphone telling me that I needed to connect to iTunes and restore because I couldn't make or receive calls. I reset it, and seemed OK. I later tried to play doodle jump, which crashed upon opening, so I reinstalled it to no avail. I discovered this morning that wasn't just doodle jump, but all 3rd party apps. It also went through stages of not turning on, telling me to restore it, and still having an image on the screen but there was absolutely no brightness to it, and instead of the screen going black when I press the sleep button on top, I would get a bright white screen. Giving up on resets, I came home from school and restored it, and it worked perfectly. Now it's 5.5 hours later and it just froze, unfroze, and had no brightness. I reset it, and now it wont turn on.
    Any suggestions? Thanks

    HPGuelpher, welcome to the forum.
    When requesting help, you should always include the make/model of the computer and/or monitor. This information is necessary for us to review the specifications of them.
    Depending on the age of the computer, you could have a failed power supply unit (PSU).  Here is a guide to help you troubleshoot the problem.
    Please click "Accept as Solution" if your problem is solved.
    Signature:
    HP TouchPad - 1.2 GHz; 1 GB memory; 32 GB storage; WebOS/CyanogenMod 11(Kit Kat)
    HP 10 Plus; Android-Kit Kat; 1.0 GHz Allwinner A31 ARM Cortex A7 Quad Core Processor ; 2GB RAM Memory Long: 2 GB DDR3L SDRAM (1600MHz); 16GB disable eMMC 16GB v4.51
    HP Omen; i7-4710QH; 8 GB memory; 256 GB San Disk SSD; Win 8.1
    HP Photosmart 7520 AIO
    ++++++++++++++++++
    **Click the Thumbs Up+ to say 'Thanks' and the 'Accept as Solution' if I have solved your problem.**
    Intelligence is God given; Wisdom is the sum of our mistakes!
    I am not an HP employee.

  • I downloaded 11.1 but now can't access the store, can only view my library. I've reinstalled but still get a blank, white screen when I try to go to the itunes store. How can I get to the store for purchases?

    I downloaded 11.1 but now can't access the store, can only view my library. I've reinstalled but still get a blank, white screen when I try to go to the itunes store. How can I get to the store for purchases?

    In iTunes prefs>Store - is the Store check box unchecked?
    Did you repair pemissions with Disk Utility?
    MJ

  • What is missing when I get a blank white screen when I try to Access some web sites?

    On some web sites, I get a blank white screen when I try to access them.

    You can try these steps in case of issues with web pages:
    You can reload web page(s) and bypass the cache to refresh possibly outdated or corrupted files.
    *Hold down the Shift key and left-click the Reload button
    *Press "Ctrl + F5" or press "Ctrl + Shift + R" (Windows,Linux)
    *Press "Command + Shift + R" (Mac)
    Clear the cache and remove cookies only from websites that cause problems.
    "Clear the Cache":
    *Firefox/Tools > Options > Advanced > Network > Cached Web Content: "Clear Now"
    "Remove Cookies" from sites causing problems:
    *Firefox/Tools > Options > Privacy > "Use custom settings for history" > Cookies: "Show Cookies"
    Start Firefox in <u>[[Safe Mode|Safe Mode]]</u> to check if one of the extensions (Firefox/Tools > Add-ons > Extensions) or if hardware acceleration is causing the problem.
    *Switch to the DEFAULT theme: Firefox/Tools > Add-ons > Appearance
    *Do NOT click the Reset button on the Safe Mode start window
    *https://support.mozilla.org/kb/Safe+Mode
    *https://support.mozilla.org/kb/Troubleshooting+extensions+and+themes

  • I have a new ipad and everything works but can't connect to the app store. Itunes works and the wifi seems to be working but i get a blank white screen when i open the appstore.Nothing will load unter the features or charts tab. Any Suggestions?

    I have a new ipad and everything works but can't connect to the app store. Itunes works and the wifi seems to be working but i get a blank white screen when i open the appstore. Nothing will load unter the features or charts tab so i cant download any apps. Purchased and updates tab loads fine. Any suggestions?

    You would get better response from the iTunes community forum.
    Have a nice day!

  • Hello all,     I have a 6G iPod Nano that I currently use as my primary watch. A week or so ago I started to experience a blank white screen when I press the "sleep/wake" button instead of the watch face (I have it set to wake from sleep to display the cl

    Hello all,
    I have a 14.88G iPod Nano that I currently use as my primary watch. A week or so ago I started to experience a blank white screen when I press the "sleep/wake" button instead of the watch face (I have it set to wake from sleep to display the clock). When I hard reset it, it will come back fine and the screen will respond and work as normal, as soon as I manually put it to sleep by pressing the "sleep/wake" button and then try to wake it the same thing happens and I have a blank white screen that doesn't respond to touch gestures or anything.
    What I have tried so far to no avail:
    Numerous hard restarts (holding the "sleep/wake" button with the volume - button).
    Tried this: iPod nano (6th generation): Hardware troubleshooting
    Changed the watch face to display.
    Recharged the device overnight (without full discharge).
    Since none of this works I'm out of ideas. Eventhough I have a 6G Nano it should no longer be under warranty since I was sent it as a replacement for a different (older) product.
    Any ideas? Is this a known problem? Thanks in advance for any insight any of you could provide. Also, what time is it??
    Regards,

    Hey,
    I have the exact same problem as you have described. I also used my ipod as a watch but starting from today, whenever I unlock it the screen turns white until a reset is done. Even a factory reset through itunes didn't fix it.
    Have you found any solution?
    Bah, this is annoying.
    //Gubbar

  • My MacBook Pro shows the logo in a white screen when I ask for a Software Update under the apple. Actually it stays blank on Featured, Top Charts, Categories and Purchases as well. What up? Thanks.

    My MacBook Pro shows the logo in a white screen when I ask for a Software Update under the apple. Actually it stays blank on Featured, Top Charts, Categories and Purchases as well. What up? Thanks.

    I am having exactly the same problem right now. After some research, it looked like my HD was toast. I replaced it today, that part was easy, but now I cannot seem to use my original Install Disk to format the new HD. I get a grey restart screen, or if I get to the Language Selection screen, my cursor is frozen in left corner and I can't use it.
    Very frustrating, hope someone else has some ideas!
    PS My MacBook was about same age, and "expired" in exactly the same way as yours.

Maybe you are looking for