Can i extend my ap express through a power line extender

I have an Apple Extreme with an ethernet cable to a Powerline adapter. The other end (in the far bedroom) the powerline adapter is ethernet wired to an Express. Will this extend my wireless network. The reason is this, I was using Facetime in the living room as I walked to the bedroom I dropped the connection only to pick up a strong signal in there. Make sense?

No, unfortunately you are going to off on the wrong track and it will be hard to get back on the right one.
You need step by step. We can provide that but we need a few details about your devices. If you have recent AirPort routers and you are using Mountain Lion or Mavericks, the setup will be very simple.
What model number of AirPort Extreme?  If you are not sure, is this a new "tower" shaped AirPort Extreme, a flat "square" Extreme, or a round "dome" shaped Extreme?
What model number of AirPort Express? If an older model, look on the side of the device for the model number. Hard to see in the faint print. It starts with an "A" followed by four numbers, as in A1264 or A1392 on the bottom of the newer version of the Express.
What operating system are you using on your Mac?  If you are no sure, click the Apple icon in the upper left corner of the screen, then click About This Mac and post back with the OS X Version number that you see there.

Similar Messages

  • XP machine can only connect to Airport Express through Configure Other...

    I have an Airport Express running the latest firmware (6.3). It works fine with my Mac, however I can't get it to work correctly with my XP machine. It's setup to just do music and not give out IPs. I've tried connecting it to my router via wired and wireless and doesn't work either way. I can connect to it if I go to Configure Other... and type in the IP but I can't see it in the AirPort Utility scan and I can't see it in iTunes.
    A possibly related issue is that I can't see my Mac's shared iTunes library on the XP machine but I CAN see the XP machine's library on the Mac.
    Everything is on the same 192.168.0.x subnet.
    Message was edited by: mason55

    similar problem. My XP can connect to AX, but I cannot use Internet (sometimes it works, sometimes it does not), meanwhile my mac is fine with the internet. P.S. My xp is sumsung NC10.
    Message was edited by: Boshu

  • Can i extend my ap express through non apple router

    can i extend my ap express through non apple router

    Yes, if you connect the AirPort Express to your router using a permanent, wired Ethernet connection.
    No, if you want to connect the AirPort Express to your router wirelessly.

  • How can I extend an Airport Express in WLAN mode with an additional Airport Express box

    I'm trying to extend the existing WLAN with an additonal Airport Express box. I read through a bunch of comment throughout the communities here but didn't find what I'm looking for.
    My actual Installation consists:
    A Time Capsule attached to the Internet router which set up my 1. WLAN range
    This WLAN has been extended with an Airport Express BOX creating my extended 2. WLAN range
    Now I intend the extend the 2nd WLAN of the Airport Express BOX with an additional Airport Express (creating a 3rd WLAN range) but don't find a way on how to set it up correctly.
    The physical situation of the location dosen't allow me to add / replace cabeling (Ethernet or similar). If there is any chance I'd like to avoid power-line connections. And, I'm aware of the impacted bandwith on WLAN / WLAN extensions, but can deal with this.
    Regards and thanks for any advice

    Two requirements that must be met to do what you want.......
    1) An AirPort Express 802.11n must be used. Check the Model No on the label on the side of the Express. It needs to be A1264. Any other model number will not do what you want.
    2) The Express must be configured to "Join a wireless network" and the option to enable Ethernet Clients must be checked. 
    Open AirPort Utility and click Manual Setup
    Click the Wireless tab below the row of icons
    The box to "Allow Ethernet Clients" must be checked
    Please check to verify that your AirPort Express meets both requirements

  • Can I extend a network with an AirPort Extreme Base Station Rather than with an Express?

    Topic title pretty well sums up the question.
    I have a TimeCapsule Base Station with two Expresses for extending the network through the house.
    We're doing a 3 room addition, and there is not a convenient place to put an Express in a wall outlet in the middle room of the addition, but there's a perfect place to put an Extreme on top of a piece of furniture.
    So, can the Extreme act as an "extender" only, in lieu of using an Express?

    pcbjr wrote:
    Topic title pretty well sums up the question.
    I have a TimeCapsule Base Station with two Expresses for extending the network through the house.
    We're doing a 3 room addition, and there is not a convenient place to put an Express in a wall outlet in the middle room of the addition, but there's a perfect place to put an Extreme on top of a piece of furniture.
    So, can the Extreme act as an "extender" only, in lieu of using an Express?
    Hiya.
    You can absolutely extend a network with an Extreme. I've got a 5th gen. Extreme extending a network created with a 3rd gen. Time Capsule. On the Extreme, you'll have the option to allow (or not) WiFi clients. I recommend having all units updated to the current firmware (7.6.1 as of this writing). Note that extending doesn't work in daisy-chain fashion, meaning that your Expresses or Extremes will each connect to and extend from the TC. As such, you'll want the TC to be in as central a location as possible to offer the best coverage.

  • Can I use an airport express as a range extender to a NON apple router using an internet cable (so not wireless)

    can I use an airport express as a range extender to a NON apple router using an internet cable (so not wireless)

    Yes, if the AirPort Express is set up to create a wireless network that uses the exact same wireless network name as the other router and the same wireless network password as the other router.

  • My airport express is still providing a link to my wifi network but I can't find my airport express on my macbook and i can't link to my bose speakers through it ... any bright ideas?

    My airport express is still providing a link to my wifi network but I can't find my airport express on my macbook and i can't link to my bose speakers through it ... any bright ideas?

    I'm not sure what you mean. You can't find the express to set it up.. or you can't find the network created by the express?

  • I used Airport Base station and I was able to extend my network using airport express and connect my printers.  Now I am using Extreme and I can't extend the network (Express) or the printers nothing shows up.  I am using utility 6.3 and Mt Lion  What is

    I had an Aiport Base Station and extended using Airport Express, where I also connected my printers (network). Now using Airport Extreme off Mt Lion 10.8.4 and Utility 6.3.
    I can't extend the network (express) or connect my printers (USB) nor will it find my one wifi printer.
    What's up?

    For now, leave the AirPort Express powered off.
    Power off the entire network....all devices.....in any order that you want
    Wait a few minutes
    Power up the modem first, and let it run 2-3 minutes by itself
    Power up the AirPort Extreme next, and let it run a full minute
    Keep powering up devices one at a time about a minute apart until everything is powered up (leave the Express off for now)
    Open AirPort Utility and check to see if the AirPort Extreme is visible.
    If it's not, click the AirPort Utility menu at the upper left of the screen, then click About AirPort Utility. Post back with the version number of AirPort Utility that you see there....which should be AirPort Utility 5.6.1.
    Post back on your progress.

  • Can I use an Airport Express to extend a network using a Bwrg500 router?

    Can I use my Airport Express to extend my wireless network while using a Bountiful BWRG500 wireless router? The Bountiful wireless router has the WDS abilities.
    http://www.bountifulwifi.com/Products/BountifulRouter500G/Overview.aspx
    Thank you for looking.

    It is in fact possible to extend your network using WDS. I say this under the assumption that your statement regarding the WDS capabilities of the Bwrg router is correct. However, keep in mind that you cannot use a WPA or WPA2 password with a WDS extended network. You must either use no encryption or use WEP. Unfortunately some routers require WEP passwords that use either 10 or 26 digits ONLY while the express uses a 13 digit password.
    This can be a troubling problem considering that most people need a wifi password to ensure safe and secure browsing.

  • Can I use an airport express to extend a Cisco E4200 802.11n or 802.11g wireless network?

    Can I use an Airport Express to extend a Cisco E4200 802.11n or 802.11g wireless network?  I'd like to improve access in a dead spot with an airport express. I know I can connect this wayt for airplay, but how about extending the signal?
    Thx! ACB

    Apple's "extend a wireless network" function appears to be a proprietary feature that works only with other Apple AirPort routers. As far as we know, this feature is not compatible with devices from other manufacturers.
    It would be extremely unlikely that the Express could do what you want, but some things are never known until  you try.

  • Can Apple TV replace Airport Express as wireless network extender?

    I currently have a 1TB Time Capsule plus an Airport Express 802.11n 5Ghz setup as a wireless network extender to the TC. I also use AirTunes on the AE tied into our home theater system. I'm contemplating purchasing an Apple TV and cannot figure out (after browsing forums and Apple.com) if the Apple TV can fully replace the Airport Express for both AirTunes AND as my wireless network extender? In other words, if I buy the Apple TV to I need to have it serve side-by-side with the AE, or can I move the AE to another location to even further extend the network range? Many thanks for any help on this topic!

    Yes, that's correct. However, the OP wasn't asking if they could do that. They wanted to use the ATV to extend the network to other devices, and it won't do that. It will connect to the network even if the network runs off a single computer as a opposed to a router. But devices not connected to the computer or router can't connect to the ATV.

  • How can I tell if the quicktime movie I export from Final Cut Express through Quicktime to IDVD is anamorphic

    How can I tell if the quicktime movie I export from Final Cut Express through Quicktime to IDVD is anamorphic

    Find the Seuence icon in the Browser that corresponds to the Timeline.
    Right click the Sequence icon in the Browser.
    Select Item Properties.
    All info is revealed.
    Al

  • I can see my Canon MP600 usb connected to Airport Express through Bonjour on my Windows XP. But, when installed by Bonjour, the printor time-out and can't print anything. Any idea what to do?

    I can see my Canon MP600 usb connected to Airport Express through Bonjour on my Windows XP. But, when installed by Bonjour, the printor time-out and can't print anything. Any idea what to do?

    Thanks for the quick reply.
    So am I correct in saying trying to utilise the Airport Express to access the printer over the network was a wasted effort due to the latest iOS? I had read up on the express before purchase and believed that was one of it's main purposes.
    Thanks again for the help.

  • Can i use 2 airport express to extend airport extreme

    My current set up: Verizon FiOs - using Airport Extreme as the wireless router (Bridege mode) with one Airport Express as range extender - works flawless.
    Recently purchase the Airport Express Base - to use as another wireless range extender - but getting error when trying to set up via Airport utility app. Can i have 2 Airport express as wireless range extender?

    Yes, you can use multiple 802.11n AirPort Express base stations to extend the 802.11n AirPort Extreme. Think of the extended network as sort of a wheel with the extended base station at the hub and the extending base stations on each of the spokes of that wheel. Each extending base station would be configured the same way.
    Please check out the following Apple Support article for setting up an extended network.

  • Can I use an airport express to add airplay to (and extend the range of) a network with a netgear N750 Router?

    I have a Netgear N750 router. Can I buy an airport express and configure it to extend the range of my current network and allow me to use AirPlay from anywhere on that SSID?

    You can configure the AirPort Express to "join" the wireless network that is being provided by the Netgear router for use with AirTunes.
    But, the Express will not be able to "extend" the range of your wireless network.
    The "extend a wireless network" feature only works if you have an Apple router as your main device. This feature is not compatible with devices from other manufacturers.

Maybe you are looking for

  • Itunes just not installing

    ok, i downloaded itunes a long time ago and its been working fine with my 30GB ipod video. somehow i think something involved with itunes got deleted and now it wont open along with quicktime and my ipod updaters. here's the message: iTunes has encou

  • Invoice - Witholding Tax

    Hi there, i have a problem while I'm adding an AR Invoice Document contented witholding Tax, using DI API 2005 SP01. i have an error message "Total Taxable amount of all rows exceeds the based amount" Seems like the base amount is never filled, becau

  • Error Connecting to SLD, while CC integration with ECC 6.0

    Dear All, I am using the CC v and from ECC IDES. I cannot connect to the SLD. It is giving an Error. When I try to register the Server Programs in Vis Admin and click the SET button I am getting an error "Error Adding Bundles". In the ABAP part I am

  • Bridge / Lightroom and Premier Elements

    Am I missing something obvious? I am new to using Premier Elements, but use Lightroom, Phototoshop. In Design every day. So I use LR to manage my photographic files and Bridge for everything else. I capture video on my camera in AVCHD, so Lightroom c

  • Employee vendor creation job cancelled

    When we were trying to create the vendor in backgroud, using the standard program RFBIKR00, job failed. Here is the error message, no idea what happend. Job started Step 001 started (program RFBIKR00, variant &0000000023327, user ID ******* Session