Can I get 1st gen to stay awake 30 minutes while timing?

I'm giving a 30-minute talk, and want to know where I am in the half hour. Can set the 1st gen iPod Touch as  timer on 30 minutes, and not have it go to sleep during that time?

You set the Clock to alarm in 30  minutes. If you do not want the iPod to sleep, then go to Settings>General>Lock-Screen and set a sleep delay interval to 30 minuter or longer.

Similar Messages

  • How do I get the watch to stay awake longer?

    I noticed that when I am using the watch, it only stays awake for a matter of seconds before going dark.  For example, I was using the Stop Watch app and while trying to time something, the watch went dark after a few seconds.  This caused me to have to lower and raise my wrist again to access the app again.
    How do I get the watch to stay awake longer when using some of the apps?
    Thanks!

    I Think it varies with what app you're using, I just went on the message app & left it & it lasted for a good 10/15 secs before going dark plus like what DonCote said you can always just tap the screen to get the screen back up instead of flicking your wrist. Not sure whether apple will change this as they'll want to do anything to help battery performance...

  • How can i get my items to stay in place and not cross over each other when readjusting the browser s

    How can i get my items to stay in place and not cross over each other when readjusting the browser size.
    Basically on my site when i go from a small screen to a big screen everything doesn't adjust to the screen size. I don't know what im missing
    Here's the link to the page all the pages & they all do it
    http://theatricalworkslive.com/
    Thanks in advance

    Please read this whole message before doing anything.
    This procedure is a diagnostic test. It’s unlikely to solve your problem. Don’t be disappointed when you find that nothing has changed after you complete it.
    The purpose of the test is to determine whether the problem is caused by third-party software that loads automatically at startup or login, or by a peripheral device. 
    Disconnect all wired peripherals except those needed for the test, and remove all aftermarket expansion cards. Boot in safe mode and log in to the account with the problem.  Note: If FileVault is enabled, or if a firmware password is set, or if the boot volume is a software RAID, you can’t do this. Post for further instructions.
    Safe mode is much slower to boot and run than normal, and some things won’t work at all, including wireless networking on certain Macs. The next normal boot may also be somewhat slow.
    The login screen appears even if you usually log in automatically. You must know your login password in order to log in. If you’ve forgotten the password, you will need to reset it before you begin. Test while in safe mode. Same problem? After testing, reboot as usual (i.e., not in safe mode) and verify that you still have the problem. Post the results of the test.

  • How can I get my MacBook to stay on and not sleep when lid is closed?

    How can I get my MacBook to stay on and not sleep when lid is closed?

    try this: http://www.macupdate.com/app/mac/37991/nosleep

  • I have an iphone 4 and i just updated to ios5 and i can't get my music to stay on my iphone and i also keep getting and error message when trying to restore iphone. anyone else having this problem?

    i have an iphone 4 and i just updated to ios5 and i can't get my music to stay on my iphone and i also keep getting and error message when trying to restore iphone. anyone else having this problem?

    When you restore, which error # appears?

  • How can I get location services to stay on inside?

    I have a WiFi iPad 2 w/iOS 8.1.  I want to use PayPal Here that requires location services in my nursery.  It works fine outdoors but inside our metal buildings with metal roofs the location services do not work (and PayPal Here does not work) even though I am still connected to our WiFi network.  PayPal support is no help.  How can I get location services to stay on inside the buildings?
    <Re-Titled By Host>

    Got to Settings > General > Autolock to set the lock time.

  • How can i get the icons to stay at the bottom of my screen?

    How can I get the icons to stay at the bottom of my screen even after closing the application?

    When it's open, control-click its Dock icon and choose Keep in Dock.
    (72521)

  • HT5557 I've always been able to see the clock at the top of the screen in iPad iBooks, but the clock has now disappeared unless I tap at the stop of the screen.  How can I get the clock to stay at the top of the screen?

    I've always been able to see the clock at the top of the screen in iPad iBooks, but the clock has now disappeared unless I tap at the stop of the screen.  How can I get the clock to stay at the top of the screen?

    cktan124:   I searched around and found the iPad does not have a PRAM.
    Anyone else want to guess?
    I found many folks here trying to hide of the clock, but I need the clock.  I use a PDF on my iPad for my notes when I am speaking in front of an audience.  I need the clock so I can kep track of time.

  • How can i get the backlight to stay on longer on ipad2

    how can i get the backlight to stay on longer on ipad2...when i play "words with friends" the screen turns dark in a minute or so

    Got to Settings > General > Autolock to set the lock time.

  • When I connect my Air to my Samsung TV, I am able to see the screen mirrored on the tv for a split second before the tv turns to static.  This pattern then cycles over and over.  I can't get the image to stay on the tv screen.  Any ideas?

    When I connect my Air to my Samsung TV, I am able to see the screen mirrored on the tv for a split second before the tv turns to static.  This pattern then cycles over and over.  I can't get the image to stay on the tv screen.  Any ideas?

    Try:
    - Going to NF support site/contacting them
    - Try a different adopter
    - Reset the iOS device. Nothing will be lost
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Reset all settings      
    Go to Settings > General > Reset and tap Reset All Settings.
    All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
    - Restore from backup. See:                                 
    iOS: How to back up                             
    - Restore to factory settings/new iOS device.

  • Can I get rid of the flashing bar of words while texting? Or even writing this post?

    Can I get rid of the flashing bar of words while texting? Or even writing this post?

    Settings - general - keyboard - turn off predictive text.

  • Can you get a battery replacement at an Apple store while you wait? What would the rough cost be, out of warranty?

    Can you get a battery replacement at an Apple store while you wait? What would the rough cost be, out of warranty?

    I am not sure what device you are trying to replace the battery on, but usually the battery is at least 30% of the cost of the device from what I have read. Apple likes to keep a monopoly on batteries I think. I have never seen them replace a battery at the store, usually they have to ship it out. You can find batteries for sale online, but you will have to crack the device open yourself.

  • Can't Update 1st-gen Shuffle

    I have iTunes 7.0.2 and Mac OS X 10.4.8. My (1st-gen) shuffle is recognized and syncs older or non-DRM songs just fine, but won't sync some newer songs purchased through the iTunes Music Store. I get a message telling my to perform an update from the Summary tab.
    Unfortunately, the Update and Restore buttons on the summary tab are disabled, so I can't use them. Nor can I use the iPod Updater 2.0.1 -- it never recognizes the iPod. The iPod Updater 2006-06-28 *does* recognize the iPod, but fails to recognize a software version. Likewise, the summary tab in iTunes says "n/a" for both Software Version and Serial Number. (I've tried "updating" using the 06-28 version; it tries, but gives me an error.)
    How can I update this thing? I'd like to have my newer music on my iPod.

    I downloaded and tried the Shuffle Reset Utility, but it couldn't restore the shuffle. I received an error message saying "No Firmware."
    However, I went to my wife's Windows computer, downloaded the Shuffle reset utility, and it worked fine, there. In fact, the Shuffle worked flawlessly with Windows (I was able to sync it with my wife's iTunes library, etc).
    I thought -- great, back in business! However, when I returned to the Mac and tried to sync with my own music library, I have the same problems; the Shuffle's version, serial number, et cetera isn't recognized, I can't sync newer songs, et cetera.
    Obviously, the Shuffle isn't the problem. Also, the Shuffle worked fine with my Mac before the latest iTunes update; I'm beginning to think it's a Mac software issue with the update. The other possibility is a connection issue, but I've tried all the direct USB ports on the computer, and also a powered hub (also, the fact that the Shuffle worked fine, before, makes me think that the connection probably isn't the issue).
    Dunno.

  • I keep trying to sync things among my MacBook Pro, iPAD, and iPhone.  Usually this works fine for a few days, but then I notice that the calendars aren't syncing and the "notes" aren't syncing.  How can I get them all to stay in sync?

    I have a MacBook Pro running OS X Yosemite, version 10.10.2.
    I have an iPad 2 running 8.1.3
    I have an iPhone 6 Plus running 8.1.1
    I have my Mail, Contacts, Calendars, and Notes set up to sync over iCloud among the three devices.
    I haven't had a problem with the Mail or Contacts syncing (at least not as far as I know), but the Notes and the Calendars don't seem to stay sync'd up.  I will notice that they aren't sync'ing, will delete and re-sync and they are fine for a while, but inevitably they stop sync'ing at some point.  This has been true through earlier incarnations of operating systems, so not something new.
    How can I get them to sync and stay sync'd?

    Soundman562 wrote:
    There used to be a tab under Itunes that allowed you to select to sync things like calendar, notes etc. but this is no longer there, can anyone help?
    This was removed in 10.9.  You may have better luck getting assistance in the relevant Mac forum.

  • How can I get "app Taps" to stay?

    I think this is in the right place, But When I set up "App Tabs" they don't stay? They will be gone the next start-up, How can I get them to stay? I am using a dell laptop, Vista 64-bit.
    I just recently( today) Installed FF4, Everything works great but the "App Taps", I tried to Pin Funny-junk (I was on the site when I figured out you could pin tabs) to the App Taps and it didn't load back as a App tab, Just a regular Tab on the next start up. I went up to the red X and clicked it to close Firefox(thought I would throw this in in-case someone says it might be because of a Bad exit way like task manenger or something)

    App tabs and Tab Groups (Panorama) are stored as part of the session data in the file sessionstore.js in the [http://kb.mozillazine.org/Profile_folder_-_Firefox Firefox Profile Folder]
    * http://kb.mozillazine.org/Session_Restore
    Make sure that you do not use [[Clear Recent History]] to clear the browsing history.

Maybe you are looking for

  • MFC Report numbers vs. Individual appliance numbers

    Hi, Can one of the IronPort folks comment on the difference between the numbers I see in reports generated for a server by MFC vs. the numbers I see in reports generated directly from that server? When I look at the MFC-generated report ('E-mail Volu

  • HTP package question

    I have a feeling I'm in the wrong place for this question but maybe someone can help. I'm not so good with Oracle configuration and setup issues but I have created a package with a few procedures that output info using the HTP package. At my old plac

  • XSQL setup woes continued

    I finally persuaded Apache/Tomcat to pass my xsql page to the servlet, & now get the following: Oracle XSQL Servlet Page Processor 9.0.1.0.0 (Production) XSQL-017: Unexpected Error Occurred java.lang.NoClassDefFoundError: oracle/xml/sql/query/OracleX

  • FileNotFound Vs NullPointer

    Hi, Why FileNotFound is checked exception while NullPointer is unchecked exception? Whether file is present or not is going to be known at run time so is the case with NullPointer as run time you will come to know ur object is null. What is that File

  • Advocacy Tool using BC?

    I am going to be doing some work for a non-profit. As part of this non-profit's work is to get the word out about changes in law and how to contact your representative for your area. Currently they link to another website that has the contact informa