Can i recieve service in Guatemala? Have problem home button and front camera
Hi guys
I'm user of ipod touch 4th generation i bought this in may 2011
And i paid apple care in applestore Glendale L. A CA.
Now i live in Guatemala and my ipod have problem of home button
And front camera(camera problem started when i bought)
What is best solution for my ipod? And can i recieve service?
And where can i meet service center in This country?
Contact an Apple Authorized Service Provider. See:
http://www.apple.com/lae/support/service/options/
Similar Messages
-
I have problems with buttons and Forms in my trial proof of Indesign CC, how can I fix it?
Moved to InDesign forum.
You can start by telling us what the problem is. -
Problems with headset and front camera
Hi, I get two problems about my Lumia 920 and my phone is still in warranty. Im just wondering whether these two issues are included in the warranty?
1. The left one of my headset suddenly goes wrong today, it cant give any sound now. Can it be fixed?
2. There are too much dust gets into the front camera, which has blurred the picture taken by it. Is there any possible way to clean it?
ThanksBoth should be covered under Warranty
Refer this for more details and the respective validity period ..
BTW, for the Headset issue, first check whether you are inserting the pin properly till the end. You may try a slight rotating actin or pull / push a few times and see. Also check whether there is any dirt within the post on the device that you can clean without damaging any terminals inside .. -
HT1212 I can't get the IPOD to start in recovery mode when pressing the home button and plugging in
I can't reset the passcode by holding the home button and plugging in to restore. Any ideas of why?
Try DFU mode.
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
Place the iPod in recovery mode using one of these programs:
For PC
RecBoot: Easy Way to Put iPhone into Recovery Mode
If necessary:
Download QTMLClient.dll & iTunesMobileDevice.dll for RecBoot
For MAC or PC
The Firmware Umbrella - TinyUmbrella -
i have a classic that seems to be stuck in restore mode, the screen says "do not disconnect'' and i can't restore using itunes. i have tried resetting it and still no good, what can i do to fix this problem ?
Be good to know what the diagnostic results are.
I've also just run into an issue where I couldn't restore an iPod with a corrupt file system, and the "super fix" in that linked article wasn't working for me. I've run across a potentially useful workaround.
iPod Classic went on the fritz today just after syncing. Couldn't restore via iTunes, kept getting 1439 errors, Windows wouldn't format as FAT32, claimed the "Volume is too big for FAT32". Finally tracked down EaseUS Partition Master Home Edition (Free) and formatted as FAT32 with 128k clusters. The iPod is filling back up again. Might be worth a shot here...
tt2 -
hello.can anyone help me plz i have problem with my macbook air i can't find image capture. there is nothing in progrem can i reinstall that progrem and how?thanks
If you can't find it in your applications folder you will need to reinstall your Mac OS X. Take a look at this link, https://discussions.apple.com/message/16478873#16478873
-
I have a ipad2, ipad3, and iPod touch that had location service working and now none of them can use location service. I have tried so many recommended tweaks but none have helped. So frustrating! Can anyone help ? Wifi only devices
Sounds like it's hardware issue. The iPhone warranty is based in the original country of purchase. Since it was bought in Korea you will need to ship the phone to someone you know in Korea to be taken in and then they will have to ship it back to you. The cost of shipping will be at your expense.
-
I have problem with my ipad3. I could not downgrade for ios 6.0.1 to 5.1.1. It was alarm code 3194. can u help me?, I have problem with my ipad3. I could not downgrade for ios 6.0.1 to 5.1.1. It was alarm code 3194. can u help me? Thanks...
Apple does not support downgrading iOS levels.
-
Can u plz tell me I hav problem with I phone 4 which I can hear their call but they can't hear my voice
Get help with hardware features on your iPhone, iPad, and iPod touch - Apple Support
-
Hi,since my update to OSX Yosemite,I have problems opening DW and AI CS6. A message with update to old Java SE-6 is displayed?Thx
You need to install Java SE 6 to run those programs. There has been quite a bit of discussion here about that. Something at one of these links should get you going...
Prompted to install Java SE 6 Runtime | Mac OS 10.9
Dreamweaver and Java SE 6 Runtime problem on MAC Mountain Lion OSX -
Since I installed ios 6.1 in my iPhone 4, I can't sync it with iTunes. Can annyone help me? I have already reinstalled iTunes and reseted the iPhone, but it still doesn't sync. Thank you.
Hello Sean,
It sounds like you are constantly needing to restore your phone because it keeps going into recovery mode. Usually putting a device into recovery mode and restoring it can help isolate an issue to your iPhone hardware if an issue persists afterwards. I would try manually putting it into recovery mode and restoring it 1 more time:
If you can't update or restore your iOS device
http://support.apple.com/kb/HT1808
If that does not resolve it the symptoms indicate to me that it is a hardware issue causing this to happen and would seek service for it:
iPhone Repair - Other Repairs
https://www.apple.com/support/iphone/repair/other/
Thank you for using Apple Support Communities.
All the best,
Sterling -
MY screen continually freezes up. I've tried closing all apps that are open and have held down the home button and start button simultaneously but neither helped. Can someone out there help me?
Well the next couple of things to try would be to reset all settings, and if that doesn't help, it's probably time to restore the iOS software.
Settings>General>Reset>Reset all settings. That will take all settings on the iPad back to factory defaults. It will not delete anything and you will not lose any data, but you will have to enter all settings again ...WiFi passwords, enable Siri, select your wallpaper, adjust brightness, turn on location services and set privacy settings, etc, etc.
You can read about restoring the software here.
iTunes: Restoring iOS software - Support - Apple
Should you decide to restore the iOS, it is extremely important that you back up first so that you can restore from the backup and then sync with iTunes afterward in order to restore all content back to the iPad. It is all covered in the kb article.
If you do not sync with iTunes, then I assume that you backup with iCloud. In that case you can erase the device in Settings>General>Reset>Erase all content and settings. Once again, backing up with I loud is I,operative before you do this so that you can restore from the iCloud backup after you erase the iPad and start over again with activation.
You should read this first before you restore from either backup.
How to backup and restore from a backup
http://support.apple.com/kb/HT1766
This is a must read before you erase the iPad should you decide to go that route.
iOS: Understanding 'Erase All Content and Settings' - Support - Apple -
Yesterday I was able to take photos but around 9pm last night my rear camera stop working. I have reseted my phone and have also restored it and the camera still is not working. Also I have deleted all apps that can have access to the camera and i have updated the new IOS.What else should I do ? Is this a hardware problem?
Looks like a hardware issue that will have to be taken to a store
-
just updated my iPhone 4s to ios6, now my phone won't turn back on. The apple logo comes on and sits then shuts off. Then comes back on and just sits.I have held down the home button and on/off switch several times to reset, but same problem persists.
Place iPhone on Wall Charger for at least 10 minutes. Then keep on charger and Reset, hold both home and power buttons until the iPhone begins to start, this can take about 20 seconds of holding both buttons while on charger. If still problem, open iTunes 10.7 on computer, connect iPhone to computer with USB Cable, hold both home and power buttons for about 20 seconds until iTunes recognizes iPhone in Recovery Mode, then click Restore button of iTunes. If still problem, try DFU Mode Restore, here are the steps. Open iTunes on computer. Connect iPhone to computer with USB cable. Hold both Home and Power buttons, after exactly 10 seconds release the Power Button, keep holding the Home button until iTunes recognizes iPhone in Recovery Mode, usually about 20 seconds time. If the iPhone screen is black, blank this is DFU Mode. Click the Restore button of iTunes. DFU Mode can be difficult to enter sometimes, just keep trying. DFU Mode is a black, blank screen with iTunes saying Recovery Mode. If still problem and there is Warranty or AppleCare make Genius reservation and take to Apple for resolution.
-
Have problems calling mobiles and landline to and ...
Hey, I have problems calling mobiles and landline to and other contry and i have and active subscrition.can u please help me out?
Hey, I have problems calling mobiles and landline to and other contry and i have and active subscrition.can u please help me out?
Maybe you are looking for
-
Submitted this to Palm as a feature request. Curious what others think about the idea. I know there are apps such as Active Home Screen (AHS) being tested and developed, but my approach would be contained within WebOS, thus not dependent upon running
-
PC to Mac, transfer itunes
I am waiting for my first mac, (27" i7) and want to put transfer itunes library from my pc to mac. What is the easiest way to do this? Go to my music and copy itunes library to disk and install on mac?
-
User Specific layout changes in settings
Dear Sir \ Mam, Need to remove check mark from layout design bar, Pls guide to enable it. Regards, Randhir
-
Mac OS-X Raw Converter for Canon produces sometimes wrong colors
I have just acquired a Canon 5D Mark II and I have some problems with the RAW converter supplied with Mac OS. The image is 21 Megapixels and it is the result of a long exposure. If I use the Canon Digital Photo Professional to produce the JPEG, I get
-
Merry Christmas everybody, My menu_bar has lot of buttons with different text captions (of course) and each one (text) depends from a var defined on main actions page. So, the button text was made with a bold property and when the movie is loaded, it