Can I use "Back to My Mac" to access a Mac that has not been logged in to?

I bought a Mac Mini and set it up with "Back to My Mac". I have set it up with Automatic login right now, but I would like to deactivate it.
When the computer is on, but at the login screen step of the boot up, is it possible to access it with "Back to my Mac"? I am under the impression that that is not possible.
Thanks for any insights you guys might have in your current setup.

Both TC should be in bridge mode. Is that what you have done? You cannot use the TC in router mode as it will cause double NAT problems.
Can you access one of the TC? Or do both fail to show up?

Similar Messages

How can you share music wiyh another iphone in the same house that has not been connected to a compter

how can you share music on iphones in the same houes when one of phones has never been connected to a computer

Hello weeshaza,
It sounds like you are wanting to sync more than 1 device to your iTunes Library. This article will help you do that:
How to use multiple iPhone, iPad, or iPod devices with one computer
http://support.apple.com/kb/ht1495
Thank you for using Apple Support Communities.
All the best,
Sterling

Could not use the clone stamp tool because the area to clone has not been defined

Freshly installed Elements 10. Can not use the option-mouse click to define an area for the clone stamp. The error I get is:
Could not use the clone stamp tool because the area to clone has not been defined (option-click to define a source point).
New Mac Mini. Had the same problems in Elements 9 so I installed the 10 trial. Is this a key binding error? Did not have this issue with Elements 9 on my Mac Air or my Windows 7 system.
I'm not a newbie and know how to use the clone tool. I won't say I'm an expert so if it's something related to layers please throw out some ideas.

This problem came back up. I hadn't used PSE since last November and was frustrated to run into it again. I don't think it's a layers issue afterall.
I use a wireless keyboard and mouse on Mini and mouse on Air, although keyboard for Air is upstairs at a desk with monitor for occasional use. Regardless blue tooth is on for these devices. Problem exists. Turn bluetooth off on Air and the problem is gone. It must be related to option key when bluetooth is on, I guess some different mapping. Even when I have bluetooth on and try to use Option key on the Air keyboard it does not work.
So now where do I look for configs to check?

HT204370 can you return a movie purchased by mistake that has not been viewed yet?

can you return a movie purchased by mistake that has not been viewed yet?

Hi jimmy505,
The following information should help you with this:
How to report an issue with your iTunes Store, App Store, Mac App Store, or iBookstore purchase
Find the email receipt for your purchase.
Click Report a Problem under the app that is having the issue.
When prompted, enter the Apple ID and password you used to purchase the item, then click Report a Problem.
Click Report a Problem next to the item you are having an issue with.
From the Choose Problem dropdown menu, choose the appropriate issue.
Follow the onscreen instructions and—if prompted—type a description of the problem into the text field.
Click Submit to have your issue reviewed.
Hope this helps ....
- Judy

HT1351 I have an IPOD that has not been synced to Itunes for several years. I no longer have the same computer or e-mail address. How can I sync my old IPOD material to my new itunes account?

I have an older IPOD that has not been synced to Itunes for seceral yeras. I no longer have the same computer or e-mail address. How can I sync my old IPOD material to my new Itunes account?

Your email address (used as your Apple ID) does not matter, because iPods are not directly linked to a particular Apple ID.
NOTE: You can still use your old Apple ID, even if your that email address is no longer valid. As long as you remember your Apple ID password. Go here and click on Manage your Apple ID.
https://appleid.apple.com/cgi-bin/WebObjects/MyAppleId.woa/
You can change the primary email address used by Apple, although the Apple ID remains the same.
Back to the iPod. iTunes syncing is generally in one direction only, from the computer's iTunes library to the iPod. You cannot use iTunes to transfer song files from iPod to computer, except for songs purchased from the iTunes Store. However, there are third-party methods and utilities that can transfer from iPod to computer. If you do an Internet search on something like "ipod transfer," you should get some links. (The CNET article seems to be popular.)
Once the song files are on your computer's drive, you can add them to your new iTunes library. After confirming everything is there, sync your iPod to that library. If there is any content purchased from the iTunes Store that uses DRM (copy protection), such as audiobooks, videos, and very old song purchases, iTunes may prompt you to authorize your computer with your Apple ID (the one you used to make the purchases).

I can't open i Tunes. Message: This version of i Tunes has not been correctly localized for this language. Please run English version.

I can't open i Tunes. Message: This version of i Tunes has not been correctly localized for this language. Please run English version.
Why did this happen and how do I correct so I can open and use i Tunes again?

please disregard my question.... I just re-installed I-tunes and it works again...

Could not use the clone stamp tool because the area to clone has not been defined (option-click to d

Could not use the clone stamp tool because the area to clone has not been defined (option-click to define a source point). this is what shows up in the command box when ever I click to start to pick the spot i want to use as the clone. makes my cloning tool useless. can any one help? I have reset the tools restrted my computer. i am at a loss...

Are you working with more than one layer? If you are working with multiple layers it makes a difference when selecting source spot and then trying to clone to a different layer. I find that I have to be sure I am selecting the corresponding layers for source and then for application when working within multiple layers.
At least for me this is the case when getting that type of message. I am very new to this program though, so maybe someone else has a more concise answer for you.
Good luck and write again if this doesn't help.
Moon52
Sent from my iPhone

I have 3 PC's. Two of them I use at 2 different locations and only use them 6 months a year. So, if I have Icloud for my calendar, and turn on a computer that has not been used for 6 months, does all the old information on that computer to go Icloud?

I have 3 PC's. Two of them I use at 2 different locations and only use them 6 months each year. When I turn on a computer that has not been used for 6 months, does all of the old information from that computer end up in Icloud? Does Icloud push all the new calendar and contact items over the old items?

A reset may help. Tap and hold the Home button and the On/Off buttons for approximately 10-15 seconds, until the Apple logo reappears. When the logo appears, release both buttons.
No content is affected by this procedure.

Can you remove a date and time stamp off a photo that has already been taken?

Can you remove a date and time stamp off a photo that has already been taken?

only with Photoshop or similar software that offer some clone/heal feature.
Weekend Travelers Blog | Eastern Sierra Fall Color Guide

Is there a way to recover my photos on my iphone that has not been backed up. It was dropped in water and will not turn on. I have had it in rice for 24 hours. Thank you

Is there a way to recover my photos on my iphone that has not been backed up. It has been in rice for 24 hrs.
Thank you !

No since thay have not been backed up. Hopefully the phone will work long enough after the 'rice treatment" for you to recover the phone and do a backup. The rice sometimes does not work. Good luck.

I have just updgraded to Mavericks and my bootcamp has vanished! I have an entire webite that has not been backed up in a while. All lost.... anybody got any ideas?

I have just updgraded to Mavericks and my bootcamp has vanished! I have an entire webite that has not been backed up in a while. All lost.... anybody got any ideas?

If you cant mount that partition in the disk utility, then try these steps in the terminal:
http://chrislee.kr/wp/2011/05/23/how-to-mount-bootcamp-drive/

Can I restore photos from a crashed iPhone 4s that has not been backed up?

I have a 2 week old iPhone 4s that has started to freeze up. I rebooted the phone several times successfully yesterday. This morning, the phone will not reboot, the Apple logo just remains on screen. I have never sync'd this phone to my iTunes library so there is no backup. Is there a way to recover the photos/videos that are on the phone? I am hesitant to resore the phone for fear of losing the data (mostly photos). Any help is appreciated.

If the iPhone has not been backed up, you will definitely loose what is in the Camera Roll when restoring the iPhone.
Photos/videos in the Camera Roll can and should be imported by your computer as with any other digital camera, which is not handled by iTunes. If you are unable to back up the iPhone before restoring and you are unable to import the Camera Roll before doing so, the data will be lost.

HT201365 my iphone 4s has been stolen yesterday and forgot to put activation lock. but i have the serial number can apple use my serial number to track it and roport that has stolened?

PLEASE HELP my iphone 4S has been to stolen. but i forgot to activation lock it. Can you use my iphone serial number to lock it even the person who did this me havent use the internet in the phone to track it.
1.The person deleted everything and i cant tract it.
2. deleted my account to use my phone.
3.Apple please tract my iPhone 4S using my serial number # C39GY1E7DT9V

What worries me is that Lost Mode (stolen) doesnt take effect until it connects to the internet.
Lito Sady wrote:
PLEASE HELP my iphone 4S has been to stolen. but i forgot to activation lock it. Can you use my iphone serial number to lock it even the person who did this me havent use the internet in the phone to track it.
1.The person deleted everything and i cant tract it.
2. deleted my account to use my phone.
3.Apple please tract my iPhone 4S using my serial number # C39GY1E7DT9V

Can I use Icloud on a ipad that has not been registered yet. I just purchased it and can not find it

Can someone please help me. I have a brand new Ipad that is not yet registered and can not find it. I only have the box.

Unless "Find My iPad" is activated on the iPad sadly you won't be able to locate it
Regards
J

How can I load movie on (onPress) and then check if the invoked has not been called by any other members before? Thx

Hello Everyone,
I would highly appreciate your wisdom and advice on this
functionality. Lets say I have two
movieclips on the stage(ClipA, ClipB). I would like user to
be able to click on any of them and, this click
will invode a createclip function which pretty much creates a
dynamic movieclip and loads
whatever I assign to it such other existing clips within the
library. The only problem I have
makeing the functionality work is that I would like to limit
the function call to one at a time.
So if the user clicks on ClipA, function createclip would get
invoke and will attach the assigned
movie clip. And when user clicks on ClipB, I would like to
end the function call that was invoked
by the ClipA and then then allow ClipB to invoke the
function.
Pretty much it would a logic like:
if(createClip = true)
end it;
else
createClip();
When a movie is attached, can it be unloaded or unattached?
I don't know how to write a function that would check if
function createClip() has
already been invoked. I would highly appreciate any direction
in this.

If the objective is just to get a unique list of authors based on your key, you could use the REPLACE statement in MySQL which functions as an "insert on duplicate key update" type of construct.
[http://dev.mysql.com/doc/refman/5.0/en/replace.html|http://dev.mysql.com/doc/refman/5.0/en/replace.html]
Catching an exception to detect dupes is functional but not very elegant. If you use REPLACE then you know your statements will always work. The drawback is that the statement is not portable across databases.

Can I use "Back to My Mac" to access a Mac that has not been logged in to?

Similar Messages

Maybe you are looking for