Can't adjust Bass and Treble from windows Mixer (SB Audi

Hello,?i have Sound Blaster Audigy (5.)i installed drivers for it, but i cannot adjust Bass and Treble from ordinary W?ndows Sound Mixer, because sliders are passi've (disabled)?what is the solution?tahnk you. my system is:windows xp prof. edition + SP2Pentium III 800 mhz,?384 mb ram,asus cuv4x 33mhz mainboard.

Check your "audio" settings in the sound and audio properties of your control panel.

Similar Messages

  • Cannot adjust bass and treble settings.

    I just installed the SoundBlaster Li've 24-bit sound card specifically so I could adjust the bass and treble settings under Advanced Options in speaker settings for a new job, but the bass and treble settings are greyed out. Can you tell me why this is? I have Windows XP.
    Thanks,
    Danielle

    I'm having the same problem -- I also have Win XP Home. So I'll be interested to hear of any suggestions for fixing this issue. Also, when I try to record voice using Windows Sound Recorder and play it back, the sound volume is very low and poor quality (yes the mic volume is turned up).

  • Hp hdx18 no bass and treble on windows 7

    I have an Hp HDX-1000CTO and after upgrading to windows 7 and Installed of the drivers from the HP website.
    I do not get on my display the Bass and Treble, however I do get only the sound display which I have to admit is not as nice as the one I used to have with my windows vista displaying the  volume, bass and treble at the same time.

    I have an Hp HDX-1000CTO and after upgrading to windows 7 and Installed of the drivers from the HP website.
    I do not get on my display the Bass and Treble, however I do get only the sound display which I have to admit is not as nice as the one I used to have with my windows vista displaying the  volume, bass and treble at the same time.

  • How do I adjust Bass and Treble in X-Fi Game Mo

    Thx

    Through the EQ ( equalizer) tab. The lower numbers are the bass ranges (lower 3 or 4 sliders) the mid ranges are sounds in the voice range , etc... (mid 3 sliders) the uppers are all other higher pitched sounds. BTW the human hearing range is about 4k so the 6K slider should really be not much more than noise.
    You can also "enable bass boost" for more bass sounds. But in FPS multiplayer gaming it is highly likely you will want much bass as it will cover opfor approach and detailed sounds.
    good luck BurZ-

  • Adjust bass and treble

    I have an HP g7-1310 laptop that has srs Premium Sound w/ ALTEC Lansing. You would think that with all that fanfare there would be some way to equalize the sound. The only adjustment I've been able to find in the sound control/mixer is volume control. I need to boost treble and cut down bass due to hearing loss. Is there a way to add an equalizer to use in Windows 7?

    BEFORE YOU MESS WITH EQUALIZER UNCHECK THE STUPID "BASS MANAGEMENT" OPTION.  I ALMOST BOUGHT AN UNNEEDED SOUND CARD BEFORE I FOUND IT.  ALSO THE LAST OPTION IN THE LIST THAT LETS YOU DEFINE HOW FAR EACH SPEAKER IS FROM YOUR EARS IS A MUST HAVE EVEN THOUGH IT TAKES SOME TIME TO SET UP.
    P.S. Actually after rereading your post - "Bass management" may be just what you are looking for.

  • Vista crashed, did factory reset, downloaded and installed Thunderbird, can I get messages and contacts from windows backup

    Did a factory reset of Windows Vista. Had Thunderbird before, downloaded and installed after reset. I have a windows backup on external drive that was made about a week before the crash. Would the old contacts and messages be on this windows backup? If so, how to retrieve?

    What you need is your Thunderbird profile folder. Check whether that's in your backup.
    http://kb.mozillazine.org/Profile_folder_-_Thunderbird

  • My question was how do you control bass and treble on your Mac pro? he act of the matter is you can't. Why don't they just say that rather than reading all of the ********

    My question was how do you control bass and treble n a Mac Pro with the latest software.
    The answer is you can't
    In summary why don't you say that upfront?
    Instead of reading a bunch of crap that says nothing

    just a suggestion: try soundflower or Audio Hijack Pro. I know with the 2nd one, you can control the bass, treble, and all that, with anything that makes sound, from itunes, to Safari, DVD player, Skype ( I guess) and other stuff. Worth the $, IMO, so in answer to your question  dbumgardner1, no, no you can't.  I suppose in that sense, Windows has us at a loss. We also need 2nd party stuff to play BluRay's, too. However, I haven't seen any Macintosh viruses (virii?) for a long long time....
    so, there's that....
    JB

  • Adjust the bass and treble

    Hi,
    I'm trying to adjust the bass and treble so that when I hear my Web Radio in Streaming I will adjust the bass and trebles.
    I can do it very well with a file. But how to perform it with the streaming radio ?
    Thanks in advance

    Did anyone ever answer this???? I'm having the same issue but on my ipad mini...

  • I'm unable to write/burn a CD-R (Verbatim) from a playlist after upgrading to iTunes 12.0.1.26. I get error 4000. I can however write/burn a CD from Windows Explorer and CDBurnerXP v4.5.4.5143 – which implies the device is working OK

    I’m unable to write/burn a CD-R (Verbatim) from a playlist after upgrading to iTunes 12.0.1.26. I get error 4000. I can however write/burn a CD from Windows Explorer and CDBurnerXP v4.5.4.5143 – which implies the device is working OK – and only fails when I write from iTunes.  The drivers are up to date
    Microsoft Windows 7 x64 Business Edition Service Pack 1 (Build 7601)
    Dell Inc. Latitude E6420
    iTunes 12.0.1.26
    QuickTime 7.7.6
    FairPlay 2.7.39
    Apple Application Support 3.1
    iPod Updater Library 12.0
    CD Driver 2.2.3.0
    CD Driver DLL 2.1.3.1
    Apple Mobile Device 8.0.5.6
    Apple Mobile Device Driver 1.65.0.0
    Bonjour 3.0.0.10 (333.10)
    Gracenote SDK 3.06.0.2770
    Gracenote MusicID 3.06.0.2770
    Gracenote Submit 3.06.0.2770
    Gracenote DSP 3.06.0.2770
    iTunes Serial Number 756D13C00C3583C8
    Current user is not an administrator.
    The current local date and time is 2015-01-13 14:47:35.
    iTunes is not running in safe mode.
    WebKit accelerated compositing is enabled.
    HDCP is supported.
    Core Media is supported.
    Video Display Information
    Intel Corporation, Intel(R) HD Graphics Family
    **** External Plug-ins Information ****
    No external plug-ins installed.
    iPodService 12.0.1.26 (x64) is currently running.
    iTunesHelper 12.0.1.26 is currently running.
    Apple Mobile Device service 3.3.0.0 is currently running.
    **** CD/DVD Drive Tests ****
    LowerFilters: SbCeCd (3.2.6.3),
    UpperFilters: GEARAspiWDM (2.2.3.0),
    F: HL-DT-ST DVD+-RW GU40N, Rev A103
    Drive is empty.
    The last failed audio CD burn had error code 4000(0x00000fa0). It happened on drive F: HL-DT-ST DVD+-RW GU40N on CDR media at speed 24X.
    F: HL-DT-ST DVD+-RW GU40N, Rev A103
    Audio CD in drive.
    Failed Reading table of contents, error 4000.
    Check the website of your computer or drive manufacturer to verify that you have the latest firmware for your CD / DVD drive.
    Audio CD reading failed. Error Code:   87 87 87 87 87 87 87 87 87 87 87 87 87 87 87 87 87 87 87 87.
    iTunes cannot play or import music from a CD in this drive. The drive may need a firmware update. Check with the manufacturer.
    Get drive speed failed. Error Code: 4000.
    The last failed audio CD burn had error code 4000(0x00000fa0). It happened on drive F: HL-DT-ST DVD+-RW GU40N on CDR media at speed 24X.

    Hi iTunes-1,
    Welcome to the Support Communities!  The error message you posted indicates a possible firmware update is needed for iTunes for Windows to work with your CD drive.  
    iTunes for Windows: Updating the firmware on your CD or DVD drive - Apple Support
    http://support.apple.com/en-us/HT201852
    Having outdated firmware can cause issues using CDs and DVDs with iTunes for Windows. Firmware is a type of software stored in a chip in hardware that can sometimes be updated.Identifying drives and firmware versions
    To run CD Diagnostics, follow the steps in this document.
    After following the steps to run CD Diagnostics linked above, look at section three to find out more about your optical drive(s).
    Here is an example of what section three might look like:
    In this example there are two drives. Drive E is a Samsung DVD-ROM drive with a model designation of SD-616 that has firmware version F000. Drive F is an NEC drive with a model designation of NR-7900A that has firmware version 1.08.Updating the firmware
    If the optical drive you are using came with your computer, check with the support site for your computer for a firmware update. Typically you will need to go to the support website for the computer maker and click on a "downloads" or "updates" link, and then enter your computer model designation and operating system version to see what updates are available. Then look through the available updates for a firmware update for your optical drive. Download the updater and run it. If you need assistance applying the update, contact the maker of your computer.
    If the optical drive you are using came as a separate part (was not included with a computer), check the support site for the drive maker for a firmware update. Sometimes the manufacturer is not clear in the CD Diagnostics results. In that case, you may just have to search the Internet for the drive model designation. You can usually find out who made the drive by looking through the results of such a search. Once you have identified who made your drive, go to the support website for that company. Look for a "downloads" or "updates" link, and then enter your optical drive model designation. Download the updater and run it. If you need assistance applying the update, contact the maker of the optical drive.Verifying that the firmware was updated
    Run CD Diagnostics again.
    Examine the CD Diagnostics results. The firmware version for the drive should be the new version.
    Information about products not manufactured by Apple, or independent websites not controlled or tested by Apple, is provided without recommendation or endorsement. Apple assumes no responsibility with regard to the selection, performance, or use of third-party websites or products. Apple makes no representations regarding third-party website accuracy or reliability. Risks are inherent in the use of the Internet. Contact the vendor for additional information.
    Last Modified: Nov 8, 2014
    Also, you mentioned that you have been successful burning a CD with the Windows OS.  Make sure that you have closed all software programs that can access the CD burner so that there isn't a conflict for the drive.   Sometimes chaning the burn speed from "maximum" to 8x can also help in this situation.
    I hope this information helps ...
    - Judy

  • Is there a way to adjust the bass and treble on my iMac Power PC sound system?

    Is there a way to adjust the bass and treble on my iMac Power PC G5 sound system? It has a lot of volume (more than my JBL speakers).

    No, but iTunes has an Equaliser that enables you to do that.

  • I can't drag and drop from windows explorer into my ipod on itunes. Any suggestions?

    Hi,
    I manage my music/podcast library on my Vista PC using windows explorer because I don't like how iTunes does it. Then today I can no longer drag and drop from explorer onto my iPod in iTunes all I get is a circle with a line through it meaning "iTunes says no." Any suggestions?
    Ta.

    You will need to Sync your iPad and all Music/Albums Selected will transfer over from iTunes..
    iOS: Syncing your data with iTunes
    http://support.apple.com/kb/HT1386

  • Can't copy and paste from windows to firefox(apple)

    I have an apple(mac os x). I have parallels desktop 3.0 for this mac.
    Problem: can't copy and paste from windows to firefox.

    I have a Mac OS X. I bought software for the Mac.(parallels Desktop 3.0 for Mac) so that I could use Windows on my Mac. I have Firefox browser.
    I can not copy anything from Windows and Paste it in Firefox.
    But I can copy and paste as long as I am not in Windows.
    Ray Chambers [email protected]

  • Does MacOS recognize Windows directory structure? Can I move an entire folder (consisting of subfolders and files) from Windows to Mac?

    Can I move an entire folder (consisting of subfolders and files) from Windows to Mac?

    Mustafafromnc,
    if you’re talking about a USB drive, then it will probably have an exFAT filesystem. Modern versions of OS X can read from and write to exFAT filesystems without problems, so you would be able to move Windows folders, subfolders, and files from an exFAT filesystem to an OS X filesystem.

  • Can't copy and paste from windows to firefox

    I can not copy and paste from windows to firefox???

    I have a Mac OS X. I bought software for the Mac.(parallels Desktop 3.0 for Mac) so that I could use Windows on my Mac. I have Firefox browser.
    I can not copy anything from Windows and Paste it in Firefox.
    But I can copy and paste as long as I am not in Windows.
    Ray Chambers [email protected]

  • Control bass and treble in System Pref

    Is there a plugin or an add-on that will allow me to control bass and treble output from my Macbook's soundcard?

    when you click on "window" in the menu bar, there is and euqualizer. You can control the bass/treble and preamp levels from there. Other than that, there is no other option. Why kind of setup do you use? Because from the macbook speaker it won't make much of a difference.
    Cheers
    Charles

Maybe you are looking for