Can't restart phone apple logo only
I started downloading an app and it froze about 3/4 of the way through the download. My phone then slowed down, I deleted a few apps as I thought maybe it was space that was freezing the download. I tried to pause the download...didn't work...so I restarted my phone (powered off). When it came back on I'm at the equivalent of the 'blue screen of death' for a computer....the apple logo only!
Help!
Try reset
Reset: Hold down the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears. Note: You will not lose any data
Similar Messages
-
ipad 2 can not restart, apple logo only appears 2 seconds after that recharge logo appears for 2 minutes continuously while on the charger,pls help me
Try a reset; hope it'll force it into Recovery Mode
Hold the Sleep and Home button down until you see the Apple logo. -
iPad stops responding, showing the Apple logo only,i tried to place into recovery mode and attempted to restore again but after downloading the software, it brings error in downloading s/w message.can anyone help please.Thanks
http://support.apple.com/kb/TS3694#error14
These errors are typically resolved by performing one or more of the steps listed below:
Perform USB isolation troubleshooting, including trying a different USB port directly on the computer. See the advanced steps below for USB troubleshooting.
Put a USB 2.0 hub between the device and the computer.
Try a different USB 30-pin dock-connector cable.
Eliminate third-party security software conflicts.
There may be third-party software installed that modifies your default packet size in Windows by inserting one or more TcpWindowSize entries into your registry. Your default packet size being set incorrectly can cause this error. Contact the manufacturer of the software that installed the packet-size modification for assistance. Or, follow this article by Microsoft: How to reset Internet Protocol (TCP/IP) to reset the packet size back to the default for Windows.
Connect your computer directly to your Internet source, bypassing any routers, hubs, or switches. You may need to restart your computer and modem to get online.
Try to restore from another known-good computer and network. -
What does it mean after you update your phone and then your phone starts to blink on and off showing the apple logo only?
Read http://support.apple.com/kb/ht1808
-
i was updating my iphone 4 through settings but in the middle my phone switched offf n now what i can see is the apple logo blinking n i cant connect it to itunes can any1 help me?
If you have a backup of your information on your computer, I would suggest putting your phone into recovery mode, by holding down the home key and keeping it held down while you connect it by usb into your computer with itunes running. Keep the home button held down until it indicates recovery mode, and proceed with the restore.
-
I tried to reset my iPhone (3gs) with deleting all data. When it power off and automatically again on then it is showing Apple logo only. Not restore and startup my phone. iPhone alerming low charge and I tried to charge and not charging.
What I should do now?Something has gone wrong. Turn your phone off, then force it into recovery mode:
Leave the USB cable connected to your computer, but NOT your phone, iTunes running, press & hold the home button while connecting the USB cable to your dock connector, continue holding the home button until you see “Connect to iTunes” on the screen. You may now release the home button. iTunes should now display that it has detected your phone in recovery mode, if not quit and reopen iTunes. If you still don’t see the recovery message repeat these steps again. iTunes will give you the option to restore from a backup or set up as new. In your case, select "new". -
I recently had my iPhone 5c screen replaced. When I switch the phone on all I can see is a dark blue/navy backlight on the screen. The phone powers on although I can't see the apple logo. I can ring the phone a bad Siri is fully functional.
I Have tried to soft rest it but it does not work.
can anybody help?Belly114 wrote:
Unfortunately because you have violated the warranty - it will cost £216.44. See https://www.apple.com/uk/support/iphone/repair/screen-damage/
Unfortunately, since an unauthorized party opened it, Apple won't have anything to do with it at all. It's not eligible for an out of warranty replacement. -
I have macbook without a firewire port, I have usb 2.0 port, now my os is not working I can not get through apple logo loading , I can not enter safe mode, I can only enter one user mode, how can I backup my data, I have very important data in my hdd
Here is what worked for me:
My usb hub, being usb2, was too fast. I moved the wire to a usb port directory on my pc. That is a usb1 port which is slow enough to run your snyc. -
My iphone screen only show the apple logo only
when i updated my iphone, suddently my usb no work now stop already. then it only show on my monitoe is the apple logo only.
cannot restart, cannot do anything. Please help me solve the problem. i scared.Did you try to reset the phone by holding the sleep and home button for about 10sec, until the Apple logo comes back again?
If this does not work, try to connect in recovery mode and restore again, explained in this article:
iOS: Unable to update or restore -
Can't turn on apple logo fades a moment after pressing on button
can't turn on apple logo fades a moment after pressing on button - not recognised by itunes as being there. Can charge - however this causes the apple logo to appear and disappear repeatedly??
Hello there Struth23,
Sounds like you may need to reset the iPhone or put it into recovery mode to resolve the issue if it is to do with the software.
From iPhone, iPad, iPod touch: Turning off and on (restarting) and resetting
http://support.apple.com/kb/ht1430
Resetting your device
Press and hold the Sleep/Wake button and the Home button together for at least ten seconds, until the Apple logo appears.
And if needed, iTunes: Restoring iOS software
http://support.apple.com/kb/ht1414
Cheers,
Sterling -
My computer won´t boot and restarts at Apple logo with the spinning thing
My computer won´t boot and restarts at Apple logo with the spinning thing and I can´t get it to work.
Before this happen I had left the computer on without a cable plugged in and so it ran out of power.
I just pressed the startbutton again after I´ve plugged it in and this problem started.
Any ideas?
Mattias
SwedenWRONG FORUM Sorry
-
IMac G5 boots to gray screen with Apple logo only
iMac G5 boots to gray screen with apple logo only.
What I've tried:
Won't boot to safe mode.
Reset PRAM several times.
Won't boot to install disk with "C" depressed at startup.
Will boot to screen showing HD and arrow buttons when "alt" depressed at startup. But clicking HD icon and proceed arrow just goes back to the gray screen with apple logo. Note the HD icon has a blue "x" symbol.
With install disc in, will boot with "alt" depressed at startup to three icons, HD, install disc, and apple hardware test. Both HD and install disc icons have the blue "x" symbol and won't run. BUT the apple hardware test icon doesn't have a blue "x" and runs. Extended test says all hardware OK.
Finally, startup in single user mode with "apple-s" depressed goes to a non-gui white text (UNIX core?) which gives blocks of repetitive text starting "unresolved kernal trap (cpu0)...(lots of date)...latest crash.....backtrace:" My rough guide to the Mac gives me text to enter at that point but I can't input to the screen.
That's where I'm stuck.You're encountering a kernel panic.
[I got a black screen telling me I had to reboot in many languages, what was it?|http://www.dslreports.com/faq/4970] Also has detailed description of what happens during a KP.
[Apple docs: What's a kernel panic? (Mac OS X)|http://docs.info.apple.com/article.html?artnum=106227]
[Topic : kmosx: Kernel Panics? Don't panic too !|http://discussions.apple.com/thread.jspa?threadID=121923]
[X-Lab: Resolving Kernel Panics|http://www.thexlab.com/faqs/kernelpanics.html]
[Tutorial: Avoiding and eliminating Kernel panics|http://www.macfixit.com/article.php?story=20060911080447777]
[Tutorial: An introduction to reading Mac OS X crash reports|http://www.macfixit.com/article.php?story=20060309075929717]
[12-Step Program to Isolate Freezes and/or Kernel Panics|http://macosg.com/group/viewtopic.php?t=800]
[Texas Mac Man's post on kernel panics|http://discussions.apple.com/thread.jspa?threadID=1723768&tstart=0]
These are often attributed to hardware problems though they can also be due to corruption of software. Since you're also encountering it with your DVD I'd tend more towards the former. Your computer seems to be passing the early stage POST tests for RAM. Apple Hardware Test also seems to be passing but [X-Lab: The Apple Hardware Test|http://www.thexlab.com/faqs/aht.html] document recommends using this in loop mode to test for intermittent problems.
Sometimes the crash logs (all the error messages you are seeing) contain information about the problem, but there's an art to reading those. -
i've jail break Iphone 3GS. i tried to restore setting (erasing all data and media) without connecting to computer/itunes. When it starts it freezes by showing apple logo only. what is the solution. please help me out. Here i don't have iphone service center too.
Although not illegal, Apple discourages a user from modifying the iPhone OS in any manner, including "jailbreaking". Apple feels so strongly about this that discussing methods to assist a user trying to either jailbreak or "unjailbreak" an iPhone are prohibited.
-
When I turn on computer I can't see the apple logo the screen is just a gray screen
When I turn on computer I can't see the apple logo the screen is just a gray screen? I know a person presses "alt" to switch people apple and windows using bootcamp, but I just don't see the apple logo anymore. What is wrong with this thing?
So, do you see any boot choices if you hold alt at bootup?
-
Im Using an ipod touch 4th gen and i have updated the iOS to 6 and nothing happens except the screen is always in apple logo only. and when i connect it to laptop, the ipod does not recognizein windows and also in iTunes
The Nano uses different drivers than iOS devices like the iPod touch
See
iOS: Device not recognized in iTunes for Windows
- I would start with
Removing and Reinstalling iTunes, QuickTime, and other software components for Windows XP
or
Removing and reinstalling iTunes and other software components for Windows Vista, Windows 7, or Windows 8
However, after your remove the Apple software components also remove the iCloud Control Panel via Windows Programs and Features app in the Window Control Panel. Then reinstall all the Apple software components
- New cable and different USB port
- Run this and see if the results help with determine the cause
iTunes for Windows: Device Sync Tests
Also see:
iPod not recognised by windows iTunes
Troubleshooting issues with iTunes for Windows updates
- Try on another computer to help determine if computer or iPod problem
Maybe you are looking for
-
Server 2008 crash - black screen with mouse cursor
dell poweredge 2950 with Perc 5/I RAID, ESXi 4.1 host, Windows Server 2008 R2 SP1 VM After swapping out a failed raid5 drive this vm began displaying inpage operation error popups while checking folder permissions. event viewer errors: The file sys
-
I just purchased the new I pad mini Retina display 16 GB and have AT&T Lite. I cannot send emails. I do receive them. The message is "copy placed in outbox. Recipient rejected by the server". Who is the server?
-
Windows 8 and Premiere 11??? Please help
Hi I'm on windows 8 (64 bit) and PE11. Today I lost all my work although I had saved regularly and I have to re-render very often. Tonight as I'm trying to re-do my day's work, I'm losing sync and entire clips keep disapearing. It seems to be beco
-
Error while starting SOA suite
Hi All, i am unable to start SOA suite it is giving a error saying OPMN error how to come out of this Configuration information Running in C:\product\10.1.3.1\OracleAS_2 Operation mode:Startup, App Server, No Enterprise Manager, Single Instance Oracl
-
Iphoto needs to update, but it says no update available
I need to update iphoto to use it on icloud, but its not letting me update it eventhough it needs to be updated.