Cannot get my PSC 1350 printer operating anymore from OS 10.6.3

I have been facing quite an unexpected regression over the last couple of days
My kid told me the scanner option of PSC 1350 All-in-One was not working anymore. After some basic testing I arrived to the same conclusion.
I re-installed the printer using the HP installer disk (dated 2005) and could restore the scanner function successfully. Did a Print Test from the HP Director S/W and the test printed successfully. Unfortunately the normal print function from an application (TextEdit, Safari, etc.) regressed and I fail to get it working again until now.
Self-test of the printer is OK. I also repaired permissions with the Disk Utility. But no improvement.
Actually the symptom was when I tried to print, the file falls immediately in the queue list with error. But no error code or anything that could help to follow a track appears, this is why I am now begging some help to Mac wizards
I tried so many different configurations that I pass the historical details. This is driving me mad and this is where I am presently : I uninstalled all HP software and refreshed the printers list. Then I retrieved a PSC 1300 series driver for Mac OX X 10.6 on HP service website with a light of hope that it could finally fix the problem : Inkjet710_6_Print_Mac1.dmg
I ran installation SW and it reported successful installation.
The problem is now that I cannot retrieve any trace of the HP Installer presumably installed and the HP procedure never says clearly in which folder the HP Installer is due to copy.
Could anyone provide me with a clean procedure to :
1. check where the HP Installer may have been written, as running this HP Installer may hopefully be the end of my problems
Else
2. how to cleanse trace of any previous printer installation
3. how re-install from scratch the PSC 1300 series driver in a way that it prints successfully under Mac OS 10.6.3 other than using the HP Installer above.
Thanks in advance to who may help me to get out of the maze.

Gilou, I would suggest calling HP tech support, as this appears to be a problem with the printer, rather than with Snow Leopard. Good luck!

Similar Messages

Cannot get pdf file to print actual size

I recently had to reinstall my printer and now when printing PDF files I cannot get the page to print in full size. This is necessary because I am printing a pattern and the size has to be accurate. I am not even given the option anymore to be able to do this. I did have the option before the reinstall. BTW the reinstall is because the computer crashed and I had to take back to factory settings. I appreciate any help given. Thanks.

pamw523
Welcome back to the HP Community Forum.
This may be helpful:
Manage Print Output with Print Preview
Assuming you have installed the Full Feature Software for the printer
and
Assuming that you have at least a recent version of Adobe Reader or Adobe software installed so you can download and open PDF files,
then
it may only be that the PDF print setup needs to be adjusted for the file prior to printing
See pages 5 and 6
You can also check
Print PDFs
===========================================================
Click the Kudos Thumbs-Up to say Thank You!
And...Click Accept as Solution when my Answer provides a Fix or Workaround!
I am pleased to provide assistance on behalf of HP. I do not work for HP.
Kind Regards,
Dragon-Fur

When I try to click on print in Mapquest and PDF documents I cannot get the popup to print the page

When I try to click on print in Mapquest and PDF documents I cannot get the popup to print the page when I click on "print."
I have to type the URL in Google Chrome browser and the print button works fine.
How can I get the print popup to work in Firefox 6.0?

My sister's 5s is having the same issue since yesterday.
Neither resetting via holding home+power buttons helped, nor the "reset all settings" in the settings. The only option left is erasing the iPhone and setting it up as a new phone ( or restoring from a backup?)

Psc 1350 prints text with shadow in Windows 7

My all in one psc 1350 prints the text with shadow since I upgraded to Windows 7, the buttons do not work, but the rest does, any suggestions about how I can correct the shadow issue?
I tried to upgrade the driver, but with no success

My guess would be this is due to a color cartridge with misdirected nozzles. Printing from PDF or a web page would print the text as a graphic which would use the color cartridge. Try the following: remove the color cartridge and print a page that previously was shadowed. Does it now print correctly? If so the issue is the color cartridge and running a cleaning cycle may help. It is also possible that the color cartridge has failed electrically, causing it to fire nozzles inappropriately. In this case a new cartridge would be required.
Bob Headrick, HP Expert
I am not an employee of HP, I am a volunteer posting here on my own time.
If your problem is solved please click the "Accept as Solution" button ------------V
If my answer was helpful please click the "Thumbs Up" to say "Thank You"--V

I cannot get my ipad to print using my wi if printer. It works with my computer

I cannot get my iPad to print with my wifi printer but it prints from my computer

Is your printer listed on this page as supporting AirPrint : http://support.apple.com/kb/HT4356 ?
If it doesn't support AirPrint then you could see if the printer manufacturer has their own app in the store which supports it (e.g. Epson have an iPrint app, and HP have an ePrint app). If not then there are third-party printer apps such as Print n Share and PrintCentral Pro which might work with it

I have a black box showing up on my desktop that I cannot get rid of which is preventing me from getting into Itunes. How can I get rid of it?

I have a black miniplayer box that has shown up on my desktop that I cannot get rid of that is blocking me from getting into ITunes.
How can I get it off ?

Reboot and see whether it goes away.

I cannot get the new mac mini to wake from sleep and trigger the displays - this is the second mac mini I have had and both have had the same issues. It worked before on my macbook extremely well...

I cannot get the new mac mini to wake from sleep and trigger the displays - this is the second mac mini I have had and both have had the same issues. It worked before on my macbook extremely well...
Using 2 displays, connected via HDMI and thunderbolt
Been on to support a number of times now - is anyone experiencing the same issues?

BUMP.
I actually showed this to Apple geniuses when I took my computer to the apple store, and it's still here. In console it says:
kernel[0]: Previous Shutdown Cause: -128
I don't know if that's related or not, but maybe helps?

I recently upgraded my 4s to a 5s. the verizon store took my old phone for a trade in. i cannot get any of my pictures to download from icloud. my photo stream folder only has a small percentage of the photos in it. any help would be greatly appreciated.

i recently upgraded my 4s to a 5s. the verizon store took my old phone for a trade in. i cannot get any of my pictures to download from icloud. my photo stream folder only has a small percentage of the photos in it. any help would be greatly appreciated.

That's possible if he didn't connect to a WiFi hotspot after taking them. I don't think the "Personal" Photo Stream uploads over Cellular, unless they changed it since the last time I used it.
If that's the case, then the photos likely didn't upload to Photo Stream and are stuck on the phone.
And you're not going to be able to get them back, either.

Text getting cut off when printing to PDF from Excel

Hello,
     I've seen a lot related to this subject but nothing that shows a real solution.
     Using Excel 2003-sp3 and Adobe Acrobat v.9 Standard, the right half of the last character in the string gets cut off. It prints from excel fine.
     It's not always the text that is the right-most on the page either. An affected PDF file is attached - note the cut off "S" on the last line (NET ASSETS OF GOVERNMENTAL ACTIVITIES).
     Any assistance is appreciated.
Thanks,
Kevin Murphy

please delete me from your mailing list. tks.
Date: Wed, 10 Feb 2010 11:20:28 -0700
From: [email protected]
To: [email protected]
Subject: Text getting cut off when printing to PDF from Excel
Hello,
     I've seen a lot related to this subject but nothing that shows a real solution.
     Using Excel 2003-sp3 and Adobe Acrobat v.9 Standard, the right half of the last character in the string gets cut off. It prints from excel fine.
     It's not always the text that is the right-most on the page either. An affected PDF file is attached - note the cut off "S" on the last line (NET ASSETS OF GOVERNMENTAL ACTIVITIES).
     Any assistance is appreciated.
Thanks,
Kevin Murphy
>

I just purchased an Iphone 4s and I cannot get my music to go onto it from my itunes, its version 10.1.1.4 any suggestions?

I just purchased an Iphone 4s and I cannot get my music to go onto it from my itunes, its version 10.1.1.4 any suggestions?

iTunes 10.6.3.25 - http://support.apple.com/kb/DL1575

I cannot get my iphone to print on 8500 officejet.

Just bought an Office Pro 8500A got it all set up but, cannot get my IPhone to find the printer. I have turn off the bluetooth, loaded the lastest software on the IPhone, turned off and on the printer, router, phone, and reset the WEP secure code on the printer for my wireles router. My compac laptop print wireless. Lost.

What router? Do not use WEP, it is not in the least secure. Switch your security to WPA with a 13+ character password.
Say thanks by clicking "Kudos" "thumbs up" in the post that helped you.
I am employed by HP

HT201335 I have just bought apple TV but i cannot get my TV to find the signal from my Ipad 2. I can access my MAC files and play those through home sharing but no streaming from my ipad. It as though the Apple TV is not receiving the signal. What am i mi

I have just bought Apple TV 2 and have followed all of the steps as directed. I have set up home sharing so I can watch the files from my MAC on the TV but I cannot get the airplay to stream my Ipad2 to the TV.
I cannot even get my Apple TV to recognise that my Ipad is even on the same network as it as it gives me no options or recognition that it is trying to send the data.
What have I missed to make my Ipad2 stream the screen image onto my TV...?
Frustrated am i with it...!!

I took a very quick look at the Owner's Manual for that Router.
Much of this you will already know....but:
1. Its a combination DSL modem/WiFi Router
2. It does not have ariel antennas. My experience, the WiFi tends to perform poorly compared to standalone WiFi units and the WiFi range is also limited thus slower the farther away you get (or Apple TV gets)
3. If you don't have a DSL filter infront of it I recommend using one, even if you don't use phones. DSL comes in the pair as a different frequency and its "probably" best to filter it out anyway.....even though it comes in on a dial tone and a dial tone often exists
4. Let me know who you ISP is and I will find out what other Routers they offer.
5. You can buy pretty much any DSL modem / Router online assuming it supports PPOe which most DSL ISPs use
6. If you have not in fact tried running an Ethernet Cable.....try it.....you can get a 100 footer locally for just a few bucks. It could solve a heart ache

I cannot get pages to automatically upload to and from the cloud and my iphone

just started using the icloud and itunes and iphoto work fine,
but
i cannot get my pages documents to "automatically sync" to the cloud and my iphone. the only way i have manged too do it so far is too cretae a document on the mac and then upload to icloud.com, if i make any changes on my iphone i then have to download the document from icloud.com to my mac.
also if i go to pages and log into iwork to open the document, it isnt there but it is shown in iwork through icloud.com??
any help will be very appreciated!
thank you

It has been discussed multiple times here: iCloud does not sync with iWork on the Mac - unfortunately. Let's hope this will be solved in the next iWork update

Cannot get HP C8180 to print from Windows XP

It prints fine in Lepoard, but cannot even set it up in Windows when I boot from mac using bootcamp.
I tried wired/wireless and it will not install any drivers.
Is this a bootcamp issue?
Thanks
Frank

Well, the only way I got this to work was using usb and plugging it into my airport express and then use bonjour. The network option did not work or wireless.
I ended up returning the C8180 and getting a MP970.
Frank

Cannot get computer to discover printer

Okay so a couple weeks ago I got an HP Officejet pro plus 8600 and have been having connectivity problems.
a bit of background
I have a macbook pro running 10.7.5
and a belkin n150 router
we also have an older desktop mac running snow leopard
Okay so from the beginning I was having problems getting the printer to actually print wirelessly. I was able to discover the printer by adding it to the print & scan under default. However at the time which was a few weeks ago it would give me the error message that it was offline and wouldn't print. Now heres the tricky part. I did something dealing with IP address that was recomended to me on an HP forum and it worked! That day I was able to print no problem.
A week later I open up my macbook and attempt to print and I am getting the same problem i.e. when I looked at the print que:
1. Menu says "looking for printer"
2. Menu says printing job 1% complete, barber pole scrolls
3. Menu says printer not responding
so I looked online for what to do.
I went to HP and followed the instructions from the link below.
http://h10025.www1.hp.com/ewfrf/wc/document?docname=c02205477&cc=us&dlc=en&lang= en&lc=en&product=4323648#N12058
Because it seems that the printer is connecting to the wifi, I deleted the printer from the que and restarted my computer. I then did a power reset on the printer.
Ever since I deleted the printer from the que I have not been able to discover anything at all when I click the + in the print and fax menu.

Thanks for replying. Just to claify, when we try to connect the iPod to the computer via usb, when using the usb cable that came with the iPod, nothing at all transpires. I check and the computer does not recognize the device. When using another usb cable she purchased locally, we get the notice that the device cannot be loaded. It will be a day or two before I get down to them, so just wanted to run this by you. In the meantime, I will try your suggestions.

Cannot get my PSC 1350 printer operating anymore from OS 10.6.3

Similar Messages

Maybe you are looking for