Canon ColorSync says RedBlueYelllow.icc is missing along with three others in CS6. How do I confirm and/or rectify the problem? Does it matter?

The summary pretty well sums it up. Don't know that it makes a difference, but I'm using an iMac running Yosemite.

I wasn't clear. I understand that ColorSync comes from Canon and is linked to its color management system for, in this case, its Pro 100 printer. My concern is that ColorSync apparently has found that four of 94 profiles are missing/bad. I'm a novice at this stuff, but it appears that the four are part of Adobe's Photoshop color management. So my questions are (1) does any of this matter and (2) if so, what do I do about it? Again, out of the 94 Sync looked at, the four specific problems are:
/Library/Application Support/Adobe/Color/Profiles/RedBlueYelllow.icc
   Tag 'pseq': Required tag is not present.
/Library/Application Support/Adobe/Color/Profiles/Smokey.icc
   Tag 'pseq': Required tag is not present.
/Library/Application Support/Adobe/Color/Profiles/TealMagentaGold.icc
   Tag 'pseq': Required tag is not present.
/Library/Application Support/Adobe/Color/Profiles/TotalInkPreview.icc
   Tag 'pseq': Required tag is not present.
Verify done - found 4 bad profiles.
Any info or help you can provide most appreciated. Thanks.

Similar Messages

HT1454 I have a speaker with I phone 30 pin dock, it use to work fine but i am not getting error saying accessory not supported,how i can determine what could be the problem

I have a speaker with I phone 30 pin dock, it use to work fine but i am not getting error saying accessory not supported,how i can determine what could be the problem
i am getting the same error with my rf transmitter that i use in my car

- Inspect the dock connector on the iPod for bent or missing contacts, foreign material, corroded contacts, broken, missing or cracked plastic.
- Did this start happening after an iOS update? Sometimes an iOS update will break compatibility.
Sometimes this works:
- Reset the iOS device. Nothing will be lost
Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Reset all settings
Go to Settings > General > Reset and tap Reset All Settings.
All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
- Restore from backup. See:
iOS: How to back up
- Restore to factory settings/new iOS device.

I updated to 3.6.15 and every time I open Firefox the Thank You for upgrading window pops up along with my normal homepage. How do I get rid of that?

I updated to 3.6.15 and every time I open Firefox the Thank You for upgrading window pops up along with my normal homepage. How do I get rid of that?

This link shows how to do that - https://support.mozilla.com/kb/Firefox+has+just+updated+tab+shows+each+time+you+start+Firefox

Itunes account is under a comcast address along with all my 800 tunes, my .me address is not connected to the music. how do I get itunes match to work for my iphone

itunes account is under a comcast address along with all my 8000 + tunes, my .me address is not connected to the music. how do I get itunes match to work for my iphone

U.S. Cellular does not unlock iPhones: iPhone: Wireless carrier support and features - Apple Support
Sell the iPhone to someone that wants to use U.S. Cellular, and use the proceeds to purchase an iPhone that is usable on the wireles carrier you prefer.

I'm new to Photoshop Elements and just getting started. While in the organizer I have one group of photos up to learn with and now it says Edit in Progress with a padlock icon. How can I remove this so that the photos will be restored to normal?

I'm new to Photoshop Elements and just getting started. While in the organizer I have one group of photos up to learn with and now it says Edit in Progress with a padlock icon. How can I remove this so that the photos will be restored to normal?

Go back to the editor and close the photo there.

My ipad2 says Apple won't allow Adobe Flash driver to load. How can I view and hear talking greeting cards?

My ipad2 says Apple won't allow Adobe Flash driver to load. How can I view and hear talking greeting cards?

IOS device do not support Flash
However Skyfire, Photon, iSwifter and Puffin Web Browser will provide limited Flash capability.

HELP I have lost all my motion 4 content from all the files, ive looked in all the files and they are all empty. can i get replacement content as I my dvds where stolen along. with my other laptop.

HELP I have lost all my motion 4 content from all the files, ive looked in all the files and they are all empty. can i get replacement content as I my dvds where stolen along. with my other laptop. any Ideas. would be a great help. For Motion 4.

Try a hard reset:- hold the home button AND the power switch - ignore the red "Slide to power off" and wait ubntil the iPhone powers down, and then restarts - at the Apple logo, release all the buttons and see if your contacts reappear.

HT4623 I'm trying to update my iPhone 5 to IOS 7 through iTunes. I get a pop up saying I need to update my iTunes to 11.0.5 before I can update my iPhone. The problem is my iTunes is current, and no update for iTunes is found. Any one have any suggestion

I'm trying to update my iPhone 5 to IOS 7 through iTunes. I get a pop up saying I need to update my iTunes to 11.0.5 before I can update my iPhone. The problem is my iTunes is current, and no update for iTunes is found. Any one have any suggestions?

I had the same problem. My phone wasn't finding it so I tried plugging it into my laptop and it said I needed the latest iTunes which I already had.... I unplugged my phone from my laptop and did a soft reset to my phone (hold down the lock button and home button at the same time until your phone turns off) once it turns back on you should find the update... Click general... Software update. Worked for me!

I am currently restoring my Ipod 5 however half way through recovering my ipod 5 iTunes say's "locked with a password unlock ipod etc... " and turns on the iPod and my iPod is still disabled what do i do?

I am currently restoring my ipod 5 however half way through re-covering my ipod 5 Itunes says "locked with a password unlock ipod etc..." and turns on the ipod and my ipod is still disabled...
what do i do??

Try and force it into Recovery Mode
1. Disconnect the USB cable from the device, but leave the other end of the cable connected to your computer's USB port.
2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to turn off.
3.While pressing and holding the Home button, reconnect the USB cable to the device. The device should turn on.
4. Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears, release the Home button. iTunes should alert you that it has detected a device in recovery mode. Click OK, and then click Restore to restore the device.
Note: Data will be lost. You may have to repeat the above many times.

Yesterday an update on software to get the facetime to work. It downloaded along with eight other updates an Itunes update now I cannot even get Itunes to open I am now completely frustrated

Yesterday I did an update on software to get the facetime to work. It downloaded along with eight other updates an Itunes update now I cannot even get Itunes to open I am now completely frustrated Now two applications are not working. Help

Hi,
I tried opening it from the application folder and nothing happens. I have tried from the dock and the same thing. Unfortunately this is not the application that I ws intending to work on. This was running perfectly fine for me. I have a lot of music on it. I know all is still there because I can see it through spotify. I started looking for help with Face time with came up with a needing proper credentials in order to open. Now neither open after a 9 an automatic download of nine updates. At this point I don't know what else to do.

I am now unable to print pdf documents. The message on screen says I have not selected any pages to print, even though the bullet point saying 'All' pages has been clicked. I have recently upgraded to adobe reader XI, could that be the problem? I also ca

I am now unable to print pdf documents. The message on screen says I have not selected any pages to print, even though the bullet point saying 'All' pages has been clicked. I have recently upgraded to adobe reader XI, could that be the problem? I also cannot sign in to Adobe Export pdf now either. It says 'error occured while signing in'!

Open Adobe Reader | Edit | Preferences | Documents: change View Documents in PDF/A Mode to Never.
Regarding the ExportPDF problem, please start a new topic in the ExportPDF forum.

Firefox freezes (along with any other program I might have running) a minute or two after I have started my session. After a minute or so, it's O.K.

Firefox freezes (along with any other program I might have running) a minute or two after I have started my session. After a minute or so, it's O.K. I have disabled all off my extensions and the problem still persists.

Hello Meg, the phone allowed me to stay on long enough to download a new app but then shut down the app centre and returned to the home screen.
Was there a specific "fix App" for this?

Creating that blur using my brush my entire image changes too and becomes blurry. Not only that but the area I painted also becomes over exposed. What can I do am I missing something here all I want is to blur a section and not change the rest of the area

Creating that blur using my brush. When I paint the area, which highlights in red, I bring the clarity down to create more of that blur but what ends up happening is that my entire image changes too and becomes blurry. Not only that but the area I painted also becomes over exposed. What can I do am I missing something here all I want is to blur a section and not change the rest of the area I am painted by automatically becoming over exposed. Does anyone else have this problem that can help me?

Quote
Do you think I should try to find a cheap mobo to OC my current CPU? How about trying to find one (mobo) used? I fear that my only realistic choice will be to scrap the CPU and eventually buy a new mobo and CPU, but as the CPU was only released just under two years ago I would value being over to overclock it with a cheap enough mobo to last me another year or so.
Who knows what additional problems may be run into by switching mainboards & such. The OS would have to be reinstalled fresh, etc. Money wise, it wouldn't make a lot of sense to invest more into a system that is rather outdated. The small performance gain making the switch to another board using the CPU you have, just doesn't really make much sense, especially if what you have now is completing the tasks asked of it. Save up some money, set it aside for a future build. There are plenty of new platforms in the works.

Cannot purchase songs on iTunes. After I enter Apple ID and password, Prompt says I need toed to verify my Apple ID. I enter my password again and never get the verification email.

Cannot purchase songs on iTunes. After I enter Apple ID and password, Prompt says I need toed to verify my Apple ID. I enter my password again and never get the verification email although my Apple ID and email are correct? Whats up with that?

from this support article:
How do I verify my Apple ID by email?
Simply follow the link in the verification email that says "Verify Now." Sign in with your current Apple ID and password, then click Verify Address. You can also verify by signing in at My Apple ID.

I still am having problems with Aperture not loading, It just refuses to work, and I get the message saying it has encountered a problem, and I may need to re-install which I have done dozens of times. The fix mentioned on an earlier post wont work as it

I still am having problems with Aperture not loading, It just refuses to work, and I get the message saying it has encountered a problem, and I may need to re-install which I have done dozens of times. The fix mentioned on an earlier post doesn't work as it is for Ver 10.6.6 and I am running 10.6.7

Do you have Final Cut installed on your machine?
If so, you may want to look at this article: http://support.apple.com/kb/TS3528
Let us know if that helps.

Canon ColorSync says RedBlueYelllow.icc is missing along with three others in CS6. How do I confirm and/or rectify the problem? Does it matter?

Similar Messages

Maybe you are looking for