CD is stuck and won't load or eject, what should I do?

I inserted a cd into my macbook and it won't load and won't eject. It just keeps making the noise like it's trying to load. I tried turning my computer on and off but that didn't help. Any suggestions?
thanks

Turn off your computer then on startup hold down on the trackpad.

Similar Messages

  • My Ipod nano 7th generation turned off and won't turn back on. what should I do?

    my Ipod nano 7th generation turned off and won't turn back on. what should I do?

    If you have done the reset and nothing appears and you are sure it still has a charge and it doesn't turn on, you may request for a replacement if it still covered by the warranty. Cheers!

  • HT4993 My iPhone 5 turned off and won't turn back on. what should i do about this?

    My iPhone 5 turned off and won't turn back on. what should i do about this?

    Hi SeanCam,
    Welcome to the Support Communities!
    The following article will provide some troubleshooting steps for this issue:
    iPhone, iPad or iPod touch: Not responding or does not turn on
    http://support.apple.com/kb/TS3281?viewlocale=en_US
    Cheers!
    - Judy

  • My iPhone 4 shut down and won't turn on again.What should i do?

    My iPhone 4 shut down and won't turn on again. I tried charging it and do it again...When i charge it , it opens the " Connect to iTunes" , when i switch to the computer to connect it , it doesn't work... It starts to the apple screen , and then just shuts down again. I tried holding the home and sleep/wake button at the same time..I tried everything. What should i do?

    Your iPhone is going back and forth between recovery mode and powering on which is really strange.
    Have you tried a hardware reset while its connected to your computer? This will force it back into recovery mode so that you can restore it. If restoring and setting up as new doesn't help, go ahead and take it to an Apple Store for a replacement

  • My New iPad (16gb   4g) went to sleep,and won't wake up! What should I do?

    What should I do? Pls Help!

    Assuming that the battery isn't empty (and it can take up to 15 minutes of charging before it will respond), then have you tried a reset ? Press and hold both the sleep and home buttons for about 10 to 15 seconds, after which the Apple logo should appear - you won't lose any content, it's the iPad equivalent of a reboot.

  • Iphone4s just died and won't turn back on, what should I do?

    Checking out apps on iPhone 4S and was about 50% battery then it just shuts down. I haven't been able to turn it back on. What should I do?

    Have you tried resetting your device by pressing and holding the Home button and power button until the silver apple appears? Put it on the charger for about 10 minutes first.

  • When I open iPhoto on my desktop, it just keeps spinning and won't go further.  What should I do?

    When I open iPhoto, the spinning icon just keeps spinning, and it won't go further no matter what I do.  I have rebooted, etc, with no luck.  Suggestions?

    details please
    What version of Photo? Of the OS? what has recently changed?
    You can try Back up your iPhoto library, Depress and hold the option (alt) and command keys and launch iPhoto - from the resulting first aid window repair permissions and if necessary rebuild your database
    LN

  • Ipod is frozen on song and won't respond to anything, what should I do?

    I have tried resetting and it is still frozen. I can't restore, because neither Itunes nor my computer will recognize it.

    You may need to let your iPod's battery run down fully. Then, after it is completely dead, let it recharge through a poewr source for 3 hours.
    Also, before you get into that, you could try this:
    1 - Connect your iPod to your computer.
    2 - Now begin to rapidly toggle the "Hold" switch back and forth while your iPod is connected.
    3 - After you've done that for a little while (for perhaps 15-20 seconds), eject the iPod if needed, then disconnect it from your computer.
    -Kylene

  • My iphoto will not load, all it does when i open it is just show a blank iphoto and won't load any of my photos that were already in there.

    My iphoto will not load, all it does when i open it is just show a blank iphoto and won't load any of my photos that were already in there. Any way to fix it ?

    Remember: we cannot see your machine. There are 9 different versions of iPhoto and they run on 8 different versions of the Operating System. The tricks and tips for dealing with issues vary depending on the version of iPhoto and the version of the OS.  So to get help you need to give as much information as you can. Basic things like :
    - What version of iPhoto.
    - What version of the Operating System.
    - Details. As full a description of the problem as you can. For instance: 'iPhoto won't export' is best explained by describing how you are trying to export, and so on.
    - History: Is this going on long? Has anything been installed or deleted?
    - Are there error messages?
    - What steps have you tried already to solve the issue.
    - Anything unusual about your set up? Or how you use iPhoto?
    Anything else you can think of that might help someone understand the problem you have.

  • When trying to download apps on my new iPad I keep getting prompted to update my security questions for my safety. When I choose this option it freezes and won't load the questions, however, when I hit not now it won't let me download. What do I do?

    When trying to download apps on my new iPad I keep getting prompted to update my security questions for my safety. When I choose this option it freezes and won't load the questions, however, when I hit not now it won't let me download. What do I do?

    Reboot your iPad and then see if you can set the security questions.
    Reboot the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider - let go of the buttons.

  • New Mini - Firewire plug is stuck and won't come out

    Hi,
    This is a virtually new Mac Mini; A firewire plug from my 20" Cinema display is stuck in the firewire port and won't come out. (I'm trying to disassemble this mini to move to another location.)
    I'm trying very hard not to pull too hard because I don't want to damage the firewire port. But I don't know what to do - it's just stuck and won't come out.
    Any ideas? Many Thanks,
    Frank B.

    Well, I finally got it out after fiddling with it, and walking away several times. I had to make sure I didn't damage it, so I approached it very gingerly.
    How did I get it out? It's amazing what actually worked. What worked was grasping ONLY the firewire chord about 1 to 2 inches away from the plug and pulling Only on the chord straight out.
    Doing it this way, it popped out with very little resistance. Strangely, the Apple Cinema Display firewire plug almost seems to click when you plug it in.
    So I immediately tested a generic firewire plug (non-Apple related) and it plugged in and pulled out with no problems or resistance whatsoever.
    "This completes my test of the Apple Cinema Display Firewire plug." (a joke there)

  • HT1222 I need some help.... I Have the iPhone 4S and downloaded the new software (6.0) and everything seems great so far except when I try to open a link in safari from a different app (messages, Facebook, ext..) it glitches and won't load. Any advice?

    I need some help.... I Have the iPhone 4S and downloaded the new software (6.0) and everything seems great so far except when I try to open a link in safari from a different app (ie..messages, Facebook, ect..) it glitches and won't load. The blue loading bar will just jump back and forth and the page will not load properly if at all....

    It sounds like you may have multiple problems, but none of them are likely to be caused by malware.
    First, the internet-related issues may be related to adware or a network compromise. I tend to lean more towards the latter, based on your description of the problem. See:
    http://www.adwaremedic.com/kb/baddns.php
    http://www.adwaremedic.com/kb/hackedrouter.php
    If investigation shows that this is not a network-specific issue, then it's probably adware. See my Adware Removal Guide for help finding and removing it. Note that you mention AdBlock as if it should have prevented this, but it's important to understand that ad blockers do not protect you against adware in any way. Neither would any kind of anti-virus software, which often doesn't detect adware.
    As for the other issues, it sounds like you've got some serious corruption. I would be inclined to say it sounds like a failing drive, except it sounds like you just got it replaced. How did you get all your files back after the new drive was installed?
    (Fair disclosure: I may receive compensation from links to my sites, TheSafeMac.com and AdwareMedic.com, in the form of buttons allowing for donations. Donations are not required to use my site or software.)

  • I have Safari 4.1.3 on a Mac OS X 10.4.11 and gmail won't load suddenly. What's up?

    I have Safari 4.1.3 on a Mac OS X 10.4.11 and gmail won't load suddenly. What's up?

    If possible you need to upgrade OS X. However, what you can upgrade to is dependent on what your Mac hardware and configuration is which you have not provided in your profile.

  • I'm now showing I have 9 updates in the App Store but when I click on updates it is blank and won't load. Tried to reset but didn't help. What now?

    I'm now showing I have 9 updates in the App Store but when I click on updates it is blank and won't load. Tried to reset but didn't help. What now?

    Try again later today or tomorrow. Other users are posting the same issue >  Apps update not working. Was before but...: Apple Support Communities
    The problem has been reported to Apple.

  • Pushed restore button with itunes and now it seems stuck and won't reinstall software

    Restore button was accidentally pushed while trying to install itunes and now it appears to be stuck and won't reinstall software.
    Please help

    Try restoring. Make sure you have a backup first.

Maybe you are looking for

  • Ctrl and fn keyboard shortcuts don't work after update

    After I updated today (list of updated packages below), all gnome keyboard shortcuts that use the ctrl or fn key stopped working completely. What could cause this? I've never had any problems with these keys in linux before and they all work out of t

  • How to use multiple tables in DRIVING_SITE

    Hi All, I see very bad performance with my query having dblinks to remote database. How can I use DRIVING_SITE for multiple remote tables here? Does it it useful to use on DRIVING_SITE multiple tables? What is impact of using ORDER BY on local table

  • How can I download Adobe Bridge? I do have a serial number?

    How do download Adobe Bridge? I have a Serial Number. Thank you F@@

  • JAXB Messing up my XML Signatures

    I have a requirement to sign an XML message. Currently our schemas (being ISO20022) have to have the XML signature located in a particular part of the message even though the signature is based on an XPath elsewhere in the message: (Ignore the fact t

  • Cannot find created Alert monitor in RZ20 being asigned to any moni context

    Dear colleagues! I have created my own monitoring object in rz20 (of virtual type). But I cannot see It in any so called monitoring contexts -> segments. Example: there is one monitoring segment on each instance: SAP_CCMS_<hostname>_<SID>_<ID> And se