Change the default "Test Pass" UUT Result message

Question

I’m still a Newbie to TestStand so if my nomenclature is a little off I apologize:
At completion of a sequence in TestUUT mode an automated banner pops up that can say “Test Sequence Passed”, “Test Sequence Failed”, “Test Sequence Terminated” and I think there is a Test sequence error one too.
In my particular application Test Sequence Passed, Test Sequence Failed and Test Sequence Terminated are a little misleading to the test station operator.
How do I go about changing these banner names? For example how do I get the banner to say Test Sequence Complete instead of Test Sequence Passed?
And Test Sequence Terminated to Test Sequence Aborted?

Answer 1

Hi,
I have attached an example (TS3.0).
In the example I have included in the sequencefile the override callback sequence PostUUT.
This is where the various banners are found. The code for the banner are found in the modelsupport.dll and you will find the complete project in ..\TestStandModels\ if you wish to modify this code. Remember to copy the folders from the \NI folder to the \User folder and modify the code in the \User folder.
As a simple example I have used a MessagePopup step type. with the same preconditions as the original step.
I hope this helps.
Regards
Ray Farmer
Regards
Ray Farmer
Attachments:
Sequence File2.seq ‏36 KB