Charger fell into glass of water what should i do now it wont work :(
Please Suggest
Seriously that is sound advice. You could save yourself a few dollars by taking it apart and drying it out but really cannot recommend that - throw it in the bin and buy yourself a new one. Its not worth risking it.
Similar Messages
-
i updated my iphone to ios 6. now i can not charge my phone with any cable. it says charging do not support this accessory. what should i do now? can anyone help please!!!!!!!
I upgraded my iPhone 4 last evening to iOS 6, the upgrade completed and the device was usable. Then in the morning I went to the device to check E-mail, Voice Messages, Test Messages, etc... and the phone was dead. I tried plugging the device into a charger (for a couple of hours) - still dead. Plugged into computer with iTunes, device not recognized or discovered, and iPhone was still dead... Took the iPhone into an Apple Store and the Technician looked it over for any visible signs of defect/malfunction, then performed various tasks to breathe life into the phone - nothing... His suggestion, at this point, was to replace the phone. He speculated that the iOS upgrade possibly corrupted the iPhone's charging firmware, and that this device was now a BRICK. Keep in mind that the phone and it's charging abilities were perfectly fine prior to the iOS Upgrade. I hate to go through the replacement hassle and the cost ($159.00) when the iOS upgrade caused the problem. Any suggestions? Thanks!
-
My ipod 5 will not charge. It died and now will not charge to turn back on. What should I do?
My Ipod 5 will not charge. It died and now will no charge to turn back on. What should i do?
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar
Also
Not Charge
- See:
iPod touch: Hardware troubleshooting
- Try another cable. Some 5G iPods were shipped with Lightning cable that were either initially defective or failed after short use.
- Try another charging source
- Inspect the dock connector on the iPod for bent or missing contacts, foreign material, corroded contacts, broken, missing or cracked plastic.
- Make an appointment at the Genius Bar of an Apple store.
Apple Retail Store - Genius Bar -
every time i connect my ipod touch 4th gen. it says this accessory is not supported by ipod touch so people recommended me to just buy a new charger, so i did, but the night before I got my new charger it stopped charging, what should I do now?
also my power button does not worked it got stuck so therefor it doesn't work, are there any ways i can help it get loose and working again?Not Charge
- See:
iPod touch: Hardware troubleshooting
- Try another cable.
- Try another charging source
- Inspect the dock connector on the iPod for bent or missing contacts, foreign material, corroded contacts, broken, missing or cracked plastic.
- Make an appointment at the Genius Bar of an Apple store.
Apple Retail Store - Genius Bar -
My iPhone 4S screen is suddenly not reacting. The screen has turned a light blue color but nothing is happening. I have tried several things such as holding the power button, plugging it into the wall, and plugging it into my computer. What should I do?
Sounds like the device was dropped at some point and damaged as a result.
Take it to Apple for evaluation and a replacement. -
i have an old apple 4s and have never backed it up (pictures and itunes). I have the usb plugged into my pc. what should i do next?
Hi Boulose,
Click on the device, and then on the Summary page to the right, click on Back up Now:
http://support.apple.com/kb/PH12325?viewlocale=en_US
Also, you are going to want to import your photos:
http://support.apple.com/kb/ht4083
Cheers,
GB -
HT201444 my iphone5 dropped water what should I do
my iphone5 dropped in the water what should i do
Turn it off
Put it in a zip lock bag with dry rice for 5 to 7 days
Then try to turn it on
Be prepared to make an appt at an Apple store to get it replaced
Water and electronics don't mix well -
so today my ipod touch 4 gen ios 5.1.1 stopped responding to touch and then it got really hot and died so i try to charge it... nothing happens. what should i do?
retrojustin wrote:
...and then it got really hot and died so i try to charge it... nothing happens. what should i do?
Call Apple. -
I was downloading some songs when I lost my internet connection. There is no sign that these songs reached my iTunes but i have been charged for these songs anyway. What should I do?
It's possible that the message you got was to update the AirPort Express Base Station's (AX) firmware...and that something might have gone wrong during the upgrade.
Let's start by performing a "factory default" reset on the AX to get it back to it's original "out-of-the-box" condition.
Then, let's set it up to work with your cable modem...
AirPort Express Base Station Setup (AX) w/High-Speed Cable Modem
Modem/Router Power ReCycling (optional)
- Power-off the Cable modem, AX, & computer(s). (Wait at least 30 minutes. If possible, leave the modem off overnight.)
- Power-on the Cable modem; Wait at least 30 minutes.
- Power-on the AX; Wait at least 5 minutes.
- Power-on the computer(s)
Setup the AX
With the network components powered down, set up the AX, using the AirPort Admin Utility, either connect to the AX's wireless network or connect your computer directly (using an Ethernet cable) to the Ethernet port of the AX, and then, try these settings:
AirPort tab
- Base Station Name: <whatever you wish or use the default>
- AirPort Network Name: <whatever you wish or use the default>
- Create a closed network (unchecked)
- Wireless Security: Not enabled
- Channel: Automatic
- Mode: 802.11b/g Compatible
Internet tab
- Connect Using: Ethernet
- Configure: Using DHCP
- WAN Ethernet Port: Automatic
Network tab
- Distribute IP addresses (checked)
- Share a single IP address (using DHCP & NAT) (enabled)
Do not, at this point, set up any security (i.e., WEP/WPA encryption, closed network, etc.) to first make sure the AX is operating properly. Try to access the Internet wirelessly with your MacBook. If you're successful, go ahead and add any security features you wish. -
Apple charge me twice for the bill when I order usb cable and power adapter, what should I do now ?
Apple charge me twice for the bill when I order usb cable and power adapter, what should I do now ?
they charge me separated for the cable & adapter , and charge 51.36$ for the full bill !!!
order number *****
<Edited by Host>Apple Store Customer Service at 1-800-676-2775 or visit online Help for more information.
To contact product and tech support: Contacting Apple for support and service - this includes
international calling numbers.. -
Okay, so my iphone 4s will not charge at all. I been charging it on my windows laptop, and it just stopped charging. even on the wall. What should I do? Help.
Wow long time ago to find a thread...
Hold the power and home button while connected to your computer for 10 seconds. Then release JUST the power button and continue holding the home button and iTunes should recongnise the device in recovery and then hit restore and iTunes will proceed to wipe the phone and restore to the latest iOS your device can go too. -
Hey, my iPhone 5 gets switched off on its own. Couldn't switch it on immediately. Have to put it for charging and gets switched on... What should i do now for this??? when evr i go out this is one big problem i get... Couldn't use my fone.... Have to wait until i go back home...
Start here www.apple.com/ca/support/ or call 1-800-263-3394.
-
hi,
i am using 10.7.5 lion there are a lot of problems in this OS.
like most of the programs quit's unexpectedly. some programs does not work on it. like adobe cs5 is not working. everytime time when i do click on adobe cs 5 icon it shows a message "To open “Adobe Photoshop CS5,” you need to install a Java SE 6 runtime, but you are not connected to the Internet.To install a Java SE 6 runtime later, open “Adobe Photoshop CS5” again" while i always remain connected on the net.
2. when ever i insert an avi or mpeg video disk it shows the file format not recognized. to **** with this macbook pro n its 10.7.5 lion. the same disk works/runs on windows on windows systems.
plz somebody help me what should i do now.
[email protected]it sounds like a fualty installation of Lion, this may happen from time to time.
The best thing to do in this situation is to reinstall Lion. You will not loose anything doing this, but you should always keep back ups of your information.
http://www.apple.com/osx/recovery/
basically hold Cmd+R on boot..
first go to disk utility, verify and repair your disks and permissions. Exit out of Disk utility and then go directly to "reinstall Lion"
choose that and let it reinstall.
Adobe CS6 does need Java to run.
To play your movies you might need to get an application called VLC. VLC is a free app and will play most videos and music files you throw into it.
http://www.videolan.org/vlc/download-macosx.html
you have a 64bit intel mac, so get the one for that. -
I've just installed iTunes on my Windows 8.1 (64-bit) laptop, but i can't open it. It keeps telling me that Apple application was not found. What should i do now?
For general advice see Troubleshooting issues with iTunes for Windows updates.
The steps in the second box are a guide to removing everything related to iTunes and then rebuilding it which is often a good starting point unless the symptoms indicate a more specific approach. Review the other boxes and the list of support documents further down page in case one of them applies.
Your library should be unaffected by these steps but there is backup and recovery advice elsewhere in the user tip.
The section Install missing components has advice on breaking down the iTunes installer into the individual .msi files which might prove useful if AAS won't install normally.
tt2 -
i want to unlock my ipod with a computer that i am using using now i have synced it with a pc which is now in another country , so what should i do now ?
Connect the iOS device to your computer and try to make a backup ( I doubt you can)
iOS: How to back up
Then restore via iTunes. The iPod will be erased. Place the iOS device in Recovery Mode if necessary to allow the restore.
If recovery mode does not work try DFU mode.
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
For how to restore:
iTunes: Restoring iOS software
To restore from backup see:
iOS: How to back up
If you restore from iCloud backup the apps will be automatically downloaded. If you restore from iTunes backup the apps and music have to be in the iTunes library since synced media like apps and music are not included in the backup of the iOS device that iTunes makes.
You can redownload most iTunes purchases by:
Downloading past purchases from the App Store, iBookstore, and iTunes Store
Maybe you are looking for
-
Hi, When we try to execute a workbook in Bex Broadcaster we get the following error Settings TESTING were started from the BEx Broadcaster Processing for user AMURTHY, language EN Processing setting TESTING Precalculation server was
-
hi, i am triggering IDoc to XI from my report in ABAP. when i am filling the control record in the report , the value for the RCVPRN i.e receiver partner should be determined from the partner profiles and should not be hard coded in the report. how d
-
Template definition for multiple topics.
Is there a way to define a template to be used for a large number of topics? I have a project with more than 1000 topics and I'd like to use the same template in all or most of them. I'd rather not have to do it on a topic by topic basis.
-
I have been trying to create a multicam clip from two camera's. They sync properly when using the sync feature but not when I use the multicam feature does anyone know what I may be doing wrong?
-
Lost bluetooth when my HP Envy 17t-j000 Quad was repaired
When my PC arrived in July it had a "Intel(R) Centrino(R) Wireless-N 2230" card which supports Bluetooth 4.0. Unfortunately, it's WiFi didn't work so I sent the PC in for repair but when it came back a "Qualcomm Atheros AR9485 802.11b/g/n WiFi Adapt