[Cisco FAQ] - Do I load new CODE and LICENSES to the RFGW1?

I would like to know where I can find the latest code

All new code and licenses are loaded to the RFGW1 via a FTP server on the same network as the chassis. A laptop can also be used (if plugged direct) and the interface settings are in the same network as the gateway. The laptop must be running a simple FTP server.
Settings for the FTP server are locatred at the bottom of the page.  Click "show FTP settings".

Similar Messages

Maybe you are looking for

  • How do i find and move all files across multiple disks

    I just purchased a 2010 Mac Pro and wanted to set it up with a clean install of Mavericks.  I installed a new SSD as my boot disk and did a clean install of Mavericks on it.   All good so far. Now from my previous Macs I have several disks (internal

  • Can one transfer music to itunes from ipod on new computer

    How does one transfer music from ipod to itunes on new computer?

  • How To Disable Verify Database Message Alert

    How To Disable Verify Database Message Alert? I have a VB6 open Crystal Reports using Crystal Reports XI R2 (SP5) and almost every time I open a report, I get an alert message about the table has been changed and I have to click "Ok" to make it goes

  • Multiple invoice with one Debit note

    Dear Experts, Is it possible to create one single debit note with multiple invoices. If yes how. Thanks Shri..

  • Copy Billing plan

    Dear Experts, Can any one explain the process of Copy billing plan from sales order to project automatically. Is their any configuration required. Regards Chandra