Cisco Flex Connect and users can not get IP Address by WAN

Hello my name is Ivan
I have a wlc 5508 with license base to 50 aps, i use a deployment flex connect. I already registered all my access points, I use web authentication to authenticate users guest, and the service dhcp is in the central site.
My issue is the users in each remote site, can not get an ip address by dhcp from the central site, they can authenticate in the guest ssid, but any users can not get an ip.
The request is passing by the wan in this way
Central Site DHCP - Router WAN - Remote Site - Users with notebooks. I use flex connect central deployment (all the traffic consulting to the wlc) .
perhaps i should use local deploy? The wlc is in the central site.
Can you help me to resolving this issue please? , perhaps any advice?
Regards
Ivan.

Thanks Osita
If I configure Central Authentication and I configure central switching I need to create a dynamic interafce for each remote site and each dynamic interface associated with a different VLAN ID, because I can not associate a single interface dynamic to the same VLAN ID, but in my case the client remote in each remote site have the same network segment with the same VLAN ID with the same SSID for guests. My goal is to configure web authentication with the local DHCP server at each remote site, will this work?.Each remote site have its own server dhcp.
If I configure authentication central authentication with central switching with web authenticacion as I set in my scenario?
My issues are the interfaces dynamics, because I have the same network to the customer guest with the same ID VLan in each remote site
Regards

Similar Messages

Bought a new Ipod touch and the WiFi does not connect. Tried Reset and total Restore, does not connect to Router on DHCP, tried Static manually and still can not get it to connect even though it registers as connected.

Bought a new Ipod touch and the WiFi does not connect. Tried Reset and total Restore, does not connect to Router on DHCP, tried Static IP, Subnet, Router and DNS manually and still can not get it to connect even though it registers as connected. Using Airport for router, latest firmware, no problems with Iphone 4 or Macbook Pro or any other internet devices. After total Restore (factory settings) tried again, showed connected to router, but does not display "check" next to router but little rotating icon even though the wifi range signal shows connected at full strength and it says it is connected. Just can't seem to get it to generate an IP. Any solutions other than turning it on and off again? Not a Merry Christmas morning.

Ok, so, a couple of things: Denisefromwaleska and I have the exact same size/type/color iPod. Now wishing I'd bought the black one maybe...
Second, Airport is an Express and I have a second one that I carry with me when I travel. Tried to connect my Airport Express to the internet and could not although the iPod did recognize the router and tried to connect to the internet for some time, unlike my previous problem. Updated firmware on my travel router, still could not connect to the internet. Going to try to set up a manual Static IP on the travel router here in a few and conect through it although I predict the problem will persist. Back on the Christmas Present Airport Express router, it is back in play and working fine for all devices save the iPod.
Thanks again for all your help, hopefully I can get a solution in place soon,

I have a toshiba lap top computer with vista and I can not get my iphone to connect all the way .. it says "connected with limited activity"?

I have a toshiba lap top computer with vista and I can not get my new iphone to connect all the way .... it says "connected with limited activity". which means I don't get on. Any help would be appreciated. Thanks.

Hi all,
Guess I understand what is going on as I'm also experiencing the problem.
Basically the issue is about the iPhone 4's personal hotspot.
I'm trying to hook on personal hotspot to my toshiba laptop but it couldnt work as the connection is limited to local only without Internet access.
The hotspot works well on other laptop and I-devices, but not my toshiba...
Hope to get assistance here. Thanks

I bought an audiobook in itunes on my pc and I can not get it to push to my iphones. Do I physically have to connect to itunes to get the audiobook on my iphone?

I bought an audiobook in itunes on my pc and I can not get it to push to my iphones. Do I physically have to connect to itunes to get the audiobook on my iphone?

Audiobooks are currently a one-time only download, so if you're asking whether you need to connect the iPhone to your computer's iTunes (if that is where you've downloaded it) in order to get the audiobook on it then yes, you will need to sync it the phone, you can't re-download it on the phone.

I have purchased the VGA Connectors for both a iMac and Macbook Pro so that i can connect my promethean board projector to the computer and I can not get the image on the screen. Does anyone have any suggestions?

I have purchased the VGA Connectors for both a iMac and Macbook Pro so that i can connect my promethean board projector to the computer and I can not get the image on the screen. Does anyone have any suggestions?

Irelandbound wrote:
thank you, I have the adaptors so glad that would work. I just heard adaptors burn out often. So Just thought for my main iMac computer, a plug would be best. I will get one once I move.
Any other suggestions or things I should know about apple products in Ireland. I know there are no Apple stores there.
An adaptor doesn't burn out. It merely serves as a means to connect the power prongs on your device to the power supply.
I believe you are thinking of a transformer, which you do not need. A transformer converts one voltage to another.
You don't need to do that as the power supply of modern electronics can take almost any worldwide voltage.
Look at the label on the device. It should indicate the input power acceptable of 100-240 VAC, 50-60 Hz.
Additionally, I found the adapters cheaper in the UK than I found them in the US. They were available in most supermarket chains. I wasn't in Ireland, so I can't say one way or the other.
If you have something that doesn't have that input power spec, it would require a transformer.
On other items like electric clocks or things with motors, you can connect them up to a transformer and the voltage will be correct, but the frequency may not. For clocks, that will cause them to not keep time well. For motors, they will burn out.

Extend Wireless Network using a Telstra technicolor Gateway wireless Router to Airpot extreme but Airport will only except join not extend and I can not get a network on the Airpor Extreme ethernet ports but can ping Airport extreme from Technicolor Rout/

Extend Wireless Network using a Telstra technicolor Gateway wireless Router to Airpot extreme but Airport will only except "join a wireless network (which it does) not "extend a wireless network" (Led turns yellow and I can not get a network working on the Airpor Extreme ethernet ports but can ping Airport extreme from Technicolor Router.
Airport gets it address DHCP.

Funny how I can ping the Extreme but the Hard Ethernet ports dont seem to work correctly.
When the AirPort Extreme is configured to "Join" a wireless network, the Ethernet ports are not enabled.
Oddly, the AirPort Express has a special feature that will allow it to to "Join" virtually any wireless network.....and the Ethernet port can be enabled. So, an Express would work for your purpose to provide an Ethernet connection to the media player. This assumes that the Express is located where it can receive a strong wireless signal from your main router.
Note that the Express will not provide any additional wireless coverage when it "Joins".

My time capsule is blinking orange and I can not get it to stop. I have done a hard reset and unplugged it but it continues to blink orange. This all started because the time capsule stated it was delayed in backing up so I thought I would try to reset.

My time capsule stated that it was delayed in backing up so I decided to do a hard reset on the time capsule. Now I am getting a blinking orange light and I can not get it to go back to green. I have had to hard wire the modem into my computer for connection. I need some help please. Thank you.

Assuming it is not simply broken, a slowly flashing LED probably means the TC is not receiving an IP address from the modem. Make sure you power down your modem whenever you change what is connected to it.
Having to unplug the Ethernet cable from the TC and plugging it in to your Mac repeatedly so that you can communicate is tedious enough, but endeavor to add the power cycle exercise to that action.

HT4539 my ipad is disabled and I can not get it to open my main screen

my ipad id disabled and I can not get it to open my main screen, how can i regain access to the product

If it's showing the red disabled screen then you will need to connect it to the computer that you normally sync to and you should then be able to reset the iPad and restore/re-sync your content to it (http://support.apple.com/kb/HT1212) - you may need to put the iPad into recovery mode : http://support.apple.com/kb/ht1808
If you do it via a different computer then :
If you restore on a different computer that was never synced with the device, you will be able to unlock the device for use and remove the passcode, but your data will not be present.

HT4352 How can I get Home Sharing turned on my Apple TV if I have lost my remote control and my remote apps on my ipad and iphone can not get access to my apple tv, only my itunes.

How can I get Home Sharing turned on my Apple TV if I have lost my remote control and my remote apps on my ipad and iphone can not get access to my apple tv, only my itunes.

You can't, you will need to get a new remote.

My apps. ended up on my computer and I can not get them back onto my iphone.

I have purchased many apps. as well as ringtones. In the last day or so I have upgraded to io5, synced by phone with my pc and now found that most of my apps. are on computer and i can not get back to phone.

Qualdog-12 wrote:
My friend deleted some of my apps from settings as a prank, and I can't get them back by using the App Store.
if they are no longer in the app store, you can not get them back.

I have recently upgraded to mountain lion and I can not get the calendar application to work. I con appears on the side put on calendars. Any suggestions

I have recently upgrades to Mountain Lion and I can not get the calendar utility to come alive. Icon appears in the tast bar but the application does not launch or appear to be any where else. Any suggestion?

Did you look in the Applications folder for Calendar? If it is there, remove the item that is in the Dock and replace it by dragging the Calendar application to the Dock.
If it is not there, did you have iCal located somewhere other than the Applications folder when you upgraded?

I bought two HD movies and I can not get either one of them to play...help please?

I bought two HD movies and I can not get either one of them to play...help please?

What have you tried?
What happened?
Error message?
Any info?

I had a crash of the mac 10.4.11 after I restarted my comp the google toolbar vanished and i can not get it back it does not install ((( all my bookmarks are there

I had a google toolbar on my 3.6 firefox for at least one year . After my Mac crashed and I restarted everything it vanished and i can not get it back I tried to reinstall it does not work and when i go to add ons it tells me it is not available for 3.6 Firefox All my bookmarks re there (((

Yup, your question and Diane's answer helped me also. Tho' I had had problems before getting into the iTunes store I always managed to find a way. Today they had me blocked cold with the "Update to 10" advert no matter what I did. Other questioners are being told, incorrectly as it turns out, that they have to update their OS to accomodate iTunes 10 and upgrade to iTunes 10. I did the download which did not take up much more room on my crowded old hard drive and now I'm back in business.

I was wondering how to get my background back? it just quit on me one day and I can not get it back, I was wondering how to get my background back? it just quit on me one day and I can not get it back

I was wondering how to get my background back? it just quit on me one day and I can not get it back, I was wondering how to get my background back? it just quit on me one day and I can not get it back

explain further please...
Is this your problem?
Program, Utility, Desktop picture, Screensaver won't open or save changes
https://discussions.apple.com/docs/DOC-3046
https://discussions.apple.com/community/notebooks/macbook_pro?view=documents

My apple Id has been disabled. I have relogged on changed password and still can not get it to work on my Iphone

My apple Id has been disabled. I have relogged on changed password and still can not get it to work on my Iphone

Contact itunes support. Click Contact Us at the bottom of this page.

Cisco Flex Connect and users can not get IP Address by WAN

Similar Messages

Maybe you are looking for