Cisco spa phone and '*' in the number
Hello.
I am set the phone dial plan (x.), but if i am enter the number ex:'45*' then phone show message "invalid number".
How am i call to the number with "*" in middle?
Try this Dial-Plan:
(xx*|x.)
Regards.
Similar Messages
-
If I want to take my old iPhone and swap the number from my wife's phone to it so she can use it for her phone how do I do it?
With AT&T it's ridiculously easy.
Create backups for each device
Log out of iCloud Apple ID
Erase all content and settings
Power off the devices
Change the SIM
Power on the device
Configure with the appropriate Apple ID
Finally, dial 611 to let AT&T know what iPhone should answer to what number. -
I reseted my ipone and removed the number how can i get it back
i reseted my ipone and removed the number how can i get it back
Two solutions come to mind:
Use your phone to call someone, and have that person use Caller ID to tell you your phone number.
Contact your cellular carrier. Here's how: Contact a mobile carrier -
My Kids were playing with my phone and now the majority of my contacts don't show up. If I use Siri, my phone will find and call the number even though it is not showing in my contact list. How do I restore my contacts?
Call mum and dad are in the contact of yourself.
You have to manually add it back or if you have contacts in your computer addressbook, you can sync them back. -
Recording for Cisco IP Phones and Cisco C90 Codec
Hello
We are looking for a solution that is capable to record both Cisco IP Phones and Cisco Codec C90.
We are using CUCM 9.X for IP Phones and VCS 7.X for Cisco Codecs.
Is their any third party solution available for both the requirements or do i have to go with TCS and any other third party recording solution.
Thanks & Regards
Aniket PatilMy reply may be too late to be of any help to you, but for the benefit of others:
Be sure you understand the different types of PoE out there. The Linksys PoE switch only supports the newer IEEE 802.3af PoE standard.
The 7940, 7960, 7905 and other older Cisco phones only support Cisco pre-standard PoE and thus will not work with the 802.3af Linksys Switch.
To use this switch, you will need to make sure you are using the newer 7070, 7961, 7941 phones with support both pre-standard and 802.3af PoE.
All the best,
John -
I lost my phone and used the iphone locater to find it. Now that it has been returned to me, it is disabled and says connect to ITUNES. Can you help me ?
Does the link below help?
Forgot passcode for your iPhone, iPad, or iPod touch, or your device is disabled - Apple Support -
cannot send or receive yahoo mail or gmail from iPhone . installed ios 6 recently. tried rebooting the phone and deleting the email account and adding again but nothing works ! can someone suggest a solution?
Not sure about yahoo, but for gmail, I done the following:
Set up using Exchange on iPhone, it'll keep prompting for password. On PC use captcha option, log in to gmail account from PC after completingg captcha option, enter password on iPhone.
See how that goes for gmail, let us know.
Hopefully someone will have fix for yahoo. -
I have bought an used Iphone 5. I dont have the password for the existing login id of the old owner. How do i use the phone and change the log in id?
Unfortunatly the only way that you can get it off is to get the old user to input the password. You may need to contact that old user and see if he can put the old password in. hope this helps.
-
I am having a big problem. I am not getting notifications from snapchat and only snapchat. I've made sure every notification setting was on and it just won't work. I have also restored my phone and deleted the app and re-downloaded it multiple times. It just wont give me my notifications. Help please.
Go to Settings > Privacy > Location Services.
Turn off SnapChat.
Go to Settings > Notification Center
Turn off SnapChat.
Restart the device.
Go to Settings > Privacy > Location Services.
Turn on SnapChat.
Go to Settings > Notification Center
Turn on SnapChat.
Test the issue. -
I purchased an audiobook from iTunes On my iPhone. I got a new phone and after the back up, the books I downloaded were not there. iTunes wants me to repurchase the books I downloaded. Is there a way for me to Redon load my already purchased books?
Hi..
On your new iPhone tap Settings > Store.
Make sure Books is turned ON.
You shouldn't need to re purchase the book > Downloading past purchases from the App Store, iBookstore, and iTunes Store -
My boyfriend and I share an iTunes account. I just tried to update his phone and during the update an error message occurred saying that his phone had to be reset to factory settings. It said it was an un setup phone and needed plugged in to iTunes. With no other choice, we had to select reset to factory settings. Now, my phone backup through iCloud downloaded onto his and all of his contacts and photos were overridden by mine. His photos were in process of transferring from the phone to the pc while this occurred and over 900 of them were complete when this happened. They don't show up on the pc now either since the sycn wasn't finished. Is there a way to get them back? When we plug his phone in now it shows my name instead of his so I'm not sure how to get to an old version of his backups even.
Error -1 indicates a hardware issue with the device.
Read here > http://support.apple.com/kb/TS3694
The device should still have warranty but unfortunately any service needs to be done in the US.
Warranty check > https://selfsolve.apple.com/agreementWarrantyDynamic.do
Is it possible for you to send the device home and have a family member take it to the Apple Store? -
Need to know how to get my apple account to sync up with a new email on my phone and delete the old one in a step by step process??
After you change the account settings as I described below hold your finger on any app until they all wriggle, then tap the "-" on each purchased with her Apple ID. Press the HOME button when done. Then go to the App Store and buy or download the apps you want.
-
ok, so I transferred my 3S info to my 4S by restoring from an old phone backup. But SIRI is gone and god knows what else?? Can I get my old stuff into the new phone and keep the 4S new functionality?
I suspect unless he had some items in iCloud backup then they are gone. Connecting an iPhone to a different library from that to which it was previously connected will result in the device asking if you want to erase it.
-
How can I play songs from an album in order on my iphone 4? The shyuffle is turned off both on the phone and on the device when I sync the phone with my iMac but it continues to shuffle. All the songs in the album have been checked in iTunes.
Bill, you ignorant moron. Turn off the ultra secret hidden shuffle diabolically placed behind the album cover. Just tap the album cover to expose the sinister little shuffle icon on the right. Is it blue? Well, tap it until it is no longer blue! Also, make sure you are in your playlist and not the genius playlist.
Hope this helps! Now, who's ready for ice cream? Or do you want to "shyuffle" some more, you weirdo?!? -
can no longer find my music and apps on itunes and when i try to sync it tells me its going to erase all that is in my phone and sync the new itunes which has nothing in it
See Empty/corrupt library after upgrade/crash or
Recover your iTunes library from your iPod or iOS device.
tt2
Maybe you are looking for
-
Bootcamp missing after Yosemite upgrade
So I had OS-X Mavericks installed and a Windows 7 Bootcamp partition. Now I've installed OS-X Yosemite and I’ve run into a problem. Here are the steps I took: First, I resized partitions manually using Disk Utility to even up the space a bit. Install
-
I've purchased too much iCloud storage for my I pad and wish to downgrade within the 14 day period in order to get a refund, how do I achieve this feat?
-
Oracle 10g FRM-41051 on a non-database text item with a LOV
Hi all, I'm struggling with a problem I'm convinced must have a really simple solution, but for the life of me I can't figure it out! I have a data block called query. It is a non-DB block with a number of items, with either LOVs or drop down lists.
-
Hi Experts We have maintained new P exchange rates ( USD >> AUD)yesetday with validity form October 2009. During the costing run today we've noticed that the activity types are not consideriing the latest rate for calculation (completed KP26 with pe
-
Revision: 12295 Revision: 12295 Author: [email protected] Date: 2009-11-30 13:41:29 -0800 (Mon, 30 Nov 2009) Log Message: fix for FLEXDOCS-889, and add doc on the WindowedApplication.useNativeDragManager property QE notes: - Doc notes: - Bugs: