Click on the the emal on my iPad2 e opens blank and it does not respond to touch, it worked perfectly until this morning. All the settings are the same ed and correct
when I click on the email on my iPad2 the page opens blank and it does not respond to touch. It worked perfectly until this morning, I did not change the settings everything else is working good. Any idea what to do to sort this out will be very much apriciated.
Please help!
Try a reset. Press & hold the Power and Home buttons together for 10+ seconds, ignoring the red power-off slider, until you see the Apple logo.
Similar Messages
-
I connected my sons Ipod Touch to my pc and it worked fine. Now, when I try to connect my iPad the following message comes up: One of the usb devices attached to this computer has malfunctioned, and Windows does not recognize it. For assistance in solving this problem, click this message.
I checked the cable. It surely is not the cable. If I connect the iPod again it works fine. If I use the same cable with my pc and ipad at work or my other son’s laptop, it is working perfectly. It is only on my laptop where the iPod was connected. Something tells me it got something to do with the drivers that went corrupt or something when I connected the iPod.
I searched the internet and I see a lot of people gets this message. Still no solved answers yet. Is there a place where I can download the drivers again or any other suggestions?
Windows 7 and iPad 2
Kind regards,I was hoping it would be something like a USB device conflict, but now the shuffle is the only thing connected...
This article was one of the ones you linked to above in your initial post
http://support.apple.com/kb/TS1369
Under Part 9. Verify that USB drivers are installed, did you try the steps in If only "Unknown Device" appears? That appears to be your situation.
Also, you said that the shuffle initially worked well enough to do a sync, then it had the same problem again. If you can get it to work again initially, before doing anything else, try the following. Select the shuffle in the iTunes sidebar, under DEVICES. Over to the right, go to the Summary tab. By default, the checkbox for Enable disk use should be unchecked. If so, check it and Apply the change. See if that makes any difference.
(If Enable disk use was already checked, try unchecking it and Apply the change. Basically, set it the "other way" and see if there is any improvement.)
NOTE: When disk use is enabled, you have to eject the iPod in iTunes before disconnecting it physically.
If the disk use change makes a difference, that may provide a clue about the actual cause. -
Using iPod shuffle 4th generation for first time and receiving the error : one of the USB devices attached to this computer has malfunctioned, and windows does not recognize it. For assistance in solving this problem, click this message.
Using win 7 and latest iTunes [10.6.3]. Have already gone through below links and did not find any solution.
http://support.apple.com/kb/HT2292
http://support.apple.com/kb/TS1369
http://support.apple.com/kb/HT1923
http://en.kioskea.net/forum/affich-17997-ipod-not-detectedI was hoping it would be something like a USB device conflict, but now the shuffle is the only thing connected...
This article was one of the ones you linked to above in your initial post
http://support.apple.com/kb/TS1369
Under Part 9. Verify that USB drivers are installed, did you try the steps in If only "Unknown Device" appears? That appears to be your situation.
Also, you said that the shuffle initially worked well enough to do a sync, then it had the same problem again. If you can get it to work again initially, before doing anything else, try the following. Select the shuffle in the iTunes sidebar, under DEVICES. Over to the right, go to the Summary tab. By default, the checkbox for Enable disk use should be unchecked. If so, check it and Apply the change. See if that makes any difference.
(If Enable disk use was already checked, try unchecking it and Apply the change. Basically, set it the "other way" and see if there is any improvement.)
NOTE: When disk use is enabled, you have to eject the iPod in iTunes before disconnecting it physically.
If the disk use change makes a difference, that may provide a clue about the actual cause. -
hello
The problem appeared two days ago is that I can't open my mail app. everything was fine and functional. Now I double click on the icon and it does not respond. it receives mail and I can see push notifications on the mail icon but when I try to open it is no use. OS Y 10.10.2 (14C1514)Please follow these directions to delete the Mail "sandbox" folder.
Back up all data.
Triple-click anywhere in the line below on this page to select it:
~/Library/Containers/com.apple.mail
Right-click or control-click the highlighted line and select
Services ▹ Reveal
from the contextual menu.* A Finder window should open with a folder named "com.apple.mail" selected. If it does, move the selected folder—not just its contents—to the Desktop. Leave the Finder window open for now.
Restart the computer. Launch Mail and test. If the problem is resolved, you may have to recreate some of your Mail settings. Any custom stationery that you created may be lost. Ask for instructions if you want to preserve that data. You can then delete the folder you moved and close the Finder window.
Caution: If you change any of the contents of the sandbox, but leave the folder itself in place, Mail may crash or not launch at all. Deleting the whole sandbox will cause it to be rebuilt automatically.
*If you don't see the contextual menu item, copy the selected text to the Clipboard by pressing the key combination command-C. In the Finder, select
Go ▹ Go to Folder...
from the menu bar and paste into the box that opens by pressing command-V. You won't see what you pasted because a line break is included. Press return. -
After updating iTunes this week Windows 8 recognizes the iPod but does not offer an option to open with iTunes. iTunes does not recognize iPod Touch. Have followed all the steps but without success. Is there a solution with iTunes?
I followed all the instructions on the suggested page. Many files in C:\Program Files\Common Files\Apple\ and C:\Program Files (x86)\Common Files\Apple\ could not be deleted. Message said ""Cannot delete files: It is being used by another person or program"' but could not find iPodService.exe in task manager (also, the "Cannont delete ... " did not mention iPodService.exe).
Deleted all that I could. Reinstalled iTunes. Still same result. iTunes and computer both recognize my old iPod. Only the computer recognizes iPod Touch. -
I bought a used iPhone and found him email iCloud does not affect me so how can I deleted this email in order to use the device freely and privacy
help me pleaseYou can't. Return the phone for a refund, if you can, because without the previous owner's Apple ID/Password, you will not be able to re-activate the phone. It will be useless to you.
Apple can't/won't help you with this. -
My iPhone 4S ios5 has suddenly stopped letting me connect to any wifi. The wifi line in settings has gone grey, reads 'no wifi' and does not respond to touch. How do I get reconnected?
HI there,
You may want take a look at some of the troubleshooting steps found in the article below.
iOS: Wi-Fi settings grayed out or dim
http://support.apple.com/kb/ts1559
Hope that helps,
Griff W. -
I have a problem in the security question I hope a solution as soon as Lee does not respond change ÓćÇá Secretariat
Welcome to the Apple Community.
Start here (change country if necessary) and navigate to 'Password and Security', reset your security questions using the link provided, you will receive an email to your rescue address, use the link in the email and reset your security questions.
If that doesn't help, you don't receive a reset email or you don't have a rescue address, you should contact AppleCare who will initially try to assist you with a reset email or if unsuccessful will pass you to the security team to reset your security questions for you.
If you are in a region that doesn't have international telephone support try contacting Apple through iTunes Store Support. -
Apple iPAD 2. Needs password to unlock iPAD; however there is a permanent keyboard displayed on the screen that does not respond to touch. iPAD switches on with button but does not turn off using it at moment. Can you help please?
Try a reboot by holding both the power and home buttons until the apple logo appears, ignore the red slider if that appears. See if that clears the glitch.
-
wi-fi in settings does not respond to touch, page becomes frozen and i have to out from it with home button. can not choose network or anything on that screen!?
noelani72 wrote:
I'd be curious to go buy an old Linksys WRT54G Wifi Router and see how the iPads work on it....but my lord, I have already spent so much time on this issue as it is.
Message was edited by: noelani72
Unless you get that WRT54G for free or next to free, pass on it and pick up an old apple WAP off eBay or similar site. Like you my iPad has a connectivity problem with the WRVS4400N running iOS 4.2.1, where it didn't have trouble with iOS 3.2.2 and ran fine for five months.
My solution at the office was to spur a second router off my DSL router just for the iPad. The first was a WRT54G that had to be set to only one 802.11 protocol to keep the iPad reliably connected, but swapped it out for an old airport extreme that I kept on after testing it to be good. With a home network like you describe, I would run a subnet off the WRVS4400N just for iPad using an apple WAP (the configuration app for Windows is easy to use).
Good luck. -
Problem: my iPhone 4S (1yr old) has started buzzing for no apparent reason. I cannot stop it or turn the thing off. The screen is black and does not respond to touch. Any suggestions?
Thanks, AM_Kidd, I had tried that before but I tried again and this time it WORKED!!!!
The buzzing stopped and I have the home screen up again.
Phew! It may be that it had been on charge for the last 30 mins.
Whatever. Again, many thanks. -
I have areas of my iPad screen that does not respond to touch. Is that normal? The areas are random and not always in the same place. Is there anything I can do to fix this problem?
Have you tried rebooting it by holding the home and on button until the Apple logo appears?
-
So my iPhone 4S started draining battery after recent update, battery got changed and it worked perfect for 3 days, all of a sudden the phone shut down and now won't stay on unless connected to mains... Claims its at 100% battery but thats impossible as it was at 30% before it shut down randomly.
Cannot receive any signal "searching" constantly.
Turns off as soon as removed from usb ... wont stay on connected to laptop!
HELP!The iPhone includes a one year warranty. If an Apple store is not nearby, you can call AppleCare and handle an exchange under warranty over the phone. The exchange will be shipped to your door - someone must sign for the delivery so if no one will be at home, have it delivered where you work. You use the same box to return the existing iPhone back to Apple. Return shipping label and tape to reveal the box incuded - call the carrier with number incuded when the box is ready to be picked up. AppleCare will request a credit card in the event the existing iPhone is not returned within 10 days after the exchange under warranty is received.
Hardware can fail - it happens, which is why there is a one year warranty. -
I am no longer receiving my mail. All my settings are the same and I can send mail. The connection doctor says I am connected, but I am no longer receiving anything. If you can help, I would appreciate it. Keep it simple, please.
-
My iphone went blank and when I plugged it into outlet the screen shows the itunes logo and a picture of what looks like the charger. I tried to reset it and it does not respond. Can anyone help?
That screen means it has gone into recovery mode. You need to connect to a computer running iTunes by following the instructions in http://support.apple.com/kb/HT1808 for the procedure of recovery mode connection.
Maybe you are looking for
-
REMOTE RECORDINGS OVER THE WAN IN CCX 7
We have a customer with CCX 7 local agents and recording services ( BUT NO QUALITY MONITORING) Normally records all local agents calls ( colocated with CCX. Now customer has remote agents via WAN and needs to record their conversations. According spe
-
Hello. We are implementing the opportunity management scenario in CRM 5.0. We are using the action profile for the sales assistant. We would also like to triger the actions from the item level. I have found so far that no action profile can be assign
-
SMB Network Share Access slow (MAC OS X SL and Windows 2008 Server)
Hi, I've added some iMacs with 10.6 to the Active Directory. This works totally fine. Anyways, I have some trouble, when accessing shares on my network. I found out, that some problems came up, because my network name was XXX.XXX.local I changed the
-
Hi, I bought my Nokia N8 two days ago and have noticed that when i view the screen from an angle the background colours and white text on the home screen look really crisp but when viewed from front on it has a sort of cream look to it like the white
-
Probably a fundamental design question
Hi, I am modeling a standalone java application ( this is an interface between two systems ). I need to have an error report object that should be made available to all other objects. Basically for each run of the application there needs to be only o