Color crashed after render. How do I reconnect files?

Question

Hello,
I have a large film project that I left rendering in color overnight.  When I opened it today the program crashed.  I opened Color again and none of the renders are connected.  I can see the render files though in a folder on the desktop.  Is there a way i can re connect them so I don't have to wait another eight hours for it to do it again like you can in final cut?
thanks!

Answer 1

Okay - I started with a DV-NTSC Quicktime File on "Drive A." I imported this file into FCE, and dropped it into a sequence. The file needed to be rendered (to DV Stream I assume), which took most of the day (18 minute movie). The render of course went into the "Render Files" folder on "Drive A."
Then, after finishing the project on the road, I moved the rendered file and the original Quicktime DV-NTSC File over to the drive I normally use for FCE Projects ("Drive B"). To be specific, the project name was called "RF-FINAL," so I took the folder named "RF-FINAL" out of the "Render Files" on "Drive A" and Moved it to the Render files on "Drive B."
I then reassigned my Media Drive in System settings from "Drive A" to "Drive B," opened the project, and relinked the media. The project had no problem relinking the music (aiff) files, but for picture and dialogue (rendered from the DV-NTSC Quicktime original) FCE asked to relink the media to the ORIGINAL QUICKTIME FILE, not the rendered (DV Stream) file that it had taken all day to create. I am unable to figure out how to make FCE point the Original Quicktime FIle to the rendered file it created. Does that make sense?
When I try to drag the rendered file from the "Render File" folder into the project, I get all sorts of error messages.
Any ideas???