Computer goes to sleep and ipod won't charge

when i leave my ipod connected to charge overnight, it only ends up charging the 20 or so minutes before the computer goes to sleep - how do i correct this?

Absolutely.
I suggested this as a workround for those who (like me) wish to keep the option to sleep when not in use. It prevents one having to change settings every couple of days to charge an iPod. Simple and elegant, like all computer fixes should be
JC

Similar Messages

  • Internet goes stale after computer goes to sleep and then needs to be rebooted to function properly

    I mac with retina 5k display
    internet goes stale after computer goes to sleep and then needs to be rebooted to get it working again
    10.10.1 os

    Please read this whole message before doing anything.
    This procedure is a diagnostic test. It’s unlikely to solve your problem. Don’t be disappointed when you find that nothing has changed after you complete it.
    The purpose of the test is to determine whether the problem is caused by third-party software that loads automatically at startup or login, by a peripheral device, by a font conflict, or by corruption of the file system or of certain system caches.
    Disconnect all wired peripherals except those needed for the test, and remove all aftermarket expansion cards, if applicable. Start up in safe mode and log in to the account with the problem. You must hold down the shift key twice: once when you turn on the computer, and again when you log in.
    Note: If FileVault is enabled in OS X 10.9 or earlier, or if a firmware password is set, or if the startup volume is a software RAID, you can’t do this. Ask for further instructions.
    Safe mode is much slower to start up and run than normal, with limited graphics performance, and some things won’t work at all, including sound output and Wi-Fi on certain models. The next normal startup may also be somewhat slow.
    The login screen appears even if you usually login automatically. You must know your login password in order to log in. If you’ve forgotten the password, you will need to reset it before you begin.
    Test while in safe mode. Same problem?
    After testing, restart as usual (not in safe mode) and verify that you still have the problem. Post the results of the test.

  • Computer goes to sleep and doesn't wake up

    Hi, I have an external hard drive (Western My Book), every time that the computer goes to sleep or I do it myself the computer doesn't wake up, I have to restart, I already used disk warrior, any suggestions? Thank you.

    never mind, I changed the connection to a different usb port and problem solved. Thanks anyway.

  • Had an iPhone 4 updating the OS when it was interrupted by the computer going to sleep and now is frozen on "plug into iTunes" screen.  Home/Power button combo will not reset, iTunes does not acknowledge the phone is plugged in.

    I recently upgraded to the 5s, so I delegated my old iPhone 4 to a music player/daughter checking instagram and email.  Three days ago I plugged the iPhone 4 into iTunes to update it, the OS began updating.  During the update my computer went into sleep mode, interrupting the OS update.  Now the phone will not do anything but show the screen with the graphic indicating to plug the phone into iTunes.  I've tried a hard reset (holding down power button/home button), plugging the phone into iTunes before/during holding down the home button, holding down the buttons for various lengths of time in various permutations according to info I've found online, etc, and nothing happens beyond a brief showing of the Apple logo and then back to the same screen.  iTunes will make a connection noise when the phone is plugged in but otherwise makes no indication that a device is plugged in (no iPhone button in the tool bar, etc.).  Any ideas or do I need to take it to an actual Apple store and hope they don't tell me it is completely bricked?

    Yep, done all that.  Repeatly.  Don't get any sort of recovery mode message or the phone showing up on iTunes at all.  iTunes is most current version, all diagnostics show everything fine, and it works fine with my current phone.  Just....nothing.

  • What do i do if my Ipod wont turn on? I was using it and it just turned off. My computer wont recongize it and it won't charge. It was perfectly charged before.

    what do i do if my Ipod wont turn on? i was using it and it turned off. My computer wont recognize it. It was perfectly charged before and I can't turn it on.

    Try holding down the on/off and the home buttons at the same time until you see the Apple logo. 

  • My computer goes to sleep and is almost impossible to wake up

    I have a HP Pavilion HPE  with windows 7
     After it goes to sleep you can hardly get it to wake you havve to shake and shake mouse and hit the space bar finally it wakes up. Is there a setting to correct this

    SMC reset.
    DALE

  • I installed OS Lion on my late 2009 Macbook and now I am having issues with WiFi.  When my computer goes to sleep my mac won't recognize my WiFi and I need to use the network assistant EVERYTIME to get on the internet.

    Very frustrated as my Macbook has been freezing a lot especially when streaming video online or sometimes just by being on a website with a lot of flash.  I've updated all my software and I have 4 gigs of ram.  I do have most of my 250 gig hard drive used up....coud this be an issue?

    Very frustrated as my Macbook has been freezing a lot especially when streaming video online or sometimes just by being on a website with a lot of flash.  I've updated all my software and I have 4 gigs of ram.  I do have most of my 250 gig hard drive used up....coud this be an issue?

  • I'm using a late 2006 2.33GHz imac.I clean installed 10.6 from disc then updated to 10.7 from download.Now every time my computer goes into sleep it won't wake up.Anyone know how to cure this problem please??

    I'm using a late 2006 2.33GHz imac.
    I clean installed 10.6 from disc then updated to 10.7 from download.
    Now every time my computer goes into sleep it won't wake up.
    The only way it will restart is to pull the mains lead out of the imac, put it back and try until it will start.
    This only happened after reinstalling.  Only Apple OS was on the imac and so it must be an issue with the software I believe.....
    Anyone know how to cure this problem please?
    Thanks
    paul

    This isn't a fix, more a workaround I used when I had wake from sleep problems that lasted from some point in 10.6.x, through 10.7 and into 10.8 (got fixed for me in 10.8.2). It seems to be connected with Bluetooth failing to wake up properly:
    System Preferences>Energy Saver and set 'computer sleep' to 'never'.

  • HT3964 My MacBook Pro i5 Dual Core has a hardtime waking up when the computer is put to sleep and only when it goes to sleep and has been asleep for a while. The indicator light flashes on and off for a while and then freezes. I've done an SMC reset once.

    Does any one have the same problem with their MacBook Pro i5 Intel Dual Core?  If the computer goes to sleep (not the screen) and is asleep for a while, when I try to wake it up it doesn't respond. I have to power it downn and restart it and sometimes it takes two or three attempts. Otherwise it works fine. I upgraded the memory to 8 GB. That is the only alteration doen to it. I've performed one SMC restart and now it wakes up  but it takes a while and a gray screen shows up. When I insert a DVD it won't start automatically I have to start the application in order to see it. Any suggestions?

    http://www.apple.com/support/macbookpro-videoissues/

  • My iMac 27 2010 vintage goes to sleep and won't wake up...I have to push the on off button and hold till it shuts down and then re start...This is not good..Help please

    My mac iMac 27 2010 vintage goes to sleep and won't wake up till I hold the on off power button....Then I have to restart as it is locked up....This it intermittent..
    Help Please
    Jim

    Ops I replied to myself in error.....
    Tom:
    I performed the steps indicated but this morning when I clicked the mouse and hit the space key and clicked the track pad again as before nothing happens.
    I hold the power button for a few seconds and the screen fills as if the computer was normally awakened but it is locked up.
    Then I have to shut it down with the power button  and then power it up as a reboot.
    Not good...SMC reset didn't work....Throughout the day yesterday I put the computer to sleep and woke it up normally.  It seems to be a overnight problem.
    Am I going to have to shut it down everynight?
    Jim

  • IPod Classic auto ejects from iTunes after computer goes to sleep on Mountain Lion

    I posted the following a few days ago in the Mountain Lion as I am suspecting the OS has something to do with it, but got no replies so I thought it might be good to post this here too in case this issue would be familiar to some of you.
    I usually have both a 160gb iPod Classic (original) and a 16gb original iPod Touch plugged into my computer and connected to iTunes, so I can listen to tracks from the devices straight through iTunes. This has worked very well for years, but since upgrading to Mountain Lion, every time the computer wakes up after going to sleep when I haven't used it for a little while, iTunes ejects my iPod Classic, and I have to replug it, but it doesn't do it with the iPod Touch. This never used to happen before, and is a tad annoying when it happens recurringly through the day.
    I have also noticed that, if the iPod is ejected, it seems to erase the play count for the tracks I was playing prior to the computer going to sleep. This is no major issue, but it seems a bit odd.
    I initially thought that this was happening on my work iMac but not at home (both running the latest versions of Mountain Lion and iTunes), but it does in fact happen on both computers. This behaviour only started when I upgraded to ML, and although it could be a coincidence, I think it may have something to do with it.
    I am using the latest version of iTunes.
    Can anyone help with this please?
    Thanks

    Hi there,
    Thank you for your reply, that's much appreciated. In a way it makes me feel slightly better to know that it's nothing to do with my iPod, although it is quite frustrating. Don't Apple QA their products before releasing them anymore? I've had quite a few issues with ML since installing it. I understand you get bugs with new products, but that would be one quite easy to identify I'd think. Oh well, I'll have to suffer this like everybody else until Apple get it sorted.
    Once again, thank you.

  • Screen goes to sleep and won't come back on - how to fix?

    My 2009 MacBook screen goes to sleep and won't come back on. It just stays black while the computer is still running. This just started happening one day for no apparent reason. Anyway to reconcile?

    When you post for help, please state which OS X is installed.
    If you aren't sure, click About this Mac from your Apple menu 
    Troubleshooting advice can depend on that information.

  • Is itunes store down its 9:36 date is saterday march 24 and im trying to download a app and up date a app and after it goes to sleep and i come back on to my ipod touch 4th gen it make me type in my pass word so basicly its not donlading

    is itunes store down its 9:36 date is saterday march 24 and im trying to download a app and up date a app and after it goes to sleep and i come back on to my ipod touch 4th gen it make me type in my pass word so basicly its not donlading

    Can't connect to the iTunes Store
    Best Fixes for ‘Cannot Connect to iTunes Store’ Errors | iPad Insight

  • My computer is going to sleep and wont wake up by touching keyboard or mouse. I have to use the power button

    Can anybody help? My computer is going to sleep and I cant wake it(bit like a teenager) by using the mouse or keyboard. I have to use the power button. Any ideas?

    Hmm, that support link doesn't like me.
    Do you have the discs that came with the computer? If so, put Install Disc 1 into the combo drive and boot up while holding the C key. Does anything show up on the screen? Do you hear the fan running? When running from a CD or DVD, the fan usually runs at a fairly fast pace and should make some noise.
    Keep in mind that you have a 1-year hardware warranty with any new or refurbished Mac, so if something has gone wrong, you should be able to have it replaced free of charge, unless the MacBook shows some form of damage.
    ~Lyssa

  • I was just listening to my iPod nano and it stopped working. I plugged it into the computer to sync it and it won't sync. The little light don't come on on my nano. I've turned it off and on, pushed the play/pause and nothing. Can anyone help me out here?

    I was just listening to my iPod shuffle and it stopped working. I plugged it into the computer to sync it and it won't sync. The little light don't come on on my nano. I've turned it off and on, pushed the play/pause and nothing. Can anyone help me out here?

    How long have you left the iPod to charge? It can take up to 30 minutes before it shows any signs of life. Did you use the instructions in this article to properly reset the Shuffle?
    Resetting iPod shuffle
    B-rock

Maybe you are looking for

  • R/3 upgrade from 4.7 to ECC 6.0 and BW upgrade from 3.5 to 7.0

    Is there a reason to upgrade Solution Manager from 3.2 to 4.0 when upgrading R/3 from 4.7 to ECC 6.0 and BW upgrade from 3.5 to 7.0? And when in current situation Unicode UTF8 is used, could that give problems during / after the upgrade?

  • The Iphone available in france on appel store?

    Hello, (I'm sorry, I don't speak english very well, because I'm french) According Appel, the Iphone would only be available in France on November 29. But visiting the site, we saw the french could buy from this page: http://store.apple.com/Apple/WebO

  • How do I get rid of face shine using Final Cut Pro 7?

    The interviewee's face is very shiny. I've tried lowering the whites and mids with no luck, and I don't have photoshop. Any suggestions?

  • WAD: maxwidth for analysis item

    Hi all, I'm trying to limit the number of columns displayed in the WAD <b>dynamically</b> based on the surrounding web-item (containerlayout, screen, etc...).  I can limit it statically by BLOCK_COLUMNS_SIZE but this is not what I want, I would like

  • Is there a API in flex to validate given IPV6 input is valid?

    Hi, I am trying to validate the given IPv6 input is valid or not. Is there an API available in flex which will help in doing this? Thanks