Connected to internet, but can't find server.

I have an 8gb 1.1.4 software. I have a wireless router in my house and I entered the password correctly, it says I am connect in the corner but when I go to Safari it says can not find server.

Exact same issue as my daughter had with her 1G Touch. Tried all suggestions found in this forum since mid-summer, and no luck. She sent it in to Apple for a replacement, and same thing with the new one. She has DSL with a modem/router from her provider and a Linksys wireless G, and her HP laptop connects wirelessly with no problems. We spent an afternoon trying different modem/router and Linksys settings and no help. I finally called her provider and complained that not only was the iPod touch unable to connect, but neither could the PS3, Wii, or Nintendo DS. They immediately OK'd a switch out of her Westell DSL modem/router with a new Zone. Everything now connects with no problems.
This is probably not your solution, but, boy, it sure worked for her.

Similar Messages

Can connect to internet, but can't find other computers in my network.

I have two macs that connect to the internet via an Airport Express unit (which is setup to connect to the internet using DHCP and share a single IP address using DHCP/NAT). My problem is that the macs cannot seem to find each other in the network.
How do I setup the network so that I can share the internet connection between both macs and at the same time connect from the one mac to the other? Is that even possible with an Airport Express unit?
I have two more Airport Express units. Can I configure one of those to act as the local network bridge (or whatever the technical term for that is)
I really just want to get all my macs to talk to each other, but I cannot for the life of me figure out how All help would be greatly appreciated!

Never mind... I'm stupid... File Sharing was off... d'oh! It all works now

I'm connected to Internet but can't connect to app store?

I'm connected to the Internet but then can't connects to app store. Why is that?

Did any one set restriction to App Store?
Settings>General>Restrictions

Can connect to Internet but can't open any web pages

Hi there helpers, I was on my iMac this morning and everything was fine. I could open any browsers and it could load pages very fast, but after I downloaded and tried to install Xquartz ( recommended by apple) I went on my browser again any tried to open Facebook but it didn't work all it said on the browser was NO DATA RECEIVED. I thought it was only Facebook so I tried google but it wasn't, it was all of the websites. So I'm not sure if I've accidentally downloaded a virus or malware. By the way I use google chrome to do the things above but I did do it again in safari. Thanks

Make a New Location, Using network locations in Mac OS X ...
http://support.apple.com/kb/HT2712
10.7 & 10.8…
System Preferences>Network, top of window>Locations>Edit Locations, little plus icon, give it a name.
10.5.x/10.6.x/10.7.x instructions...
System Preferences>Network, click on the little gear at the bottom next to the + & - icons, (unlock lock first if locked), choose Set Service Order.
The interface that connects to the Internet should be dragged to the top of the list.
10.4 instructions...
Is that Interface dragged to the top of Network>Show:>Network Port Configurations.
If using Wifi/Airport...
Instead of joining your Network from the list, click the WiFi icon at the top, and click join other network. Fill in everything as needed.
For 10.5/10.6/10.7/10.8, System Preferences>Network, unlock the lock if need be, highlight the Interface you use to connect to Internet, click on the advanced button, click on the DNS tab, click on the little plus icon, then add these numbers...
208.67.222.222
208.67.220.220
Click OK.

Connected to Internet but can't Browse-Right out of the Box!

Hello, I am having trouble loading web pages when connected to the internet via wireless (LAN works fine). My network sharing center says i'm connected to the internet and when i troubleshoot it finds no problems. Occasionally the google or youtube homepage will load, but no more than that. An error message is never displayed either, the web page simply loads forever until i close out of it. Something odd I've noticed is that, if i cut the wireless on my laptop off then back on, I have around 30 seconds of browsing freedom--everything works; however, after that it returns to endless load times. All the other laptops in my house have no issues with the wireless. Anyways, I've looked for solutions all over the internet and none have fixed this problem. I just received my Lenovo t530 yesterday and this was a problem right out of the package. I hope someone can help.

Peytizzle,
Try changing the Channel in the wireless router and see that helps. Also do you have those "N" router? Can you try using only a/b/g?
Also if you have Channel set to "Automatic" can you try setting it into 1 channel only rather than leaving it in Automatic.
Let us know
Thanks
*Non Lenovo employee*
I have a Y2P (i5) ... Feel free to ping me if you want me to test some applications with your Y2P if you have the same model. I don't mind keep doing recovery on it if needed .... =)

Desktop not connecting to Internet but can use wif...

I have bt hub attached to my desktop which is not allowing me to connect to the Internet.
But all the time the wireless devices are still working.
I have phoned bt and they say that my computer is not connecting to the hub and I may need to replace the computer or it will be a shop job.
I am desperate for any help as I have a final exam next week and the practice papers are all interactive on the Internet!!
If anyone has any ideas I would be very grateful!! Thanks.....
Solved!
Go to Solution.

I'd read something like this - http://pcsupport.about.com/od/fixtheproblem/ht/updatedriverxp.htm
If this fails, I may blow the dust off my XP PC and take a look at mine as it's been such a long time since I've updated it, I've forgotten myself!
-+-No longer a forum member-+-

IMac won't connect to internet, but can on internal network

Hi,
I've tried resetting the router and various other things that I found on the internet. I know its not a router problem as I am using my MBP to post this discussion. It won't even connect to the router's internap page. Any thoughts?

With the iMac failing to open any web page outside of your network, then I would be checking the DNS setting in System Preferences > Network > Wifi > Advanced. Compare what you have here to what the MBP has set.
But with the iMac also failing to connect to the routers internal web page then you've got additional problems beyond DNS. Using the MBP as a reference, if you make a note of the TCP/IP network settings in the Advanced section as shown above, is the iMac using the same? (apart from the IP address which should have the last number set to a different value).

Connected to the internet but browser says 'can't find server'

Hi,
I have an Apple Airport Extreme and it has been working well for a long time. My husband and I both run our internet connections from it wirelessly. Recently, when we go to connect to the internet, the browser says 'Can't find Server' but the Airport status bar says we are fully connected to the internet with a strong signal. I have no idea what happened or what is going on. The only thing that we have done differently is update the firmware on both our computers, and it seems as if this problem has started around that time. Any suggestions would be greatly appreciated. Thanks
April

It might be a good time to perform a complete power recycle of your network components to make sure they are "talking" to each other properly and see if this resolves the problem.
Please try the following:
o Power-down the modem, AirPort Extreme Base Station (AEBS), and computer(s); wait at least 15 minutes. Order is not critical.
o Power-on the modem; wait at least 10-15 minutes.
o Plug-in the AEBS; wait at least 5-10 minutes.
o Power-on the computer(s).
Can they access the Internet now?

Can connect to internet, but software can't find base station

I bought the Airport express a few months ago to use with my stereo and IBM laptop. It took me a few tries to get it initially installed properly, but eventually did and everything worked great. A month or so ago I noticed that the tab to select "remote speakers" was not on my iTunes as it had been before. All of the settings were correct on my iTunes however so then I went to the AirPort Utility to check out the settings and the program said it could not find the base station. I tried to find the station on AirPort Set-up assistant. This program can find it but not connect to it (on the first page after the menu it shows the base station and when I hit "next" it can't connect to the station). All of this is really odd as I have internet access through this base throughout these problems. Any ideas what might be happening and how to fix it? I have reset the base station to factory settings numerous times, I have unplugged everything and restarted the whole process numerous times, I even left the base station unplugged for a week to let it relax. Still nothing works. I can connect to the internet through the station but can not find the station.
IBM T40 Windows XP Pro

Thanks for your help. I can manually connect to the internet but I can't figure out how to get iTunes to recognize that there are remote speakers as my computer can't recognize my base station. Is there a manual way to do this?
IBM T40 Windows XP Pro

Can't access weblogic server from internet but can from intranet

Hopefully this isn't the wrong place to post but I've searched through many many
newsgroups to figure out where to post this but can't find a specific enough one.
I've recently run into a problem with my weblogic server in that it can not be
accessed from the internet now. This was all working several weeks ago, when
I had the wl server listening for SSL communications on port 7002. I could access
the server from both within our corporate intranet (kind of) as well as access
it from the internet. I say kind of for the intranet in that when I chose to
setup SSL on the the wl server, I couldn't get port 7002 to communicate through
our proxy server. After a little research I determined that it would be best
to communicate on the default SSL port of 443. After switching to 443, I didn't
need to bypass the proxy any longer, when accessing from within intranet, but
now couldn't access the server from the internet. The wl server is behind a firewall,
but I had the network administrators open up port 443 on the firewall. They ran
a network sniffer and determined that the wl server is sending a TCP FIN packet
immediately following the last ACK packet in a TCP session establishment. I don't
really understand what that all means, but it seems really strange that everything
works great when inside the intranet and I don't get any TCP FIN packets sent
from the server, but when you try to communcate through the firewall you do.
Does anyone have any insight into this issue? something else I could look at.
The network administrators are basically saying it's the webserver that needs
configuration (even though it worked great in the past when listening on port
7002 instead of 443). PLEASE HELP!!!

Got it. This thread helped!
Thanks!
https://discussions.apple.com/thread/3193444?tstart=60

Airport express connects to internet, but not print server

hello all. i hope someone can help me with this. 2 days ago, my wife was able to print using her ibook/airport expess setup. today, the network diagnostics has this message: "network diagnostics was able to connect to the internet but not to the server EPSON Stylus CX3800.pdldatastream.tcp.local. this could be caused by problems with the server, or an internet problem between this computer and the server." she says this happened when she turned it on. what could be causing this? any and all help welcome. mcrat

You can reset the AirPort Express (AX) following the directions in Resetting an AirPort Base Station or Time Capsule FAQ.
Then you can use AirPort Utility on your computer to configure the AX.

Safari and mail will not load but i am connected to internet and can download form itunes and other sourses is that HD failure?

Safari and mail will not load but i am connected to internet and can download form itunes and other sourses is that HD failure? any suggestions ? verify disk says its OK

iOS 4: Updating your device to iOS 5 or later - Support - Apple
iOS: Unable to update or restore - Support - Apple
iTunes for Windows: iTunes Store connection troubleshooting
See if any of these three may help.

I have an ipad2 and we purchased an HP office jet 6600. I can not connect to print. In searching the net, I have been advised to get the firmware update but can not find it. Can you advise?

I have an ipad2 and we purchased an HP office jet 6600. I can not connect to print. In searching the net, I have been advised to get the firmware update but can not find it. Can you advise?

Is the HP on the airprint list?
iOS AirPrint Printers http://support.apple.com/kb/HT4356
How to Print from Your iPad: Summary of Printer and Printing Options
http://ipadacademy.com/2012/03/how-to-print-from-your-ipad-summary-of-printer-an d-printing-options
Print from iPad / iPhone without AirPrint
http://ipadhelp.com/ipad-help/print-from-ipad-iphone-without-airprint/
How to Enable AirPrint on a Mac and Use Any Printer
http://ipadhelp.com/ipad-help/how-to-use-airprint-with-any-printer/
 Cheers, Tom

HT2495 I have a wirless network. I connect all my computers to it and a printer. I can print wirelessly from all computers. I tried to add the printer to my new Macbook, but can't find the printer on the add printer and scan icon on preferences.

I have a wirless network. I connect all my computers to it and a printer. I can print wirelessly from all computers. I tried to add the printer to my new Macbook, which is connecte to the network, but can't find the printer on the add printer and scan icon on preferences. I downloaded a installation printer utility from the Manufacturer (lexmark), but it didn't work. Any sugestions?
Thanks,
Ivette

You would need to get the IP address of your printer then manually add a network print queue.
To get the IP address, on the control panel of your printer, press on Setup > Network Setup > TCP/IP > View/Set IP address.

HT2497 Connected to wifi but can't get on internet on MacBook Pro laptop

Connected to wifi but can't use internet on laptop??

Information.
Can’t Connect to the Internet
Can’t Connect to the Internet (2)
Connect to the Internet – Solutions and Troubleshooting
Connecting to the Internet - Solve Problems

Connected to internet, but can't find server.

Similar Messages

Maybe you are looking for