Connection error in "Dual mode"

Question

Yesterday, after 2 months of normal usage, my E61i, settled on “dual mode”, stopped to work.
On the screen it appears instead of “3G” the symbol of an antenna (GSM connection) without the name of the operator.
If I try to make a call it doesn’t work and it gives “connection error”. When someone calls me, it gives the message "phone is switched off".
If I set the phone on “GSM mode”, it works but of course in GSM and not in UMTS (3G), and I need to use 3G in order to speed up the internet connection.
My Italian operator is Wind and if I transfer this sim in another phone (Nokia 6151 that is a more simple UMTS phone) the problem is exactly the same.
I tried to use a different sim Wind, and also in this case I have the same problem on both the phones.
With a sim of Vodafone all is ok.
Probably it is mainly a network problem, but I cant understand why the phone doesn’t switch automatically on GSM if UMTS signal is not present. The phone is not a “provider locked phone”, it is an original “Nokia” and it has been updated to firmware version 2.0633.65.01. The 3G signal was very good.
I’ve found a lot of posts concerning this problem, but the only suggestion is to change the network mode from "Dual Mode" to "GSM", and then back to "Dual Mode".
Unfortunately the above solution doesn’t work and consequently I’m starting a new topic hoping to receive some new suggestion in order to solve this problem.
Thank you and best regards
Piero

Answer 1

RodWard: I have the same problem as x1cwm562
My videos work when previewed in CP and when previewed in web browser, but not when published in the LMS. I have just updated from CP 5.5 to CP 7 AND switched to a new LMS ;-) Naturally problems occur...
My old LMS took scorm 1.2 and the new one scorm 2004. Therefore I have merely opened my CP 5.5. project in CP 7- re-publised it to scorm 2004 and published it to our new LMS. Everything works but not any of the videos. Instead of the video playing the text "Connection error" appears. I have tried both IE and Chrome. The videos were added by Video- Insert video and are matched to the slides length. The videos are in f4v format and worked fine when published in CP 5.5. and the old LMS.
1. Is there anything I need to do when re-publishing a CP 5.5. file in CP 7?
2. I've seen many questions about similair issues at the forum concerning going from CP 5.5. to 6. In those cases peolpe recommended to inistall a patch from Adobe, and that seem to have solved peoples issues- would the same work for me?
3. Might there be some adjustment needed in the new LMS?
Hope you can give me som input!
/Johanna