Controller Interface problems

Question

I recently purchased a Presonus Faderport to make light work of automation and the mixing stage but I have a few niggling problems.
First of all, in Logic, I created a controller surface, then selected Mackie HUI (as specified in the Presonus product manual) and also selected the input as faderport, out port as faderport and flip reverse off. The pan and volume work fine but ultimately, the main reason for getting the faderport was to control the automation parameters. When I move the fader only, the channel strip volume increases instead of the selected automation parameter (lets say for instance I have chorus as an insert and selected chorus intensity as the selected automation parameter).
The current channel strip parameter is set to volume, and send parameter set at destination. Are these at the correct settings?
4PBloody

Answer 1

The problem was solved by bringing Interface controller from Comp B to Comp. A.
We have to import the "Called" component interface controller into the "Caller" Component, using Component Usage definition.
In my understanding, Interface controller works more likely as an Input device than Output.
Then, we have to put this Input device into the Components that are "outputing" data.