CR2008 SP2 install appears to hang with no progress bar

I have CR2008 SP2 installed.  Come to find out I didn't have .NET support installed originally so I re-ran the installation to make a modification to the installation.  Unfortunately the installation process appeared to hang on the "Thank you for choosing Crystal Reports 2008", not activity bar, but the msiexec process was still running, so I killed it.  I decided to uninstall the whole program.  Reinstalled CR2008 SP1, no problem.  Then it then downloaded SP2 and and ran the update and it was hung on the same screen for about 15 minutes before it actually finished.  There seems to be an issue where the progress bar is grayed out.  I am running Win7 64Bit.  The install eventually completed successfully.

Hi Seth,
This is normal for Windows 7. Lots of registering and low end stuff happening that can't access the progress bar while it's being done.
I'll suggest we add a "Please be Patient" to the install screen.
Thanks again
Don

Similar Messages

  • LCM import of Planning Application Hangs with "In Progress Status"

    Hi,
    LCM import of Planning Application Hangs with "In Progress Status" . its already couple of hours. Earlier it was always within 10 mins.
    Any advise is appreciated.
    Regards,
    Vineet

    It is probably worth trying again, may be useful to first bounce the services.
    If it happens again after bouncing the services then investigate at what staging it is getting stuck at.
    Cheers
    John
    http://john-goodwin.blogspot.com/

  • HT201263 my iphone 3g Stops responding, showing the Apple logo with no progress bar or a stopped progress bar, for over ten minutes ..plz give me suggusition ?

    Stops responding, showing the Apple logo with no progress bar or a stopped progress bar, for over ten minutes

    First thing to try is to reset your device. Press and hold the Home and Sleep buttons simultaneously ignoring the red slider should one appear until the Apple logo appears. Let go of the buttons and let the device restart. See if that fixes your problem.

  • HT1212 My ipad mini has been crashing a lot recently so I started a system reset. However, it's now stuck with the progress bar less than a quarter gone: this has been the case for several days now. I have tried resetting from itunes but it needs the pass

    Now it's stuck with the progress bar less than a quarter full. I have also tried resetting through itunes which works right up to the point where itunes states that it needs the passcode to be inputted into the ipad to connect to it. At which point it then sticks at the same progress bar point. HELP!! please, this ipad is really important to my work.

    Well the term "hotlined" I have never heard before. In any case many states (like NY) just passed regulatory powers to the State Public Service Commission of which it may be called something different in your state. You could file a complaint with them. Or file a complaint with your state attorney generals office, they also take on wireless providers.
    The problem here is the staff you speak to are poorly trained, in days gone by it took one call to them and they pulled up your account and see the error and had the authority to remove any errors. They did not remove legitimate account actions, but used their heads instead of putting a customer off or worse lying to the customer.
    Its a shame you have to go through what you going through.
    Good Luck

  • HT1451 I am trying to restore my iphone but its stuck at the apple logo with the progress bar. What should I do?

    I am trying to restore my iphone but it has been stuck at the apple logo with the progress bar and it shows no signs of loading at all. What should I do?

    Hello kuukua.b,
    Thanks for using Apple Support Communities.
    Please try to restart and reset your iPhone by following the steps below, and then resume your restore process.
    Turn your iOS device off and on (restart) and reset
    http://support.apple.com/kb/ht1430
    Take care,
    Alex H.

  • Problem with the progress bar

    I've have a problem with the progress bar of my ipod. I bought a 5th generation ipod about 8-9 months ago. Now its progress bar stuck so it only shows the 5 dots. It doesn't show both scrubber bar and song time bar. When I press the center button, the 5 dots dissappear from the screen and then reappear but it doesn't show the other bars. Do you know what is the problem and How can I fixed it?

    have you tried resetting ipod, cause as far as i know, this is sometimes just a temporary glitch, mine does this.

  • When my Mac battery dies and I turn it back on, it always crashes on the grey screen with the progress bar, then it restarts (taking forever) and does not remember any of the programs I was running. MacBook Pro 13 inch running Mavericks

    When my Mac battery dies and I turn it back on, it always crashes on the grey screen with the progress bar, then it restarts (taking forever) and does not remember any of the programs I was running. MacBook Pro 13 inch running Mavericks

    http://osxdaily.com/2014/10/17/os-x-yosemite-installation-stuck/
    also use the Command-L to view logs during installation

  • Splash Screen with a progress bar at the bottom

    Hi,
    I want to display a splash screen with the progress bar at the bottom just like eclipse , limewire etc
    Take a look at the image below.
    [http://imageupload.com/out.php/i138889_splashScreen.png]
    Can anybody tell me how to achieve this type of splash screen?
    Thnx in advance.

    Search Google.
    This is one of the results: [Splash screen avec progress Bar|http://www.labo-sun.com/resource-fr-codesamples-1126-0-java-gui-splash-screen-avec-progress-bar.htm]

  • HT4623 My iphone had an error while updating and is now locked up on the apple screen with the progress bar

    Itunes was updating my phone from 6.01 to 6.1 and it came up with an error. I closed the error not thinking about it and now my phone is locked up on the apple screen with the progress bar on it.

    hi i tried to update my iphone 3gs from ios 4.1 to 6.1.2, while doing the same i got an error message (-5000) which i ignored an continued. it was almost about to complete while my itunes is not able to detect the iphone kindly help.

  • Place video with no progress bar?

    Hi
    I'd like to place a video seamlessly so it plays like an animation, with no progress bar or controls. It's easy to exclude the controls but there is still a progress bar. how to remove ?
    learning a lot here!
    thanks for the help!
    S

    If you disable "tap to view controls“ the video should play seemlessly.
    The desktop viewer shows the progress bar even with that setting disabled.
    On your iPad it will be without.
    —Johannes
    (mobil gesendet)
    Am 08.12.2011 19:32 schrieb "SteveLunny" <[email protected]>:
       place video with no progress bar?  created by SteveLunny<http://forums.adobe.com/people/SteveLunny>in
    Digital Publishing Suite - View the full discussion<http://forums.adobe.com/message/4071925#4071925>

  • TS3681 the device displays the Apple logo with no  progress bar for 8 hours until battery run flat.

    My Iphone4 displays the Apple logo with no progress bar for 8 hours until battery went flat this was after i try to make an up date know the  i tunes dosent reconise my phone.
    Can you please help me
    Thank you.

    http://support.apple.com/kb/ht1808

  • After a reset of settings on IPad2 it turns "on" but i only get to the logo screen with the progress bar under it. so it turns on to logo then to progress bar screen then off. and repeats over and over

    Well as I said in the "question", I did a reset of the settings on my IPad2. however when it powered back on from resetting. it lets the the logo screen with the progress bar under it. The progress bar gets about 1/4 of an inch from the left then stops. After a few mins Ipad shuts off then turns on to the logo screen, then goes to the logo/progress bar screen, does whats said above, then off. That cycle just repeats over and over. Any help with this would be appreciated.

    Recovery Mode Step by Step
    1. Hold Sleep/Wake button down and slide to turn off iPad
    2. Turn on computer and launch iTune (make sure you have the latest version of iTune)
    3. Plug USB cable into computer's USB port
    4. Hold Home button down and plug the other end of cable into docking port. Do not release button until you see picture of iTune and plug.
    5. Release Home button.
    On Computer
    6. iTune has detected iPad in recovery mode. You must restore this iPad before it can be used with iTune.
    7. iPad Recovery Mode on computer screen
    8. Select "Restore iPad"...
    9. Select "Restore and Update"
    10. Extracting Software.
    11. Preparing iPad for restore.
    12. Waiting for iPad.
    13. Verifying iPad restore...
    14.Restoring iPad software.
    15. Verifying iPad software.
    16. Verifying iPad Restore...
    17. Restoring iPad firmware...
    18. Your iPad is restored to factory settings; keep iPad connected to computer
    19. Activate iPad
    20. Enter Apple ID and Password
    21. Continue
    22. Welcome to Your New iPad
    (a) Set up as new iPad   (b) Restore from this backup (select from list of backups)
    23. Restore from this backup
    24. Continue
    25. Restoring iPad from backup
    26. The settings of your iPad have been restore; keep iPad connected to computer
    27. Syncing iPad (Step 1 to 5)
    28. Preparing apps to sync
    29. Copying 1 of 9
    30. Sync apps, movies and music to iPad
    31. Finishing syncing
    32. Eject iPad

  • My iPhone 4S got stuck on the apple logo with the progress bar!

    Afternoon. My iPhone 4S got stuck on the apple logo with the progress bar! but every time after I restore the 4S the progress bar starts again and stops at different stages of the loading process! Can anyone help with this please?
    All this started happening after I tried to download the lastest update (iOS 7.1). The 4S went and got stuck on the apple logo and progress bar!!

    Hello kuukua.b,
    Thanks for using Apple Support Communities.
    Please try to restart and reset your iPhone by following the steps below, and then resume your restore process.
    Turn your iOS device off and on (restart) and reset
    http://support.apple.com/kb/ht1430
    Take care,
    Alex H.

  • Mac OS Mountain Lion Shuts down at Apple logo with a progress bar appearing under it.

    Last Night there were two updates available which i downloaded and after that it asked for a restart, when i restarted the Mac, it gave me a progress bar for the updates at the middle of which it said, Installation of Updates can not be Completed and My mac book froze. After that i Shutdown my Macbook Pro by holding the Shutdown button for a little while.
    When i restarted the Macbook Pro, it gave remained at apple logo for a while then a progress bar appeared after which it shut down itself and it is doing the same since then.
    I have got windows over Boot Camp in my Macbook Pro and i can boot into Windows which is running fine and i can access all the data on my Main Partition through Windows as well but i am unable to boot into Mac os Mountain Lion.
    I have tried Repairing the Partition by going into Recovey and it Fails, I have tried Resetting the PRAM and that hasn't worked either, i have tried re-installing the Mac os Mountain Lion from Recovery but that says that all my Partitions are Locked.
    I haven't got any backup of my data through Time Machine so i was thinking as i can boot into Windows and access the data and as all this is because of the Installation of Updates Failure so there should be some way to manually edit the Boot Files to trick the Mac book into thinking that there weren't any updates or to simply clear the data from Updates.
    Can anyone please help me if you have any better suggestions.

    If it's still under warranty or with AppleCare (even if it isn't, really) take it in to an Apple store.  If you can get at your personal files from Windows, copy them to an external drive first.  That includes anything you have in Windows that you need to keep.  Sounds like the drive is going south and if it has to be replaced, you'll lose everything if you don't have it backed up.

  • Why does the word "attaching" sometimes appear with a progress bar at the bottom of the woindow when I have not attempted to attach anything during composition

    Occasionally, when composing and email, the word "Attaching" appears at the bottom of the window and a progress bar repeatedly sweeps as though a file is being attached, but I haven't tried to attach anything to the email.

    Hi mark11111,
    Does this happen when you are composing new emails, or when you are replying to emails?
    Or both?

Maybe you are looking for

  • ITunes 11 (11.1.4) Update Missing Album Artwork

    Macbook Pro, Mac OS X (10.7.5). I have recently updated to 11.1.4 and now I am left with much of my album artwork missing...........sort of. In the picture below you can see the artwork is in the mini window but not on the album cover. Simple enough,

  • IPod plays while 'switched off'

    My iPod is 2 years old. 80Gb with colour display. For the last 9-10 months I go to use and and the battery's flat or I find it playing. When I connect to my computer I find it's been playing for hours. It comes on when I'm out etc so it's nothing I'm

  • 2 Idocs in 1 Message

    Hi, I have this problem where I'm trying to mapp one file to two different Idocs in the same mapping. The mapping works correctly but when I test it i get this error: Messages in multi message format can be sent to one adapter engine only. I have use

  • I updated my 3rd Gen iPod Touch to 4.2.1 but now it won't access wi-fi.

    I updated my 3rd Gen after restoring to factory settings, to the 4.2.1 softwre but now it won't even acess the wi-fi anymore. As in the wi-fi button has been disabled, or rather said, it became unavailable (aswell as the bluetooth button.) It became

  • Custom Web Service in GRC

    Wanted to know if a stage can be defined that invokes a custom web service that returns an approval  indicator. All the web services I've seen in GRC are at predetermined points or prebuilt integration sections. We need the ability for a custom web s