Crrystal Reports using ADO. How do you Change the Isolation Level?

Question

Post Author: jmetaxas
CA Forum: Data Connectivity and SQL
Crrystal Reports using ADO.  How do you Change the Isolation Level?  I found a knowledge base article that allows you to change it for ODBC.   But nothing on ADO.  I kicked around changing the reports to ODBC but even then the keys described in the article do no exist.  Any suggestions?
Thanks,
John Metaxas

Answer 1

T-Bob wrote:
I want to make sure that points 2&3 are at the same level, so I can just move the envelope region between them up and down to change the volume. Any quick way to do this to speed up my process?
Specifically to address this point: if you mouse over the audio levels' rubber band segment BETWEEN your points 2) and 3) until the cursor changes to an up/down adjustment arrow ⬍, and move it up/down, it will adjust BOTH the levels at 2) and 3), maintaining the relative difference between them (or, if points 2) and 3) start at the same level, this adjustment will keep them equal as you drag them both up/down together in one action.)
As usual, much easier to DO it, rather than describe it!