Detailed specs for Cinema HDD 23-inch -- different from older models?

Question

I am having trouble finding detailed specifications for my new 23" display to use for running X.org. I need to know the timings for each resolution, as simply specifying the resolution does not work. The best I've found is here:
http://www.gubbe.ch/linux/dev-cinema23.php (the gray box at the bottom lists the detailed specs to put in the file)
However, this is for the older model of display with ADC and not DVI. I'm not sure if these will work with the new model, and I'm afraid to try because it used to be that one could really mess up one's display by specifying the wrong timings.
Does anyone know if the specs have changed between the older and newer models, or where I could find new specs, or help setting it up to run under X.org?

Answer 1

Actually, those Modelines from the web site work fine, at least for the generic nv driver. I'm having trouble getting the proprietary one from nVidia to work though. I'm working with them on this: http://www.nvnews.net/vbulletin/showthread.php?t=70630
The problem I am looking at right now are these lines from my latest Xorg.0.log file:
(WW) NVIDIA(0): No connected display devices detected; assuming 1 CRT
(WW) NVIDIA(0): Unable to read EDID for display device CRT-0
(II) NVIDIA(0): NVIDIA GPU GeForce3 Ti 500 at PCI:1:5:0
(--) NVIDIA(0): VideoRAM: 65536 kBytes
(--) NVIDIA(0): VideoBIOS: 03.20.00.16.10
(II) NVIDIA(0): Detected AGP rate: 4X
(--) NVIDIA(0): Interlaced video modes are not supported on this GPU
(--) NVIDIA(0): Connected display device(s) on GeForce3 Ti 500 at PCI:1:5:0:
(--) NVIDIA(0): CRT-0
(--) NVIDIA(0): CRT-0: 350.0 MHz maximum pixel clock
(II) NVIDIA(0): Assigned Display Device: CRT-0
(II) NVIDIA(0): Validated modes:
(II) NVIDIA(0): "1920x1200"
(II) NVIDIA(0): Virtual screen size determined to be 1920 x 1200
(WW) NVIDIA(0): Unable to get display device CRT-0's EDID; cannot compute DPI
(WW) NVIDIA(0): from EDID.
(==) NVIDIA(0): DPI set to (75, 75); computed from built-in default
This is my graphics card saying, "I can't see what sort of monitor has been plugged in, so I'm going to assume it's a CRT," and then from there it messes up. It can't tell my monitor is plugged into the DVI port. I'm not sure if this is my monitor's problem or my card's problem. The monitor is plugged in directly--the cable coming from the monitor is plugged right into the DVI port--but I'm not sure if Apple did something silly like, say, converting that DVI connection into an ADC connection before having it interface with the monitor's hardware. Any insight about this would be appreciated.
Anyway, I tried that timing you gave me with the proprietary driver. It didn't work, but I doubt that's because the timing is incorrect, and has more to do with the fact that my card can't seem to see the monitor.