Distance need to be covered without wire and mesh

Hi
I have AIR-AP1231-A-K9(Obviously FAT).I need to be covered two distances (100 meter and 50 meter).Is there any possibility we can use Bridging or Repeater and Standby AP and extend the signals upto required distance.But main thing is client dont want to purchase anything he want to use his existing above mentioned 6 APs.
Please reply....

So you would like to extend your cell coverage without additional purchases.
Sounds to me you may want to try and use the 1231 in repeater mode. A few things to keep in mind, you will need power in the place you plan to install the 1231 (repeater). Also keep in mind cisco recommends 50% cell over lap between the main ap and the repeater, you should also expect a 50% throughput loss in data from clients using the repeater.
If you want to use the bridge; i would use 802.11a to bridge the traffic from ap to ap and have the 802.11g radio serve clients or other way around...
Lots of ways to skin this cat ...

Similar Messages

'send to' widget? I need to send pdf without downloading and attaching to an email (one click send function)

Is there a 'send to' widget I can attach to a pdf document or form to send pdf without downloading and attaching to an email (one click send function)

From this conversation's thread it appears that Acrobat is not the application / service at issue.
As this user forum has as its focus "Acrobat" it seems that the OP is in the wrong place.
Acrobat's one click send feature provides the user a "draft" email. The user still has to process ("click") through steps with the email client/service to actually get the email out and on its way.
I'm sure that "one click" does everything is available somewhere. Considering all it'd have to do and do right it'd be rather expensive.
Be well...

WRT300N signal needs to be extended without wires.

I am approximately 80 feet from our WRT300N router and receive a 40% signal on my desktop PC using the WUSB300N network adapter. That is the highest I have ever connected at. It usually works fine unless someone else is using the wireless network, especially if they have a B or G card. When this happens, I can not do anything online at all. Now that summer is almost here, the network will be used a lot more which means I will not be able to get online.
I have found there are no repeaters/extenders that work with the N standard yet but was wondering if there is a way to extend the range to where I am at so I can remain online basically 24/7.
I can not run a wire from my location to the router because it would be outside and over a driveway. Can I purchase another product for my house that would extend the signal for me without connecting a wire to the current WRT300N router?
This WiFi signal is the only access I have to the internet and was hoping I could maybe purchase another router and plug it in here to pick up the signal without too much trouble.
Any help is appreciated,
Troy
Message Edited by vBTEAM on 04-02-2008 02:57 PM

The kind of network you are working on ... i think WAP4400N Wireless Access Point ... with N standard ... It will extend range also & signal strength also...

Help! I accidentally deleted Apple Application Support... is there any way I can download it and reinstall it without deleting and reinstalling itunes?

My huband is going to be so ****** if I have to uninstall and reinstall itunes. PLEASE HELP ME! If he loses his playlists or any other information it will be devastating... he has a radio show!
When I try to open itunes it says that it won't open woithout Apple Application Support and says I need to uninstall and reinstall itunes. 2 things I'm afraid will happen.
1. He doesn't want to update to the latest itunes because all his friends told him not to because the newest version *****.
2. He might lose all his playlists and also even if he doesn't los his itunes library he might lose data and information about all the songs.
I just really need to open itunes WITHOUT uninstallign and reinstalling it. Is there ANY way I can do that?

I also googled this question. Someone said if I download quicktime it comes with apple application support. Does that solve my problem?

How to delete everthing without itunes and restriction password

i need to delete everthing without itunes and restriction password

Can you go to Settings>General>Reset>Erase all content and settings? That is the only way.

For the new iPhone 5s - is there not an option anymore to edit imessages without deleting the whole stream? There are some things I need to keep within a stream and some not necessary, and it looks as like no editing within a conversation?

For the new iPhone 5s - is there not an option anymore to edit imessages without deleting the whole stream? There are some things I need to keep within a stream and some not necessary, and it looks as like no editing within a conversation?

Now I also know about pulling the message to the left to see the time stamp. Good to know, although I preferred it being right where I could see it without having to do a swipe or keystroke.

Urgent help : Need to recover a database without backup and archivelogs

Hi,
We are in urgent need to recover a database without backup and archivelogs
one datafile seems corrupted
SQL> recover automatic database until cancel using BACKUP CONTROLFILE;
ORA-00279: change 10527325422479 generated at 07/27/2011 03:13:04 needed for
thread 1
ORA-00289: suggestion : /pys/u5/oradata/PYS/PYSarch/arch0001.0000181845.arc
ORA-00280: change 10527325422479 for thread 1 is in sequence #181845
ORA-00278: log file '/pys/u5/oradata/PYS/PYSarch/arch0001.0000181845.arc' no
longer needed for this recovery
ORA-00308: cannot open archived log
'/pys/u5/oradata/PYS/PYSarch/arch0001.0000181845.arc'
ORA-27037: unable to obtain file status
HP-UX Error: 2: No such file or directory
Additional information: 3
Specify log: {<RET>=suggested | filename | AUTO | CANCEL}
CANCEL
ORA-01547: warning: RECOVER succeeded but OPEN RESETLOGS would get error below
ORA-01152: file 1 was not restored from a sufficiently old backup
ORA-01110: data file 1: '/pys/u2/oradata/PYS/pay_system_01.dbf'

N Gasparotto wrote:
bsac14 wrote:
my database is in no archive mode
can you please tell how to restore
yes it is a datafile corruptionYou did not say how you defined that's a datafile corruption. You provide minimum to zero information.
I just need to bring the database up,no need any exact data
I can refresh from prod laterThen drop and recreate database. Basically and since you are not in archive mode, no recover is possible. Period.
Nicolas.Hi,
How did you come to the conclusion that your datafile is corrupted? Can you provide and supported logs?
Regards .....

HT4848 Hello- My laptop needs the OS X recovery run. Can I download the software directly to a thumb drive without affecting my desktop unit? The Geek Squad said they need to wipe my hard drive and re-install the operating system. Thanks.

Hello- My laptop needs the OS X recovery run. Can I download the software directly to a thumb drive without affecting my desktop unit? The Geek Squad said they need to wipe my hard drive and re-install the operating system. Thanks.

They already damaged you Mac by fooling with the BootCamp partition without knowing what they were doing. I wouldn't suggest haveing them help you do anything.
Here is the article that describes the Recovery HD: http://support.apple.com/kb/HT4718?viewlocale=en_US&locale=en_US
First, see if you can boot into the Recovery HD. Restart and hold down cmd-r until you see the gray screen. It should boot into Recovery. If your Mac shipped with Lion or Mountain Lion, it will boot into Internet Recovery if it cannot boot into the Recovery HD on the hard drive.
They should have tried this at the store.

I own CS4, upgraded to CS5, then joined CS6, CC... and now I installed CC14. Which will be the best way to delete or uninstall the programs I don't need keeping only CC14 without running into issues? I have an Alienware Area 51 PC running Windows 7.

I own CS4, upgraded to CS5, then joined CS6, CC... and now I installed CC14. Which will be the best way to delete or uninstall the programs I don't need keeping only CC14 without running into issues? I have an Alienware Area 51 PC running Windows 7.

Which will be the best way to delete or uninstall the programs I don't need keeping only CC14 without running into issues?
There is none. Whatever you do to get rid of the older versions will inevitably do damage to shared components and other stuff of the new versions as well. That's just how it is with this approach... Uninstall the older versions, run the cleaner tool then reinstall CC 2014.
Use the CC Cleaner Tool to solve installation problems | CC, CS3-CS6
Mylenium

The Iphone 4 patch IOS 7.6 is suppose to be a security update but it freezes the phone and doesn't reset. Help I need my phone. What makes the phone go back to normal? There is nothing but a simulated plug in wire and an ITunes icon on a black screen.

The Iphone 4 patch IOS 7.6 is suppose to be a security update but it freezes the phone and doesn't reset. Help I need my phone. What makes the phone go back to normal? There is nothing but a simulated plug in wire and an ITunes icon on a black screen.

Hi SDPISMENOW,
If you are having issues updating or restoring your iPhone after attempting the iOS 7.0.6 update, you may find the following article helpful:
Apple Support: If you can't update or restore your iOS device
http://support.apple.com/kb/ht1808
Regards,
- Brenden

Just got an iphone 4 from my dad and its his old iphone and i was gonna delete his account so i can put my account on the iphone but he does not remember the password so I couldnt delete it. I need help deleting it without a password

just got an iphone 4 from my dad and its his old iphone and i was gonna delete his account so i can put my account on the iphone but he does not remember the password so I couldnt delete it. I need help deleting it without a password.

If the iPad has Activation Lock - that is, it's asking for the previous owner's Apple ID and password to activate the device or to turn off Find My iPhone - then you will need that information. There's no way around it If your father can't remember the password, he'll need to recover it.
http://iforgot.apple.com
If he can't do it via that page, then he'll have to call Apple Support and ask to speak with Account Security.
If that's not the "password" you meant, please post back and clarify.
Regards.

Need itunes without quicktime and cd burning

can i get itunes without quicktime and cd burning? i don't need it
and of course a version working on vista 64

Unfortunately, iTunes will not function properly without Quicktime (usually by popping up the 'iTunes has encountered a problem' message). It's needed for iTunes to play media.
Also, any 64 bit edition of Windows is unsupported by iTunes, and has a whole lot of problems with CD burning/importing. More information on that is listed here: http://docs.info.apple.com/article.html?artnum=301301

I charged my ipad with a defective charger, it heated up and stopped working. i charged for a good 4 hours without knowing the charger was defected (distortion of internal wires and a broken protective external layer)

I charged my ipad with a defective charger, it heated up and stopped working. i charged for a good 4 hours without knowing the charger was defected (distortion of internal wires and a broken protective external layer)

You're not asking any question so I'll just ramble.
You may have permanently damaged your iPad. The iPad controls the current coming from the charger but the charger electronics must be capable of responding to the iPad. Charge with a known good charger and then test your iPad. If it's OK, you lucked out. Otherwise... If the charger was not an Apple charger, you're completely out of luck. If it was an Apple charger, call Apple and discuss the issue with them.

I need to set up 9 IPhones and 4 IPads to be used as data collection devices. How can I do that without setting up 13 separate ITunes accounts?

I need to set up 9 IPhones and 4 IPads to be used as data collection devices. How can I do that without setting up 13 separate ITunes accounts?

You can use the same account to set up as many devices as you like.
You might also find there are tools to help with a roll out.
http://www.apple.com/support/iphone/enterprise/
tt2

How do I use my MacbookPro On my 47inch Screen without wires

I have a macbookpro that I hook up to my tv using the mini display port. Screen comes on TV without issue the thing I want to do is hook up a wireless keyboard and mouse so I could connect my laptop and sit on the couch with the keyboard and mouse and do everything i need to do..
How and what would I need to do this

You just need a bluetooth mouse and keyboard. I do the same thing on one of my TVs.

Distance need to be covered without wire and mesh

Similar Messages

Maybe you are looking for