DMR with skip lots & without inspection severity

Question

Hi,
I have a requirement where my user needs the DMR at lot level where they do not need the inspection severity to be picked from DMR because the inspection plan has got different sampling procedures for respective MIC's.
Example:
Create a inspection  plan with 3 MIC's for a material as shown below which is having active inspection type as 01: Inspection lot against GR
MIC
Sampling procedure
Inspection severity for sampling procedure
Temperature
SAMP1
SEV1 (for 100 lot size, sample size =5)
Length
SAMP2
SEV2 (for 100 lot size, sample size = 8)
Width
SAMP3
SEV3 (for 100 lot size, sample size = 2)
DMR at lot level is assigned to the inspection plan
DMR is defined as given below:
Stage
Insp severity
Skip
Initial
No. of OK inspections
New stage if OK
No. of not ok insp's
New stage if not OK
1
sev1
yes
2
1
2
yes
1
1
When a inspection lot is created against a GR for 100 lot quantity for this material then system will show the sample size in the results recording screen by considering the DMR inspection severity for all MIC's as shown below.
MIC
To inspect
Inspected
Result
Temperature
5
Length
5
Width
5
My requirement is system should propose me the sampling size as per the sampling procedures assigned to the MIC's in theinspection plan as shown below:
MIC
To inspect
Inspected
Result
Temperature
5
Length
8
Width
2
Lots should be skipped normally as shown in the DMR but sample size should be calculated from the sampling procedure assigned to the MIC.
Please help me out if there is any standard practice in SAP for this requirement.
Thank you.

Answer 1

Dear Craig,
I am concerned about the sample size calculation here.
Yes I have defined three seperate severities for those sampling procedures.
Each sampling procedure has many inspection severities assigned to it and I am defining the default inspection severity in the additional tab of sampling procedure so that where ever i use the sampling procedure automatically the default inspection severity will be considered for calculating sample sizing,
For example:
I have assigned normal, reduced, tightened and loose inspection severity to SAMP1 sampling procedure, then here I will default the inspection severity for the sampling procedure as reduced inspection. In this case where ever I use SAMP1 sampling procedure automatically reduced inspection severity will be considered for sampling sizing.
Similarly, I have assigned normal, reduced, tightened and loose inspection severity to SAMP2 sampling procedure, then here I will default the inspection severity for the sampling procedure as loose inspection. In this case where ever I use SAMP2 sampling procedure automatically loose inspection severity will be considered for sampling sizing.
The procedure which I have given above is standard practice in SAP, but here I want to assign DMR at inspection lot level.
DMR: If 1 lot is created then 3 lots should be skipped. Here inspection severity should not play any role.
Inspection severities should be picked from the sampling procedure assigned to the inspection plan and sample size should be calculated as per the default inspection severities assigned to the respective sampling procedure for an MIC.
Thank you.