Does iTunes use wireless music stream if using an Ethernet cable for AE?

Hello,
I have been having trouble with airtunes for some time now. I've tried lots of different things without much success. I think there might be too many wireless networks in my building and I am getting a lot of interference. So i'm thinking of trying a wired method.
If I plugged an ethernet cable from the computer into the Airport Express (which is then plugged into the stereo), does airtunes still send the music stream wirelessly or would it use the ethernet cable instead?
Thanks
WP

1. Will this work (i.e., add wireless to the office and maintain my existing wireless in my home)? If so, what do I need to do? Specifically, do I need to configure WDS and (if so) does 2Wire support this?
What you are attempting to do is actually called a "roaming" network in Apple terms and not WDS. In a roaming network, AirPort base stations are connected together on the same subnet of an Ethernet network. Each base station is setup as a bridge, but share the same network name (SSID) and encryption (if used). It sounds like it should be possible to setup the AirPort Express Base Station (AX) as a roaming network. The following is how it would be done with AirPort Extreme Base Stations:
- Network configuration: DSL/Cable Modem or Internet Router > (Ethernet cable) > [WAN] AEBS1 [LAN] > (Ethernet cable) > [LAN] AEBS2 [LAN] > (Ethernet cable) > [LAN] AEBSn (Note: In your case, you will have a single AX, instead of multiple AEBSs.)
- Setup the second AEBS, as a bridge. (Disable "Distribute IP addresses")
- For each AEBS in the roaming network:
-- Connect to the same subnet of the Ethernet network
-- Provide a unique Base Station Name
-- The Network Name should be identical
-- If using security, use the same encryption type (WEP, WPA, etc.) and password.
-- Make sure that the channel is set at least three channels apart from the next AEBS.
2. Assuming I can, can I have that same AX (i.e., the one connected vis-à-vis Ethernet cable) be used for wireless printing in the office while providing wireless internet? Any special configuration to allow that?
Yes.
3. If this network desire does not work, is there another set of hardware that I should purchase (i.e., a different wireless DSL modem, Airport Extreme, other???).
The configuration as you planned it should work...but, in case it doesn't, I'd recommend that you replace your current wireless router with an AEBS. You can then get either another AEBS or an AX to create the roaming network.

Similar Messages

HT204291 Using an ethernet cable for Apple tv

I found that my mirroring was lagging. Would it be possible for me to connect to the Apple tv with an ethernet cable?

I plugged the Apple TV box into my router via ethernet, and voila! All works now. I can mirror my desktop just fine. HBO Go apparently shut off video streaming (FAIL) so I guess I'll watch that stuff on demand or on my laptop.

I'm trying to transfer music from iTunes on an old PC that uses an external storage device to a new PC (Windows 7) that will use that same external storage device. I am also dealing with new iTunes 11. How do I do this?? What folder does iTunes use?

I'm trying to transfer music from iTunes on an old PC (Windows Vista Home Basic) that uses an external storage device to store the files to a new PC (Windows 7 Starter) that will use that same external storage device. I am also dealing with the new iTunes 11. How can I accomplish this successfully? What folder does iTunes use to store the data in? I've tried several things. Home Sharing caused duplicates but not all songs or apps transfered. It is a large library! I've tried just setting the path in the Advanced Tab of iTunes preferences of the new computer with the external drive connected the same as the path when the external drive is connected to the old computer. This was the best solution so far but still a few artists missing and some apps. Any suggestions?

Here are typical layouts for the iTunes folders:
With iTunes 11 you might also have a Home Videos folder inside iTunes Media.
In the simplest cases you copy the entire iTunes folder from <User's Music> on the source computer to <User's Music> on the target machine, install iTunes, and it "just works"TM.
If the media folder (inside the red outline) has been split out to a separate location then you can copy the library folder (outside the red outline) as before and connect the drive holding the media so that it has exactly the same path as before. If the drive appears as D: on one system and E: on the other then the library won't be able to find the media.
The crucial file is iTunes Library.itl - this contains a record of the tracks that have been added to the library, ratings, play counts, playlists etc.
See also: Make a split library portable.
tt2

How does iTunes use or access existing files?

how does iTunes use or access existing files? My existing windows music folder is about 2GB in size. When moving to iTunes, will iTunes just access those existing files or will it make an actual copy of all the songs? Thanks!

http://support.apple.com/kb/HT1549?viewlocale=en_US

What information (in my itunes) does iTunes use to retrieve album art?

What information does iTunes use to retrieve album art?

too bad we can't bring up a list of possibilities from Gracenote, like it does when it's confused about a CD you're importing
Good idea!
Send suggestions here -> http://www.apple.com/feedback/itunesapp.html

Does iTunes use Internet Explorer to access the internet from a PC with Windows Vista?

Does iTunes use Internet Explorer to access the internet from a PC with Windows Vista?

Are you using Windows XP or Windows Vista?
Did you remove iTunes and the other Apple software also, and then reinstall iTunes.
Removing and Reinstalling iTunes, QuickTime, and other software components for Windows XP
Removing and reinstalling iTunes, QuickTime, and other software components for Windows Vista or Windows 7
Did you try to put the iPhone into recovery mode?

Can I add a second Airport Express using an Ethernet cable to extend my network if the first AX is wirelessly connected to an Xtreme?

Hi, I run a small motel and I am trying to extend the wireless network from the office to the rooms in the next building.
I have an AirPort Xtreme connected to my router with an ethernet cable and it works fine. I have then connected an AirPort Express to this in the next bulding wirelessly (as i cant run an ethernet cable outside) which extends the network over all but the last 2 rooms in the next building. There are bick walls so it sruggles over the distance. I realise I cant connect another airport express wirelessly to extend the network further but can I connect another Airport Express using and ethernet cable to the exisiting Aiport Express to extend the network that extra distance?

You can do this, but as you might imagine, that is going to place even more of a load on the weakest link....the wireless "hop"......between your AirPort Extreme and the current AirPort Express.
So, things will slow down even more. Whether or not that will be acceptable to your guests is open to question. Light browsing and email should be OK. Someone trying to download a large file is going to be waiting longer than they might consider normal.
Things like this, you simply cannot predict in advance. Might be a good idea to understand the store's return policy if the new Express puts more of load on the network than is expected.

How can I make Time Machine use the ethernet cable to Time Capsule instead of the wireless connection? Wireless is too slow; has been taking 40 hours to create an initial 142 GB backup.

How can I make Time Machine use the ethernet cable to Time Capsule instead of the wireless connection? Wireless is too slow; has been taking 40 hours to create an initial 142 GB backup.

Plug in ethernet .. in the computer.. turn off wireless.

How does iTunes match handle music that isn't available in iTunes?

How does iTunes match handle music that isn't available in iTunes?

Apple - iTunes - Match
iTunes Store: Subscribing to iTunes Match
iTunes Match on iPhone, iPad, or iPod touch

Does it use hitachi hard disk for hp probook 4530 note books?

I gave my hp probook 4530s note book for install few software to a service center. But after few days my hdd is not working. when I remove the hard disk to chech there is a hithachi HDD. I'm afraid does it use hitachi hard disk for hp probook 4530 note books?

Hi,
HP uses many components from many vendors to build their computers. All other vendors DO the same.
Regards.
BH
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.

HT204074 How does iTunes match handle music that isn't available in iTunes?

How does iTunes match handle music that isn't available in iTunes?

Music in your iTunes library that isn't available at the iTunes Store is uploaded to your iCloud account.

Using an ethernet cable to connect Time Cap to iMac?

Hello,
This is a pretty basic question, but I'm not really sure what the correct answer is.
I use a Time Capsule as my WiFi unit in my house (I have a cable internet connection---cable comes out of the wall and goes into a cable modem, and then from there, an ethernet cable goes from the cable modem into my Time Capsule).
I was told by an Apple expert that I can probably get a faster internet connection if I use an ethernet cable to connect my iMac to my Time Capsule (as opposed to using it via WiFi, as I am currently doing). I have two questions regarding this:
1) Is it true that my speed will increase?
2) How do I connect the two together? Do I just use a spare ethernet cable and plug that into the rear of my Time Capsule, and then the other end into my iMac?
I want to keep the WiFi part working, because I have other Apple devices that use WiFi (iPhone, iPad, AppleTV).
Thank you for any information and/or suggestions.

I was told by an Apple expert that I can probably get a faster internet connection if I use an ethernet cable to connect my iMac to my Time Capsule (as opposed to using it via WiFi, as I am currently doing). I have two questions regarding this:
1) Is it true that my speed will increase?
The expert is only providing half of the story. He forgot to tell you that your Internet connection speed is determined by the plan that you have with your Internet Service Provider (ISP).
This is the bottleneck on your (and my) network since your wireless connection speed capability is already much higher than your ISP can ever hope to deliver.
For example, let's say that your plan with your provider supplies 20 Mbps. Your wireless network will typically handle much higher speeds...anywhere from 100-250+ Mbps.
Yes, an Ethernet connection has yet higher speed potential than a wireless connection, but if your wireless connection speed potential is already much faster than your Internet connection can deliver, having even higher speed potential with an Ethernet connection will do nothing for your performance.
In other words, your Time Capsule (or any other router) cannot take the signal that your Internet Provider supplies and make it go faster, whether it is using wireless or Ethernet connections.
Your Internet connection speed will only be as fast as your plan allows. If you need a faster Internet connection, you will need to speak to your ISP about a faster plan.
2) How do I connect the two together? Do I just use a spare ethernet cable and plug that into the rear of my Time Capsule, and then the other end into my iMac?
Yes, that is correct. Be sure to turn off the wireless on your iMac as well since you no longer need that connection.

My Itouch 3rd gen can't be recognize by my computer but when I put my iphone4 its can be recognize I use the same cable for both of them.

My Itouch 3rd gen can't be recognize by my computer but when I put my iphone4 its can be recognize I use the same cable for both of them.

Does it charge?
- Reset the iOS device. Nothing will be lost
Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Inspect the dock connector on the iPod for bent or missing contacts, foreign material, corroded contacts, broken, missing or cracked plastic.
- Make an appointment at the Genius Bar of an Apple store.
Apple Retail Store - Genius Bar

I used an ethernet cable between my iMac and Time Capsule for the initial backup. Now that initial backup is concluded, can I simply unplug the Time Capsule from my computer?

I used an ethernet cable between my iMac and Time Capsule for the initial backup. Now that initial backup is concluded, can I assume I can simply unplug the Time Capsule from my computer without any glitches and Time Capsule will then run wirelessly. Is this assumption correct?

can I assume I can simply unplug the Time Capsule from my computer without any glitches and Time Capsule will then run wirelessly. Is this assumption correct?
Yes, if the computer will be able to receive a strong wireless signal from the Time Capsule.
I did not disable wireless. So I assume the backups are occurring both with the ethernet and wirelessly.
It is inot possible to have both an "active" Ethernet and "active" wireless signal simultaneously. If an Ethernet connection is established, your computer will default to the Ethernet connection. If the Ethernet cable is unplugged, the computer will revert to the wireless connection.
I also show 2 wireless networks available through Airport. Shouldn't there only be one now?
You have a simultaneous dual band Time Capsule. That means that it will always be providing both a 2.4 GHz and a 5 GHz network.
I named my new network the same name as the old network. This enabled all of our devices to continue with their connection without entering the new network and/or passwords; however, I am afraid this may pose problems in the future somehow. Any input on this issue as well?
Things should be fine. Devices will connect to the best signal.....either 2.4 GHz or 5 GHz....based on their capabilties and location in relation to the Time Capsule.

I cannot access my Apple TV in WiFi mode. I have used it previously, but it keeps saying it is not connected to the network. My broadband is running. I was able to access Apple TV using an Ethernet cable. I have entered the password as confirmed by my ISP

I cannot access my Apple TV in WiFi mode. I have used it previously, but it keeps saying it is not connected to the network. My broadband is running. I was able to access Apple TV using an Ethernet cable. I have entered the wireless password as confirmed by my ISP without any success.

Hi,
Thanks for trying to solve my problem. It appears that the password I was inserting was incorrect. I now have access.
Thanks again.

Does iTunes use wireless music stream if using an Ethernet cable for AE?

Similar Messages

Maybe you are looking for