Does Zalman Reserator fit in the Mega PC 651?

Is there room for a Zalman Reserator water cooling fan in a MegaPC 651? Does anyone know?
I have asked in the Zalman Faq forum, but they don't know....

Quote
Originally posted by jjarrett
but an external PSU could be set on the floor
usually system designers try to make power cables/buses as short as possible, in order to have the "power" at the end as "clean" as possible. I dare say that external PSU even 1m /3ft apart form the system probably would not be very practical solution, if the output power cables were designed by the textbook. Too much of copper...
Just like Reserator, which needs to be well-aligned by height with the CPU cooler block, not to mention the challenge to put the water pipes through the interior of Mega
EDIT: on Mega 180 one would need an extremely small CD/DVD device, something like notebook "slimline" drives, in order to get the water cooling block in, or (more likely) to skip the internal CD/DVD drive.

Similar Messages

  • MEGA PC 651 and 1 gig of RAM

    Hi Guys, I have a MEGA 651, cele 2.6 gig and i HAD 1 gig of ram in there... but after doing my usual tasks in XP, it would just reboot! as anyone had this problem? i take out 1 stick of 512 and it runs fine.  I think this may be an over heating problem because i noticed that extra stick of 512 generates quite a bit of heat.  Could it be a problem with the mobo handling 512 or ram as well?  If anyone has any info this would be great
    Thanks

    Quote
    Originally posted by Danny
    Could be bad ram:  Memtest86
    Could be power supply can't handle the extra load.
    Thanks alot for your response..
    Hmm i know its not the ram, its been tested in another system and its fine.. So it might be the power supply huh? how can this be resolved? i heard the mega PC 651 was released in 2 models.. 1 with a higher voltage power supply, i guess mine is the lower of the 2 released, if so..do i have to replace the power supply?

  • MEGA PC 651 BOOTING/BIOS/HEATSINK PROBLEM

    From this thread topic it seems really general but heres the deal...
    I was recording some music with it and video editing the other night and the monitor went blank but the PC was still on.I rebooted and the PC started beeping with one long continuous beep.
    From what i've found looking on here it seems to mean the RAM is faulty but i have managed to reboot for a while before experiencing the same problem which i'm guessing wouldnt be possible without any RAM
    I opened up the case to inspect and noticed the heatsink clamps are broken which obviously isn't good because it means the CPU isn't being cooled as well as it could be but i have managed to sit the heatsink on the CPU with the thermal compound keeping it in place.I have emailed MSI to get some spare clamps but i'm not sure this will solve the problem.
    As i have said tho i have managed to reboot the machine and work on it and then it shuts off again
    The HDD light stays on when everything is powered up.Sometimes i get the continuous beep, sometimes i don't and sometimes it boots up like nothing is wrong.
    Is it because the CPU is getting too hot? Or is it something else like the BIOS, the CPU or the mainboard itself?
    Also...some segments are missing from the LCD display causing characters to not display properly - do i need to get a new LCD screen or can i rectify it with software or something?
    Please help me
    Thanks

    I found someone had posted about getting spare clamps on here and they were successful in getting some from MSI
    I just copied and pasted the email this user had sent to MSI to get them and they sent me some
    The machine has been working again but is a really troublesome system
    I still have trouble with the MEGA PC 651 - even getting it to boot even tho i had installed a new HDD and installed a fresh copy of XP
    It's just problem after problem 

  • Does the Zalman VF700-AlCu fit on the MSI N220-MD1G ?

    Hello all
    I have a little question
    Does the Zalman VF700-AlCu
    or the Zalman VF900-Cu
    fit on the MSI N220-MD1G ( it has currently a very little cooler which makes a LOT of noise )
    The current cooling is mounted on 4 screws in a square
    Between each 2 screws is 5,5Cm of space
    Diagonal: +- 8 cm of space.
    Thank you for your awnsers!

    They all said it wont but it fit just fine

  • Does 1Z0-001 fit the requirement of 11g DB OCP requirement (1Z0-051)?

    Dear Sir:
       Hi, I would like to ask 3 questions about the certification requirement of 11g DB OCP.
    Please advice me what do I have to do to prepare the OCP exam, thanks a lot in advance.
    Q1:
    Does 1Z0-001 fit the requirement of 11g DB OCP requirement (pass 1Z0-001 = pass 1Z0-051)?
    AFAIK, 11g DB OCP requires passing 3 exams: 1Z0-051 (SQL), 1Z0-052 (AW1), 1Z0-053 (AW2) and finishing a hand-on course at least.
    I have passed the 1Z0-001 (Introduction to SQL ans PL/SQL) many years ago.
    After searching the discussion in the community, I've found 2 relative:
    https://forums.oracle.com/thread/2526631  It said :"1Z0-001 will satisfy the SQL requirement."
    https://forums.oracle.com/thread/2467872 It said : "I can confirm that the 001 exam will fulfill the SQL exam requirement if it was passed before it retired."
    I was confused on that. Please help me to clear it.
    Do I have to prepare the exam 1Z0-051 since I have passed 1Z0-001 (an retired exam)?
    Q2:
    Please confirm that finishing the SSC (Self-Study Course) DOES NOT apply the "hand-on course requirement ".
    It still need to pay more money for an instructor-led (face-to-face) course, right?
    Q3:
    Can I just finish ONE course "Oracle 11g Database Administrator Workshop II" from an Oracle authorized education center to fit the " hand-on course requirement " ?
    Sorry I have to ask this because the budget consideration.
    Thank you very much!
    Steve C.

    Q1:
    Does 1Z0-001 fit the requirement of 11g DB OCP requirement (pass 1Z0-001 = pass 1Z0-051)?
    Q2:
    Please confirm that finishing the SSC (Self-Study Course) DOES NOT apply the "hand-on course requirement ".
    Q3:
    Can I just finish ONE course "Oracle 11g Database Administrator Workshop II" from an Oracle authorized education center to fit the " hand-on course requirement " ?
    A1 -- Yes, if you passed 1Z0-001, you do not need to take 1Z0-051.  When courses are retired, it simply means they are no longer given to *new* students.  Anyone who passed them still retains credit for having done so.
    A2 -- Self Study CDs do not count for the hands-in requirement.  On the approved courses page of OU, it specifically states: "Self Study CD-Rom and Knowledge Center courses are excellent study and reference tools but DO NOT meet the Hands-on Requirement for certification."
    A3 -- Only one course is required for the 11G OCP.  That one is on the approved list and so will be acceptable if the vendor is authorized by OU.

  • Does an Iphone with mophie juice pack plus fit in the tigra bike mount?

    Does an Iphone with mophie juice pack plus fit in the tigra bike mount?

    Hello KThomLV
    According to the Apple Store Online, it is compatible with iPhone 5 and iPhone 5s
    Mophie Juice Pack Plus for iPhone 5/5s
    http://store.apple.com/us/product/HD069ZM/A/mophie-juice-pack-plus-for-iphone-55 s?fnode=48
    Regards,
    -Norm G.

  • How can I receive a fax?  The phone jack does not seem to fit in the ethernet port....(OS 10.6.7)

    how can I receive a fax?  The phone jack does not seem to fit in the ethernet port....(OS 10.6.7)

    sarahfromberkeley wrote:
    how can I receive a fax?  The phone jack does not seem to fit in the ethernet port....(OS 10.6.7)
    The MacBook has no fax-modem. You will need an external (USB) modem.
    Stedman

  • Why does the huawei modem from Cricket or any flashdrive fit in the USB cord on my macbook pro?

    Okay, so I just purchased a macbook pro and I was excited about switching from my dell. While I set up everything in my mac book, it asked me what type of wi-fi or internet connection I would be choosing. I tried to install my cricket modem but there was one problem. It doesn't fit in the USB cord. At first I thought I was putting it wrong but no that wasn't the answer. Then I tried to put a flashdrive to test it and it doesn't fit either? Is there like something wrong with my mac or I am doing something wrong? I didn't had this type of problem with my dell? In fact, I could even connect ipods, iphones to it but in mac....nothing. Can somebody please help me? I'm starting to get frustrated.

    The easiest way is to go to the Apple site and find the Java for OSX 2014-001 and install it. There have been some reports of blank pages returned so you may need to try several browsers.

  • Photo does not fit in the screen

    I watched that video http://www.youtube.com/watch?v=KJMi5l9Ru-g     and tried this to do the parallax scrolling with the image this on my page. Unfortunately, my photo does not fit in the whle screen, even if I take a . jpg image  3000 px wide. ( look here ) I have no idea how I can get the photo to fit in the whole screen.
    Thank you for your help.
    Heike

    Hello again,
    I'm sorry, but nothing works and I don't understand, what you mean. I will show you again with no other item on the page. I draw a rectangle which snaps each of the lines at the outside.
    I got rid of the stroke and the fill.
    I filled with a .jpg image 3000 px wide.
    For the future parallax scrolling I need to set up the photo in vertical tile. And this is, how it shows on the screen.
    I still have no idea, what I made wrong. Thanks for your help
    Heike

  • I recently bought a Macbook Air and a Thunderbolt Display and the laptop's power is supposed to come from the display, but the power cable on the display does not fit into the Macbook Air.

    I recently bought a 11" Macbook Air and a 27" Thunderbolt Display.The laptop's power is supposed to come from the display when connected, but the power cable on the display does not fit into the Macbook Air.

    If your MBair is a 2012 model, it has a Magsafe 2 power connection.  The monitor probably has the old magsafe connection.  If this is the case, you need this adapter.
    http://store.apple.com/us/product/MD504ZM/A?fnode=5a

  • Transportation error - SIPT_INSERT_FI (SIPT_DATA|11) does not fit into the existing function group ((SIPT_DATA_FI|02))

    While performing a system maintenance task we came across this Transportation error - SIPT_INSERT_FI (SIPT_DATA|11) does not fit into the existing function group ((SIPT_DATA_FI|02))
    Can someone help us in resolving this
    Thanks and regards
    RS

    Please expand the log also please check the SAP note 1835436
    Regards
    Aneesh

  • Template does not fit into the window

    Hello all,
    <b>Template does not fit into the window (Message no. SSFCOMPOSER173)</b>
    I am getting the above error in when i try to preview my smartform.
    The template is in footer window. I have only 3 lines in the template.
    And the size of template is less than window size.
    I do not understand why this error. This happened when there are many line items in the main window. With less no. of line items it worked well.
    If you have any suggestions Please help.
    Thanks.

    Hi,
    Please check the following points:
    1. Font size and font family.
    2. Line spacing
    3. Allignment.
    4. Left and right margin
    Deserve Rewards.
    regards.

  • Hi, my iphone 5 charger does not fit in the hole iphone .. it seems as if something inside the iphone had moved because I see that the charger works perfect in another iphone 5

    Hi, my iphone 5 charger does not fit in the hole iphone .. it seems as if something inside the iphone had moved because I see that the charger works perfect in another iphone 5

    Clean the lint or grit out of it with canned air or a toothpick.

  • Does the new ipod nano fit into the apple docking station the same as the former ipod nano?

    I have an apple docking station and I know that the ipod nano is thinner but other than eprhaps being a little wobbly does it fit into the same socket as the original ipod nano?
    Thanks

    You need the lightning-to-30-pin adapter. Get it from an apple store.

  • Does anyone if the iPhone 5 cases will fit on the iPhone 5s?

    Does anyone if the iPhone 5 cases will fit on the iPhone 5s?

    Check your Apple store online and under cases you will find those that both iPhone5 and 5S compatible

Maybe you are looking for

  • A question about xpath2.0 sequencetype

    The result of following expression 5 instance of xs:integer is true while the result of following expression 1.0 instance of xs:float is false what's the problem of the second xpath expression

  • Drag and drop in I tunes

    I can drag and drop music from the computer to the I tunes library, but It won't let me drag and drop from the library to a new play list I created. Only to the I tunes DJ. How can I do that?

  • Is it safe/okay to use RSNAST00 program in a user-exit?

    Hi Experts, I got a business requirement and its: After SAVEing the sales order......by using the user-exit USEREXIT_SAVE_DOCUMENT I have to trigger custom IDOC (currently its in the system and using for some other application) outbound direction to

  • Can i set up an id w/out entering a credit card info

    how do i set up an id w/out entering a credit card info

  • Forms applet doesn't respond anymore

    Hi, Migrating to SunJVM 1.6.0_07 (JPI) our forms application sometimes crashes. It happens when dragging the mouse over the value displayed in a text field. About once a month on a normal PC and a couple of times a day on a virtual client. It never o