Download fails to finish at the very end

I started to download the Trial Version of CS6 Design and Web Premium suite (4565 MB). My computer stopped when the download was about a third done and, after restarting it, I activated the Adobe Download Manager. The download resumed though, curiously seemed to start anew though in the target directory it was clearly adding to the file's size. When, after some 13 hours, the download manager reported that "less than a minute" remained, the file contained 7,279,902 kb, far more than had been initially announced. At that point, the download manager jammed and failed to finish the download. The target file's name (DesignWebPremium_CS6_LS16.7z.adadownload) didn't get amended to become an executable file.
Is there a solution or must I start the download from scratch again?

It looks like you will need to cancel the download. You can either reinitiate the download through the Adobe Download Assistant or initiate a direct download by following the steps listed at http://forums.adobe.com/thread/981369.

Similar Messages

My iTunes On my iPad will download tv shows then at the very end say error downloading.....any ideas?

At the very end of the download it says error downloading, tap to retry. On just about any tv show or movie.

If your ext HD boot volume is running Lion, just use something like Carbon Copy Cloner to clone it to the internal. Clean installs are usually just a waste of time.

TS3694 I waited about an hour to download IOS 7 and at the very end, it said An unknown error occured (6). What is this "unknown" error?

So basically I waited about an hour for itunes to update my iPhone to IOS 7 and it is currently frozen because it had an (error 6) right at the end up the update. What do I do now? Why is it not updating?

An unknown error occured (6). What is this "unknown" error?
Don't know - it's unknown.
Try again, when the Apple servers are less busy.

I tried to download Itunes 11 but at the very end it says that an error has occurred and my system is not modified??

Its all in the question. It also says to complete the install I should run the installer again. My laptop has Windows 8. I'd really apperciate any help!

Hello there, im so lost.
The following Knowledge Base article should walk you through uninstalling and reinstalling iTunes:
Removing and reinstalling iTunes and other software components for Windows Vista, Windows 7, or Windows 8
http://support.apple.com/kb/HT1923
Thanks for reaching out to Apple Support Communities.
Cheers,
Pedro D.

ITunes goes all the way through the download process and at the very end fails. what is the problem?

Couldn't get into iTunes. Advised by error message to download iTunes again. At the very end of the installation, it fails and tells me to try again. What is the problem here?

At the very end of the installation, it fails and tells me to try again.
What's the precise text of that error message, please? (There's a few different ones I can think of that you might be getting.)

Creative cloud download fails at the very end and won't complete [was: can you PLEASE help me?]

as the title says when i download creative cloud it fails at the very end and doesnt let me download it? PLEASE HELP!! ill do anything

The problem is that none of us are in the same room looking at the same computer you are looking at. Also "Please help" is not very descriptive and won't invite help. "Filename.zip won't download" is better.
We need to know what your operating system (Windows 7 or Mac 10.8) CPU/ram tells us if you meet system requirements.
Next detail what you are doing, link us to what web page are you downloading from and what link are you clicking to download the file.
Sometimes browsers can have pop-up or script blockers. You might try another browser. IE, Safari, or FireFox.
Once we know exactly what file you want,we can give you an alternate download link.
Gene

I cannot receive email properly now. When I open mail, it says that is downloading about 1,700 emails. At the very end, it gives me my newest ones. But this takes a long time. I've contacted the Internet service provider and verified all the right setting

I cannot receive email properly on either my IPad or my IPhone. I have had them for over a year and they have always worked fine. Until three days ago, when they both started acting up. On the IPad, when I open mail, it says it is downloading about 1,700 emails. At the very end, which takes quite a while to get to, I finally get the most recent ones. The IPad is sending emails just fine.
On my IPhone, when I open mail, it says it is downloading 100 emails, but it doesn't do that. And it gives me no new emails at all. The IPhone is sending email just fine.
I have already deleted the email accounts on both devices and reinstalled them. I've contacted the Internet service provider and verified all the right settings. The Outlook email on my desktop is working perfectly.

WMV is a heavily-compressed format/CODEC, and the processing time will depend on several factors:
Your CPU, which is not that powerful in your case
Your I/O sub-system, which is likely a single HDD on your laptop
The source footage. What is your source footage?
Any Effects added to that footage. Do you have any Effects?
Each of those will have an impact on the time required.
The trial has only one main limitation - the watermark. Now, there are some components, that have to be activated, but are not with the trial, but they would be evident with Import of your source footage, if it's an issue.
Good luck,
Hunt

HT1657 I tried downloading a movie, at the very end it said there was a problem. Now it's not on my laptop but if I go to download it again it asks me if I want to rent again? How do I get a credit?

I tried downloading a movie, at the very end it said there was a problem. No explanation, now it's not in my itunes library and when I try to download again it tells me I have already rented this movie do I want to rent again? I don't want to pay for it a second time, how do I receive a credit?

If it's not in the Movies part of your library, then does the Store > Check For Available Downloads menu option download it ? If not then try the 'report a problem' page to contact iTunes Support : http://reportaproblem.apple.com
If the 'report a problem' link doesn't work then you can try contacting iTunes support via this page : http://www.apple.com/support/itunes/contact/- click on Contact iTunes Store Support on the right-hand side of the page, then Purchases, Billing & Redemption

Upgrade from Windows 8.1 to 10 fails with an error code, at the very end of processing

I tried to upgrade to Windows 10. It went through the whole process, and upon reboot at the very end it failed. It threw this message: I searched on these terms and couldn't find an answer. My machine is brand new. I haven't installed much on it at all, figuring it's better to wait until I've gotten Windows 10 installed. Any ideas?

So it looked like I was missing a KB update, the 3035584, which enables the upgrade. I performed some Windows 8.1 updates and got everything set up. I ran the upgrade to Windows 10. It went all the way through to the reboot, taking about 20~30 mins. At this point it asks me to confirm installation, and I select "OK" and it goes for another 20 mins. It proceeds about 10% of the way there, and then it reboots. The next thing I see on my screen is "Restoring your previous version of Windows". I'm back to Windows 8.1 again. I log in... and same error message as shown above. Frankly, I can't understand what is causing this... and why Windows can't "figure out" if my machine is good to go for a full installation in just 10 mins or so. Why go through all of these gyrations for 45 mins only to reject the whole process?

For me, I hit the restore process, get a spot on apple's servers, ites through the restore, and at the very end it fails and gives me error 3004

I hit the restore process, get a spot on apple's servers, it goes through the restore, and at the very end it fails and gives me error 3004 :|

Jdda wrote:
... error 3004 :|
See here for your Error message > http://support.apple.com/kb/TS3694

Downloaded IOS 8.1 to my IPAD2 which locked up at the very end and would not complete download

Downloaded IOS 8.1 to my IPAD2 which locked up at the very end and would not complete download, need help to complete download to IPAD2. How do I restart. IPAD2 is now locked up. Can't even power it down. HELP.

Hello erniefromrichland,
The article linked below details a number of steps that can help get your iPad to respond.
iOS: Not responding or does not turn on
http://support.apple.com/en-us/TS3281
If you're still unable to get your iPad to boot up or the update did not complete successfully, the next article linked details how to get your iPad updated via iTunes using Recovery Mode.
If you can't update or restore your iPhone, iPad, or iPod touch
http://support.apple.com/en-us/HT1808
Cheers,
Allen

HT204302 At the very end of installing iTunes 11.1.1.11 a window appears: "There is a problem with this Windows Installer package. A program required for this install to complete could not be run. Contact your support personnel or package vendor." Availab

At the very end of installing iTunes 11.1.1.11 a window appears: "There is a problem with this Windows Installer package. A program required for this install to complete could not be run. Contact your support personnel or package vendor." Available choice is click "OK" then "Finish" and install has then failed.

Go to START > ALL PROGRAMS > Apple Software Update. If it offers you a newer version of Apple Software Update, do it but Deselect any other software offered at the same time. Once done, try another iTunes install
If you can't find ASU, go to Control Panel:
XP - Add n Remove Programs
Win7/Vista - Programs n Features
Highlight ASU, click change then Repair.

CS5 freezes at the very end of encoding

I have been using Premiere CS5's media encoder for months now, without issue, but now I've run into a problem:
I have a 2-hour video that I am encoding to a .m2v to be put onto a DVD in Encore. However, at the very end of encoding it, when the estimated time remaining is only a second or two, AME essentially freezes. It never finishes the job.
If I close AME out, the video shows up in the folder, but shows it to be only about 1.5 hours long instead of 2. When I import it into Encore, it's the correct 2-hours, but Encore then freezes when I try to build the DVD.
None of this has ever happened before, but it seems to all trace back to AME. This project has been working fine with AME until now -- all I've done recently was cut a few minutes out of the video. Here's a screen cap of what AME looks like - it's just sitting here like this and will indefinitely until I close it down:

Superfan:Thanks for the tips. I will try the out marker suggestion.
Re: the files - mostly Quicktimes, but there are a few AVI files in there. This project has about 1,000 files in it (feature film) now that I'm in the final stage of finishing it, and I have no idea how to track down which file might be corrupted.
Jim: Separate .m2v and .wav files on the export for Encore. I've tried Adobe Dynamic Link to send it directly to Encore, but when I select that option absolutely nothing happens

How to Add a Linefeed to the Very End of a TextFrame's Contents

(IND 5.0, Actionscript)
Hi all,
I need to be able to add a linefeed ("\n") to the very end of a TextFrame's contents, which may include any combination of tagged and untagged texts, and tagged and untagged image frames.
There seems to be an endless variation of circumstances, each of which require a specific solution.
For example:
If the last run of the Text is tagged, then I need to append the "\n" to the that last tag's contents.
If there are no Tags in the Text, then I can append the "\n" to the TextFrame's contents.
If the TextFrame is Tagged, but the last letter(s) in the Text are untagged - I don't know what to do.
If the last object in the TextFrame is an Image Frame, then I don't know what to do (you can't add the "\n" to an image's contents).
In short, is there some catch-all solution for adding a "\n" at the very end of a TextFrame's contents, without the Tags on the Text being removed and without causing a failure due to trying to add "\n" to an Image's contents?
TIA,
mlavie

Harbs is crazy busy right now, and I don't really understand your issue.
Why do you need to add a linefeed? Do you mean a paragraph return or soft return?
Something like this might be what you are after:
textFrame.insertionPoints.item(-1).contents = "\r";
or
textFrame.insertionPoints.item(-1).contents = SpecialCharacters.FORCED_LINE_BREAK;
Harbs

At the very end of creating an email account the program asks for a software security device password, I have no idea what this is or where to find it.

At the very end of creating an email account the program asks for a software security device password, I have no idea what this is or where to find it. To my knowledge I don't have a "software security device". I am using Windows 7 on an IMac.

What is the exact prompt or error message you get?

Download fails to finish at the very end

Similar Messages

Maybe you are looking for