Dropped my iPhone in snow and now it will only show the apple logo when plugged in

I dropped my iPhone4s in the snow the other day, consequently it got wet. I could see the condensation in the camea and flash and the screen turned black however the phone still worked as when my friend called me it vibrated but I couldn't answer it because of the screen. The flash also was constantly on so it seemed like everything was working inside the phone but just not the screen.
As soon as I got home I left the phone in rice for 2 days.
I got the phone out and plugged it in to charge. The apple logo showed up and the phone vibrated but en the apple logo disappeared and the screen turned black again. I unplugged the phone and plugged it in again and the same thing happened with the logo again but no vibration.
If I take the phone out of the plug it will just stay as a black screen.
Any suggestions as to what is ring with it or what I could do to fix this?

You've most likely cooked it. Make an appointment at the genius bar. Take the phone and your credit card with you. An out of warranty replacement will cost you $199.

Similar Messages

  • HT201406 while trying to update my ipod touch  something happened and now my screen only shows the apple logo and nothing else happens

    while updating my ipod touch something happened and now the screen only shows the apple logo that goes on-off. i dont know what to do,please somebody help me!

    Try:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try on another computer
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
    Apple Retail Store - Genius Bar       

  • My phone went blank and now will only show the apple logo I have tried to reset it and that doesnt work HELP!!!!

    My iPhone is frozen. It was working find about a hour ago and then for no reason the screen went to the apple logo. I have tried to reset it and that doesnt work. When I press the power/lock button and the center key it turns off but then it comes right back to the apple logo screen and wont go any further. Please help I dont have my stuff saved and would like to keep the stuff i do have on it!!! Every once in awhile the screen will go black for a few seconds then the apple logo pops right back up! I dont know what to do.....

    Try to set it up as new device, explained here:
    How to back up your data and set up as a new device
    First without using the backup, in case it contains corrupt data.
    If it works after that, use the backup to restore from.

  • HT201263 my iphone 4 wont come on although it does show the apple signal when plugged in. i need to restore it but dont know how

    recently my iphone 4 shut down and wont come back on. when i plug it in to outlet or computer it shows the apple signal but still wont turn on. i need to restore to factory settings

    Hello, Taylorlocke. 
    Thank you for visiting Apple Support Communities.
    Here are a couple helpful troubleshooting articles that I would recommend going through.  They will walk you through troubleshooting this issue. 
    Will not turn on, will not turn on unless connected to power, or unexpected power off
    Verify that the Sleep/Wake button functions. If it does not function, inspect it for signs of damage. If the button is damaged or is not functioning when pressed, seek service.
    Check if a Liquid Contact Indicator (LCI) is activated or there are signs of corrosion. Learn about LCIsand corrosion.
    Connect the iPhone to the iPhone's USB power adapter and let it charge for at least ten minutes.
    After at least 30 minutes, if:
    The home screen appears: The iPhone should be working. Update to the latest version of iOS if necessary. Continue charging it until it is completely charged and you see this battery icon in the upper-right corner of the screen. Then unplug the phone from power. If it immediately turns off, seek service.
    The low-battery image appears, even after the phone has charged for at least 20 minutes: See "iPhone displays the low-battery image and is unresponsive" symptom in this article.
    Something other than the Home screen or Low Battery image appears, continue with this article for further troubleshooting steps.
    If the iPhone did not turn on, reset it while connected to the iPhone USB power adapter.
    If the display turns on, go to step 4.
    If the display remains black, go to next step.
    Connect the iPhone to a computer and open iTunes. If iTunes recognizes the iPhone and indicates that it is in recovery mode, attempt to restore the iPhone. If the iPhone doesn't appear in iTunes or if you have difficulties in restoring the iPhone, see this article for further assistance.
    If restoring the iPhone resolved the issue, go to step 4. If restoring the iPhone did not solve the issue, seek service.
    iPhone: Hardware troubleshooting
    http://support.apple.com/kb/ts2802
    If the above steps do not resolve the issue, or the if the screen remains black or shows a persistent Apple logo, try restoring with iTunes:
    Connect the device to your computer and open iTunes.
    If the device appears in iTunes, select and click Restore on the Summary pane. Learn more aboutrestoring iOS software.
    If the device doesn't appear in iTunes, try to force the device into recovery mode, and then restore it.
    If the above steps do not resolve the issue, contact Apple.
    iOS: Not responding or does not turn on
    http://support.apple.com/kb/TS3281
    Cheers,
    Jason H.

  • Ipod only showing the apple logo and will not do anything else. 1st GEN

    my ipod will only show the apple logo when plugged in to my computer i have a dell running xp but i have tried other computers and it will not do anything but show this symbol. my computer does not recognise that it is plugged in. ive tried the apple support fix-it but it does not do anything period. the buttons do not work when plugged in or not. the only thing it does is light up when plugged in. my other ipod works perfectly no problems so this leads me to believe that its not the computers i have used. just think the ipod has had it

    Mine did the same thing last week after trying to update it via wi-fi. I then spent 11 hours Sunday updating my itunes on the laptop then restoring my ipod. Now all it does is beep as if it is just plugged in and flash the white apple logo. It beeps constantly. My computer at first didn't recognize it, then it did but said I needed to unlock it,(since I can't get the home screen up, I can't.) and now it doesn't recognize it at all. I've tried both computers.

  • Iphone 3G only will only flash the Apple logo and do nothing else. HELP

    My phone started acting up yesterday and then it started only showing the apple logo. It flashes off and on. I plugged it in the computer and it stopped when plugged in. I then downloaded the new software and it still does the same thing. Any help or information you can give will be greatly appreciated. I bought the phone overseas so I doubt I can get official support here in the USA. I just moved back to the USA from Singapore.

    See if you can force the phone into recovery mode:
    Leave the USB cable connected to your computer, but NOT your phone, itunes running, press & hold the home button while connecting the USB cable to your dock connector, continue holding the home button until you see “Connect to iTunes” on the screen. You may now release the home button. iTunes should now display that it has detected your phone in recovery mode, if not quit and reopen iTunes. If you still don’t see the recovery message repeat these steps again. iTunes will give you the option to restore from a backup or set up as new.

  • I tryed to update my iphone and now my phone screen show the itunes logo with a wire and won't turn on, i tryed to update my iphone and now my phone screen show the itunes logo with a wire and won't turn on

    i tryed to update my iphone and now my phone screen show the itunes logo with a wire and won't turn on, i tryed to update my iphone and now my phone screen show the itunes logo with a wire and won't turn on

    Did you try to connect in recovery mode to your computer, explained in this article?
    iOS: Unable to update or restore

  • HT4061 I was software updating of my iphone when the updating complete and start installing the wi fi connection suddenly disconnected and it couldn't be completed. Now my phone doesnot display anything its like empty. it only shows  the apple logo. help

    Hi all,
    i was upgrading my iphone to ios6.1.2; the upgrading had been completed and starting to install but suddenly the wi fi connection lost and the installation couldn't be completed. Now my phone is dead....it only shows the apple logo....can't do anything..help me out..

    Press the button at the top right and the home button together for 30 seconds, when you see the apple logo, let  them go.
    if you see a picture of the itunes symbol and a whitye usb chord then connect the device to a computer and perform a restore. 

  • I recently restarted my iphone and now all that appears is the apple logo how do i fix this problem

    i recently restarted my iphone and now all that appears is the apple logo how do i fix this problem?????

    Plug it into your computer and restore it.

  • My ipad shut-off and now all i get is the apple logo and a spinning circle. Any suggestions on why and what I can do about it?

    my ipad 2 shut off and now all I get is the apple logo and a spinning circle

    Try holding down the home button and the sleep / wake button at the same time to restart the iPad .

  • MY iPhone 5C suddenly stopped working. It wont connect to my Mac and repeatedly reboots from the apple Logo when plugged into the wall. Help!

    MY iPhone 5C suddenly stopped working. It wont connect to my Mac and repeatedly reboots from the apple Logo when plugged into the wall.
    There is no water damage or anything. I got that checked at the Apple store. I also have Apple Care + but didnt let them give me a new one yet because I have photos on this that I have no yet backed up that are very important. They are the last photos I have with my grandfather. Can anyone help me. Please!

    If the phone shows the "connect to iTunes" screen, the data on the phone is most likely lost.
    Connecting in recovery mode is your only chance to use the phone again, besides getting it serviced by Apple.
    iOS: Unable to update or restore

  • Phone got wet,now it's only showing the apple icon and sometimes connect to itunes

    3gs phone got wet,now it's only showing the apple icon alternating with connect to itunes

    You didn't connect it to your computer or to power, did you?
    Wipe it down, put it in a baggie with raw rice or new silica gel packets and set it in a cool, dry area, like a cupboard. Leave it there for 3 - 4 days.
    Take it out after this time, wipe it off, use a soft brush to wipe any rice dust from the dock connector, and connect it to your wall charger. Let it charge for at least 30 minutes and then Reset it while it is connected to power. May take several tries. If it revives fully charge it.
    If this does not work you can do an out-of-warranty replacement with Apple for $199 USD.

  • My iPhone 5's screen will only blink the apple logo on and off but never fully turn on

    When I plug in my iPhone 5, it will only blink the apple logo on and off but never fully turn on. I tried to reset and that didn't help, any suggestions.

    Hi,
    Try a Reset of the Phone... You will Not Lose Any Data...
    Turn the Phone Off...
    Press and Hold the Sleep/Wake Button and the Home Button at the Same Time...
    The Apple logo will Appear and then Disappear...
    Usually takes about 10 - 15 Seconds...
    Turn the Phone On...
    If that does not help... See Here:
    Backing up, Updating and Restoring
    http://support.apple.com/kb/HT1414

  • I can no longer see my iphone on my computer. the ipone is gone blank only showing the apple logo

    my iphone no longer shows up on my computer, the iphone screen has gone blank only showing the Apple logo. I am unable to make and receive calls. Can someone help me with this problem please?

    Your iphone is shown at the top of the page.
    You can also simply click View>Show Sidebar and it will look about the same as it did before.

  • What do i do if my iphone only shows the apple logo?

    It only shows the apple logo noe and then. Help please

    Restore it.  This link will help:  If you can't update or restore your iPhone, iPad, or iPod touch - Apple Support

Maybe you are looking for

  • SOAP Web Service Authentication configuration

    Hello, I've got a little problem with Web Service authentication configuration. I'm working on the SAP NetWeaver CE EHP1 7.11. I also have a XMII application deployed on the server and there are some SOAP Web Services(over XMII Transactions) that req

  • How to generate a report from stored procedure

    I would like to generate a report from stored procedure. I used to work on sql server. this can be done as easy as put a select statement at the end of stored procedure. The resule can be displayed on the development IDE, like sql developer or consum

  • Is there a procedure to open keynote 09 files with videos in the new Keynote without converting videos?

    is there a procedure to open keynote 09 files with videos in the new Keynote without converting videos? I have a big presentation with many video mov and avi files created with Keynote 09. When trying to open the file in the new Keynote the procedure

  • Having some problems updating.

    Ok. So my little brother comes to me with his Ipod Touch because he it is displaying the "Connect To Itunes" Screen. So i do. But here is the kicker. An error comes up on itunes saying: "Itunes could not connect the Ipod "Vince's Ipod" because it is

  • OSX cannot boot-up after installing Security Update 2008-008

    Hi Everyone. I'm using a MacPro 2 x 2.66Ghz Dual Core Intel Xeon with 3GB RAM with Tiger 10.4.11. After installing Security Update 2008-008, my OSX was not able to boot-up. The screen shows the Apple Logo and the spinning grey gear wheel. It stayed t