DVD Studio log says "Bitrate too high"

Question

DVD Studio log says "Bitrate too high" and cancels burn process. Do the videos need to be re-exported, or can DVDSP be told to accept a higher bitrate? This is the first time I've used an external burner, so I'm thinking it's probably this, but then why does it only say Bitrate Too High in DVDSP, and not something more specific to the burner?
Any thoughts?

Answer 1

It sounds like you are encoding the video through DVD Studio pro, when doing this its possible to go over the DVD Spec bit rate (9Mbps). Go to your DVD Studio Pro preferences and in the encoding tab lower the bit rate.
Depending on the length of your project you may need to lower both the average and max bitrate.
For something under 90 min the attached image has settings you can use.
For better quality you may want to change the Mode from one pass to 2 pass VBR but remember this will take longer. Ideally doing all this in compressor will usually yeld better results because it has the ability to use frame controls and so on.
Hope this helps.