E 52 Screen stopped working and want to back up c...
Can any one help, is there any way of syncing the phone without being able to folllow the syncing instructions. Cheers
What you could try is to connect the phone to Ovi suite or Pc suite and try to click the "Ok" button to see if you can get it to choose Pc suite mode and connect. Then it should be able to make a back up of everything.
Try hitting the red disable call button a couple of times before connecting so you know you are on the home screen.
Similar Messages
-
My iphone 4 stopped working and want turn on
my iphone 4 stopped working and want turn on
If it is still charging using the adapter, let it charge for about 15min, then connect in recovery mode, explained in this article:
iOS: Unable to update or restore -
Trunks between 2950s stop working and wont come back
I've seen this happen on 2 different 'pairs' of 2950s, so it's time to investigate. The scenareo:
simple trunk (no vlan definitions) between 2 2950s. 1 switch looses power, when power is restored, the switch that didn't lose power doesn't pass any traffic. The interface is up (link and administrativly up) the logs don't show anything other than the interface went down and came back up. here's a sample port:
interface FastEthernet0/23
description new Feed from phone room switch
switchport mode trunk
no ip address
I'm not using spanning-tree, there aren't any redunant paths. Its worked fine for months (until a ups failure), I set up a new port on the switch and swing the cable and it comes up. Any ideas?
thanks!Hello,
I know this is an old post... but I am posting here in case this is viewed by anyone with a possible solution.
Our organization has multiple locations configured the same way:
(x2) cross connected 2950 switches in trunk mode, configured the follwing way per each interface (fa0/19):
interface FastEthernet0/19
no ip address
duplex full
speed 100
no cdp enable
spanning-tree portfast
Our problem is similar to the one explained in this initial post. The switches are auto-trunked via port #19.
Let's call one switch "A" and one switch "B"
Whenever power is removed from one of the switches (Switch A), and it has completed a restart, the opposite switch (Switch B ..the one which was not powered off) will not return to a "Trunked" state. When you run the "show int status" command, it shows that the port is "connected". Even though the switch which was initially restarted returns to "Trunked" mode.
We have seen this with a few of our 2950's across the infrastructure.
The bottom line is that restarting one of the switches causes the other to lose the trunked state. The only was to correct the issue is to restart the opposite switch as well.
The IOS version is 12.1 (9) EA1d .. I know it's old, however we cannot upgrade it at this time due to policies within the organization.
Could anybody shed some light on this?
Thanks in advance.. -
My touch screen stopped working...on my brand new replacement iPod touch.
I recieved my replacement while on vacation in Vegas, about five days ago. My new iPod has been kept nice and safe in it's case without any bumps that could damage it. Today, May 4th, I go to school with a perfectly working iPod. On my way home, kept safe in my pocket all day, the touch screen stopped working, and restarting it didn't fix it. It's brand new, so whats wrong and how can I fix it PLEASE!
yes i have the same problem. But also other then the fact that the touch screen doesnt register it is really dark, like there is no light bulb
-
Screen not working and device not working properly!
Npw im a careful person with mobile never had issues before
Earlier on in the day after just getting my phone today on contract with carephone warehouse i decided to do a little water test and take pics underwater , now the first thing i did was test the pressure of the device by going in the service menu and when i did it with flaps totaly firmmly close the pressure , so i fought well there shouldnt be any problems if i put it in like 6 inches of water in clean no redisidue sink ,now i checked the flaps 6 times bettore putting in water ,now at first i was working fine taking the pics and that thne after 3 mins i pulled out then wiped it clean next thing i know the screen stop working and after the device wont come on proper ie no screen displaying ,now I bouught this because of the amazing battery life and camera now this isnt a cheap pone so it should hold up to what it says it can do , im very disappointed
I cant afford to have pay for \a new and its not my fault any help guys?thanls for the reply guys took it back showed and no water inside they swapped it for a new one justl ike that have another problem now tho
stockyvillage wrote:
If on UK take it back to CPW and get them to exchange it.You could use the sale of goods act or consumer rights. -
Ipod nano 6th gen touch screen stopped working please help
Everything on the ipod nano 6th gen is working except the touch screen and once it goes to sleep i have to hold the sleep button and the volume down button to turn it back on. I went into the volume -, sleep, volume + menu and went through the tests and in the touch panel error check section it says i have IC error reported: 0xFFFFFFFF. Please help as i have reset and restored and update itunes etc. Do i need to send it in to apple? The touch screen was working at one stage and then i disconected from the computer while it said eject first (this is when the touch screen stopped working) and put the ipod on a different computer. The first computer was windows 7 which i used just to charge it a little and the second one im using is windows vista.
I have had the same problem and changed three Nano's. Each time the fault is diagnosed by Apple as "water damage".
If you take your Nano to one of their maintenance centres they will look into either the headphone socket or the power dock and and tell you that you have infringed the warranty by somehow getting the thing wet.
Basically is a poorly designed piece of kit whereas a simple shuffle is way more robust.
I have given up with my Nano and am now using an old model -
My (4G) iPod's screen adhesive came off, it's home botton is broken, and it also stopped working I want to get it fixed how much would it cost to get it fixed?
Apple at this time does not repair iPods, but assuming that that iPod is not in multiple pieces will replace the entire iPod for a flat fee; see the Repair Pricing section here:
http://www.apple.com/support/ipod/service/faq/
There are independent iPod repair services that may be able to perform a repair for less. Do a web search for "ipod repair". It is also possible to purchase parts and find instructions on doing a repair yourself, though it's not particularly easy. Note, though, that if you elect to have the iPod serviced by an unauthorized shop or perform a repair yourself, all further support from Apple will be void.
Regards.
Forum Tip: Since you're new here, you've probably not discovered the Search feature available on every Communities page, but next time, it might save you time (and everyone else from having to answer the same question multiple times) if you search a couple of ways for a topic, both in the relevant forums and in the Apple Knowledge Base before you post a question. -
Dear Sir: Yesterday on 18.09.2014 evening, I wanted to install
IOS 8.0 according to your instructions iPhone 5S.during installation
Stopped working and was closd, I can not work with him. Ibought it in
the United States
Apple Store Fifth 40venue 767 New York NY1053
iPhone 5s Spase Gray 32 gb verizon.
Part Number: ME344ll / A.
Serial number: DN*******NjM.
Model A1533. I would like to request a new password for opening the
iPhone. Passwod..... Thank you very much,
Im not difficult for you to request a quick answer.Israel.
<Personal Information Edited By Host>We are fellow users here on these forums, you're not talking to iTunes Support nor Apple - it looks like somebody has asked the hosts to remove your personal info from your post (it's not a good idea to post any personal info on any public forum).
What do you 'stopped working and was closed, I can not work with him' ? What exactly are you seeing on the phone's screen ?
If it's the activation screen and you can't remember your password for your account then see if you can get it reset via http://iforgot.apple.com -
2 of my movies are no longer working in my iTunes or on my iPod Touch, One doesn't play at all and the other gets to about 29:00 than stops working and I don't want to buy them again. Then also when I added a non-iTunes movie and tried to have iTunes make an iPod/IPhone version it gave me error -4. What's happening to my movies?
I also have to add that the right earbud only doesn't work on my phone while i'm listening to music. If I'm face timing it's okay. what the heck.
-
please someone who help me please
when I tgry to drop a video from the main screen to a time line with no secuence i receive an error with no number, just tell me the progran stop working and the program closesYou need to help us first ...
Computer specs:
OS, CPU, RAM, GPU, vRAM ... and also disc layout & connections can be useful (as in, "2 internal hard-drives and an external on Thunderbolt connection for exports")
Program specs:
Specific build of Premier Pro from the bottom of the "About" splash screen off the "Help" menu is best.
Footage file type: MXF, AVCHD, MOV, m2s, what?
Even the camera it was shot on can be of interest at times.
And did you use media browser to import, then project panel to drag & drop?
Neil -
I have apple macbook pro mid 2009 ... my hard disk stopped working and i had mac os 10.6.8 in it ... i bought a new hard disk drive but i didn't have my CD so i installed my friend's mac os 10.5.8 in the new hard disk ... i want to get my previous 10.6.8 back ... hope there is a way to do so
Upgrading to Snow Leopard
You must purchase Snow Leopard through the Apple Store: Mac OS X 10.6 Snow Leopard - Apple Store (U.S.). The price is $19.99 plus tax. You will be sent physical media by mail after placing your order.
After you install Snow Leopard you will have to download and install the Mac OS X 10.6.8 Update Combo v1.1 to update Snow Leopard to 10.6.8 and give you access to the App Store. Access to the App Store enables you to download Mountain Lion if your computer meets the requirements.
Snow Leopard General Requirements
1. Mac computer with an Intel processor
2. 1GB of memory
3. 5GB of available disk space
4. DVD drive for installation
5. Some features require a compatible Internet service provider;
fees may apply.
6. Some features require Apple’s MobileMe service; fees and
terms apply. -
Hi, I was wondering what is the warranty policy. A year ago I was using Iphnone 4 s and the camera stopped working and the carier gave me a new.
I couple of month ago I bought Iphone 5 and yesterday it just stopped working.
My question is want ca I do now? Do I need to go in an Apple store or in the office of the mobile carier I'm using.
Thank youType the S/N here and see if it is indeed covered for you: https://getsupport.apple.com/ProductSelector.action If yes, take it directly to Apple and avoid a runaround. If there's any issue with coverage or any other sh*t, take it to the carrier and let them deal with it, although it will probably take longer to sort out (but you may get lucky and be handed a refurbished unit right off the bat).
If possible try connecting it to a computer running iTunes to see if it shows up. That way you can back it up and save its contents for restoring onto whatever new device you get. -
I unplugged my iPod Classic without ejecting it first. It played for many hours(about 8) after that but then suddenly stopped working and it has a blackend screen that seems to say paused. Wondering if there is a way to get it to work again.
Hey hughborg25,
I found an article that can help you troubleshoot when an iPod becomes unresponsive or the screen goes black:
iPhone, iPad or iPod touch: Not responding or does not turn on
http://support.apple.com/kb/TS3281
I would go through all the steps listed there, and the issue should be resolved by the end.
Live long and prosper,
David -
My MacBook Pro speakers are stopped working and on screen volume icon shows in gray colour I am unable to change the volume.
Go step by step and test.
1. System Preference > Sound > Output > Internal Speakers
Highlight Internal Speakers.
Make sure that Mute is not enabled.
2.Plug in and remove the headphone.
If you see red light in the headphone port, plug the headphone
in and out of the port 5 or 6 times to flip the microswitch inside.
Sound output may be stuck in the digital mode.
Try this even if you don’t see the red light.
3. Reset PRAM. http://support.apple.com/kb/PH14222
Do this twice
4. Reset SMC. http://support.apple.com/kb/HT3964
Choose the appropriate method.
Choose the method for:
"Resetting SMC on portables with a battery you should not remove on your own".
5. Applications > Utilities > Audio MIDI Setup
Audio Devices window
Side Bar
Click the Built-in Output.
Under Mute any of the boxes checked? If so,uncheck it.
6. System Preferences > Sound> Sound Effects
Play sound effects through:
Select "Internal speakers" and then back to "Selected sound output device". -
I have a problem in iPhone . When you receive a contact and press the key at the top to cancel the contact screen stopped working .ataml times after the last restart device
Since restarting did not help, reset your iPhone, see: Turn your iOS device off and on (restart) and reset http://support.apple.com/kb/ht1430
If that still does not solve it, check, if the contact you are trying to add is problematic. Try to save a different contact. Does that work?
If not, reinstall the Contacts app. This is only possible by restoring your iPhone, unfortunately.
See: Use iTunes to restore your iOS device to factory settings http://support.apple.com/kb/HT1414
Maybe you are looking for
-
Hi, I've been looking to get a cable to connect my macbook to a normal widescreen CRT TV. I found the Apple Mini DVI to Video cable on the website, but it doesn't list the Macbook as one of the compatible systems. Can someone let me know - preferably
-
If I have a new apple ID and password do I lose all of my old apps if I sync under the new apple ID?
If I have a new apple ID and password, do I lose all of my old apps if I sync to my new apple ID?
-
Hi guys. I've had my MacBook Pro for 2 years now. Last night it suddenly kept glitching to a dark grey screen every now and then, then it would flash yellow / blue spots, and now it won't go past the grey screen even when I reboot it. I don't think I
-
Facetime & Mail not working(in India).
When i start Facetime & enter my apple id & password after sometime it says"Could not sign in.Please check your network connection and try again".what is the problem.In case of Mail,I followed the instruction given online by Apple.End result is i get
-
SSL on Oracle HTTP causes errors in IE 6/7/8
Hello, We installed new SSL certificate on Oracle HTTP server (Centos, Linux, Oracle 10g) and getting an error in IE 6,7,8: res://ieframe.dll/dnserror.htm#https://... Examining http headers provide following error description: ERROR_INTERNET_SECURITY