EA6500 does not list AppleTV devices

I have an EA6500 and have three AppleTV... all three generations.l I also have a DirecTV Genie and DirecTV HD-DVR that, together, provide whole-house viewing. When I first setup the EA6400 based network, all three AppleTVs were listed and my whole-house viewing worked. This past Saturday, however, that changed, when I couldn't see the programs recorded on the HD-DVR, from the Genie. My troubleshooting determined one of the AppleTVs had been assigned the same address as the HD-DVR upstairs and that the HD-DVR wasn't listed as being connected. Once I reset everything, the IPs resolved and the whole-house viewing was resolved, however, none of the AppleTVs are listed as connected, even though they are. I can check the connections by the AppleTV device and see that they do, indeed, have an IP address, and I can view material from the iTunes cloud or stored on another PC in the local network. I reset everything again, but to no avail. No AppleTV devies show as connected from Smart Wi-Fi. The AppeTVs are all wired to the LAN... not wireless.
So, the question is, is there a fix to get AppleTV devices to list? All of my devices and router have the lastest firmware. BTW, I had a WRT610N, which I'm now useing as an access point, didn't have this issue.

Correcting myself... my 3rd gen AppleTV is wired through a switch to the EA6500. The other two AppeTVs are wirelessly connected.
Here's my config... (the only devices that don't show up are the AppleTVs but, they have IP addresses, are connected to the network, and they work)...
Internet
---Motorola Cable Modem
------EA6500
---------PC1
---------switch1
------------TV
------------DirecTV Genie
------------AppleTV (3rd Gen)
------------Blu-Ray DVD
------------XBox 360
---------switch2
------------WRT610N
------------PC2
............PRT1
............PRT2
............AppleTV (1st Gen)
............AppleTV (2nd Gen)
............DirecTV HD DVD
............iPad1
............iPad2

Similar Messages

My iTunes does not list any devices when I plug in my new iPhone to the computer. how do I get iTunes to recognize my new phone?

My old iPhone died, so I just got a new one. I am hooking it up to my computer for the first time. The iTunes on my computer doesn't show any devices as being hooked up to the computer when I plug in my iPhone. Yet my iPhone is charging so I know it is connected to the computer. Any suggestions on how to get my iTunes to recognize the new device? Thanks

Make sure that your music is in the format supported by the iPhone. I use either MP3 or AAC.
A friend had the same problem a while back. All his music was in the WMA format and is therefore not playable on the iPhone and would not copy. Once he converted his songs to MP3 they copied to his iPhone without problem.

I want to transfer a movie I have downloaded from itunes to my new IPAD. I have been on the itunes help menu, it tells me to look under 'devices' tab for IPAD. BUT there is no 'devices' tab and it does not list my new IPAD. Help!

I want to transfer a movie I have bought in itunes to my new IPAD. I have been trying to work how to do this for 3 days now. I have accessed all the itunes help and forums and wiki online. They all tell me to go to the DEVICES tab on itunes and select IPAD then sync. YUP seem simple, BUT there is not DEVICES tab listed on my itunes and it does not list IPAD. Years ago I set up my IPOD no problem and that is listed, but not the new IPAD. Can anyone help? I would love to be able to actually watch films on my IPAD!! thanks

If you have iTunes 11 on your computer then you can enable the left-hand sidebar on it via option-command-S on a Mac, control-S on a PC - when connected (and if your computer's iTunes is up-to-date) your iPad should then appear on that sidebar under a 'Devices' heading :
If you select the iPad on that sidebar you can then use the Movies tab on the right-hand side of the iTunes screen to select and sync that film to your iPad's Videos app.
Has your iPad been synced to the computer before ? If not then you might find this page for syncing to a new computer useful : https://discussions.apple.com/docs/DOC-3141

HT1386 itunes does not list ipod touch as a device

itunes does not list ipid touch as a device

iOS: Device not recognized in iTunes for Mac OS X
or
Try
iOS: Device not recognized in iTunes for Windows
I would start with
Removing and Reinstalling iTunes, QuickTime, and other software components for Windows XP
or
Removing and reinstalling iTunes and other software components for Windows Vista, Windows 7, or Windows 8
Before you reinstall the Apple software, also remove iCloud vi Control Panel Remove programs. The reinstall the Apple programs
New cable and different USB port?
Runs this and see if the results help with determine the cause
iTunes for Windows: Device Sync Tests
Try on another computer to help determine if computer or iPod problem

Trying to get ESN off of iPad but iTunes on my laptop does not list devices in the left hand column

I am trying to get my ESN off of my iPad but iTunes on my laptop does not list Devices in the left hand column

i am not sure the pad will have an esn. that is a phone based system that is being replaced by the meid number. Can you find that?
Just out of curiosity, what do you need the esn for?

TS4006 Device does not appear in device list

Device does not appear on device list

Welcome to the Apple Support Communities
It happens when you haven't registered that device in Find my iPhone. In the device you want to use with Find my iPhone, log in iCloud following these steps > http://www.apple.com/icloud/setup Then, turn on Find my iPhone, and the device will show up in the device list

T430 NVidia GPU not listed in device manager

Hello -- I have a problem regarding the NVidia NVS 5400M inside the Thinkpad T430. I use Windows 8. I'm not exactly sure how it happened, but the NVidia card no longer shows up in Device Manager and the NVidia driver (both the standard driver from their website AND Lenovo's Optimus driver) refuses to install, complaining it can't find any compatible hardware. Device Manager does not list any graphics cards or unknown devices, and as far as Windows is concerned the NVidia card does not exist.
Here's a summary of what I see:
In Discrete Graphics mode -- my Linux installation (which uses native NVidia drivers) works fine and uses the NVidia card. Windows 8 boots and runs with a generic graphics driver; there is a performance hit, and no graphics cards or unknown devices are listed in Device Manager. That's the problem I want to fix.
In Optimus mode -- Windows 8 boots and runs with the Intel integrated graphics (Intel HD Graphics 4000) which is listed in Device Manager. Again, no other graphics cards or unknown devices are listed.
I appreciate in advance any help towards getting the NVidia drivers installed successfully!
Solved!
Go to Solution.

nsrathjen wrote:
Yep, still doesn't appear that the NVidia drivers from that package are installing. If I boot in Optimus mode, only the Intel card is shown in Device Manager. I'd like to not have to use Optimus and just stay in Discrete Graphics mode if possible because Linux support for Optimus is not very good.
Would completely uninstalling all the drivers possibly help?
Before you go through that hassle, try the following:
1. Go into the BIOS Configuration Display setting and change it to Discrete only. If you see a setting just below display that talks about OS detection, disable that as well otherwise it will try to flip back to Optimus. F10 to save and exit.
2. Go back into the BIOS settings and verify the setting was really saved. Exit the BIOS settings (discarding this time) and boot Windows normally.
3. Go to C:\DRIVERS\WIN\VIDEO\NVIDIA and run setup.exe. Use the Custom option for the mode after it does compat checks and asks for you to agree to the EULA.
4. When you see the list of custom installation options, turn on the "Perform a clean installation" checkbox. This should not present a problem if you don't have custom profiles.
See if that works.

G500 - Bluetooth not listed in device manager

Hi,
Bluetooth is not listed under device manager
it doesn't appear in pc settings/pc and devices neither does the bluetooth switch appears une aiplane mode
my model;
product: 20236
serial: xxxxx
thx
Moderator comment: Serial number(s) removed to protect member from mischief.

Hi guys,
I see that Shiv_K is helping you out on this
In addition.
Try to refresh the Hardware and Power.
    Remove AC and Battery
          Hold the Power Button down for at least 15 sec. Then Reconnect Everything back
Turn on the Systen and Right away start hitting F2 to load the BIOS Utility
          Inside BIOS hit F9 then Enter for Yes to load defaults
          Hit F10 to Save and Exit then Enter for YES.
now open
    Control Panel / Programs, and uninstall Lenovo Energy Management and restart the system
Then install these
Lenovo Energy Management
Intel Wifi Driver
Press Fn+F5 and see if you will be provided with this window showing the bluetooth..
Spoiler (Highlight to read)
Hope this helps,
Cheers
Did someone help you today? Press the star on the left to thank them with a Kudo!
If you find a post helpful and it answers your question, please mark it as an "Accepted Solution"! This will help the rest of the Community with similar issues identify the verified solution and benefit from it.
Follow @LenovoForums on Twitter!

Ipad not listed in devices, ipad not listed in devices

ipad 2 is not listed under devices in itunes. Have tried everything listed on apple help list & it stiil does not list my ipad2 under devices. Ipad makes a ping noise when i connect it to my laptop. Any suggestions?

Windows
http://support.apple.com/kb/TS1538

Hp officejet 4500 prints but does not appear in devices and printers in Windows 7

My wireless hp officejet 4500g prints fine wirelessly but it does not appear in Control Panel Devices and Printers in Windows 7. Do I have to go through all that uninstall and reinstall. I've used Window 7 Troubleshooting Printer check and all was fine.. Thanks for any help

Hi,
If the printer successfully print, it do exists within Devices and Printers..
Windows 7 may merge several devices into a single icon, right clicking a merged icon will let you then choose the specific device as you may see in the following screenshot as a sample:
Check any existing printer icon and locate the one your printer combined with..
If none of the printers does not list the 4500 printer make sure to right click the Computer icon within the Devices category, I notiice the printer sometimes merged within the computer as well, then you will see any printer options (e.g. Printer Properties, Printing Preferences within the computer menu.
Hope that may help,
Shlomi
Say thanks by clicking the Kudos thumb up in the post.
If my post resolve your problem please mark it as an Accepted Solution

Visa Resource name does not list anything

Hi,
I recently installed a Agilent 82357B GPIB and along with it I also installed Agilent IO 16.3. This GPIB is hooked up to a power supply. I am able to find and query the device in MAX and Agilent IO, but when I use the Visa Resource Name control in a VI, it does not list anything. Before I used to see LPT1 and COM1, but now even they have disappeared. All these are present in Device Manager. Even VISA interactive control throw an error. Attached are screenshots for some reference.
HP_GS
Attachments:
VisaResource-Refresh.png ‏2 KB
Visa-IC.png ‏7 KB

Hi there,
You might want to read this post about the specific error.
Also you need to make sure the right class is slected for the visa resource (right click):
Hope that helps, regards W

My new Ipad 2 wifi does not charge and itunes does not find my device when pluged into my pc

My new Ipad 2 wifi does not charge and itunes does not find my device when pluged into my pc. Help

You should probably start here and go through all of the troubleshooting steps and then report back if you are still having problems.
http://support.apple.com/kb/TS1538

My iPhone 4s does not appear on devices when connected to iTunes in my Mac

My iPhone 4s does not appear on devices when connected to iTunes in my Mac

Check to make sure you have enough free space to include the videos.

I had a new hard drive replaced in my imac. Now my 1st generation apple TV does not appear under devices in itunes. How do I get my apple tv to connect to my computer? My OS is 10.6.8

I had a new hard drive replaced in my imac. Now my 1st generation apple TV does not appear under devices in itunes. How do I get my apple tv to connect to my computer? My OS is 10.6.8

Welcome to the Apple Community.
Navigate to Settings > Computers > Your Library on the Apple TV, you may be told you will lose all synced content, but you can't doing anything abouty this, you won't lose any purchased content that has yet to be transferred. Then select Settings > Computers > Connect To iTunes, note the passcode that appears on screen, click on the device in iTunes and enter the passcode when prompted.

I bought an apple iPod 5th generation the other day and I cannot remember the unlock passcode. I have done the restore thing, but because I never set it up or synced it with iTunes, it does not recognize my device. It is disabled for one hour. Please help

I bought an apple iPod 5th generation the other day and I cannot remember the unlock passcode. I have done the restore thing, but because I never set it up or synced it with iTunes, it does not recognize my device. It is disabled for one hour. There's only a few things that could be my passcode, but because it disables for an hour, it is time consuming trying to figure it out. What do I do? I do not care about having to erase everything since it's new and there's nothing on it, but it was never synced with iTunes.

Disabled
Place the iOS device in Recovery Mode and then connect to your computer and restore via iTunes. The iPod will be erased.
iOS: Wrong passcode results in red disabled screen
If recovery mode does not work try DFU mode.
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
For how to restore:
iTunes: Restoring iOS software
To restore from backup see:
iOS: Back up and restore your iOS device with iCloud or iTunes
If you restore from iCloud backup the apps will be automatically downloaded. If you restore from iTunes backup the apps and music have to be in the iTunes library since synced media like apps and music are not included in the backup of the iOS device that iTunes makes.
You can redownload most iTunes purchases by:
Downloading past purchases from the App Store, iBookstore, and iTunes Store
If problem what happens or does not happen and when in the instructions? When you successfully get the iPod in recovery mode and connect to computer iTunes should say it found an iPod in recovery mode.

EA6500 does not list AppleTV devices

Similar Messages

Maybe you are looking for