Elements 4.0 did not capture entire 1 hour miniDV tape contents

Question

I used Elements 4.0 for the first time and in capturing the footage on a one hour tape, it stopped after 46 minutes and gave some sort of message (I failed to write it down at 1 AM) to the effect "Exceed Threshold 699KB".
Why would Elements not capture the entire 1 hour?
Thank you.

Answer 1

I still cannot drag the template into Video 1 or 2.
You would only use Video 1, if you had no Asset that you wished to "show through" the "hole" in this Title. If you have Assets on both Video 1 & 2, you would use Video 3, otherwise, use Video 2 above whatever you wish to see through the hole.
Do I need to be in Edit or Create Menus?
Edit Mode.
Let’s try this from the ground up, shall we?
In Timeline View Mode, click on the Edit tab. Then click on Titles and navigate to General (Show All) and navigate to the Canvas Titles. In PrE 4.0, there are two. We will use Canvas_frame.
Look at your Timeline display, and make sure that you have either an empty Video 2 or Video 3 Track, above the Clip that you wish to "show through" the "hole" in Canvas_frame. There is a zoom slider at the top of the Timeline Panel. It is to the right of a little double clock icon (the TimeStretch icon). Slide the black bar in this slider to the right, to expand the horizontal view of the Timeline. You may have to scroll (bottom of the Timeline Panel) the Timeline’s view back and forth a bit, until you have the area, where you wish to place the Title, in full view.
In the Titles Panel (this is really an extension of Organize, but automatically shows the Titles, which are part of the Functional Content, installed along with the program files in PrE), click-drag on Canvas_frame. While holding down the left mouse button, drag it to the spot you desire on Video 2 Track, or Video 3 Track. If you only have Clips/Assets on Video 1 Track, choose Video 2 Track. Let’s assume that this is your case and that Video 2 Track is empty above your Clip in Video 1 Track. The cursor will change to include the little Insert Edit icon, but that is not important, as we are placing this Title onto an empty Video Track. When the Title is over that Video Track, you will get a long white line with two little right-facing arrowheads. Depending on what you have on your Timeline, it might not be easy to see the lower of these. When you have positioned your Title onto Video 2 Track, you can release it and it will stick there. You can move it along the Video 2 Track, as is required. You can also change the Duration of the Title by click-dragging on either the Head, or the Tail, of the Title.
Done.
If this is not working for you, then there is something very wrong with either your installation of PrE, or with your system.
Now, a couple of questions:
1.) I assume that when, in Edit Mode, you click on Titles, you open up the Title Templates, and can find the Canvas_frame. Is this correct?
2.) I assume that you have an empty Video (2, or 3) above the Clip, over which you wish to place this Title. Is that correct?
3.) If one clicks and drags (holding down the left mouse button, for right-handed mouse settings) on something (say a Clip in Organizer) in PrE, it can be dragged to the Timeline. Does this happen for you? Can you click-drag on Clips in Organizer and get them to the Timeline?
Good luck,
Hunt