Enabling Logging on an ASR from a source port

Question

I have a Cisco ASR 1001.  I am trying to send traffic from g0 to a switch that picks up all my logging traffic.
Below is my config.  What am I missing.  I am trying to send traffic to device 10.10.23.17. I want to make sure that ll traffic get to 10.10.23.17.
Thanks in advance!
logging trap debugging
logging facility local1
logging host 10.10.23.17
ip route vrf Mgmt-intf 0.0.0.0 0.0.0.0 10.10.88.1

Answer 1

Syslog logging: enabled (0 messages dropped, 11 messages rate-limited, 0 flushes, 0 overruns, xml disabled, filtering disabled)
No Active Message Discriminator.
No Inactive Message Discriminator.
    Console logging: disabled
    Monitor logging: disabled
    Buffer logging:  disabled, xml disabled,
                    filtering disabled
    Exception Logging: size (4096 bytes)
    Count and timestamp logging messages: disabled
    Persistent logging: disabled
No active filter modules.
    Trap logging: level debugging, 553 message lines logged
        Logging to 10.10.23.17  (udp port 514, audit disabled,
              link up),
              121 message lines logged,
              0 message lines rate-limited,
              0 message lines dropped-by-MD,
              xml disabled, sequence number disabled
              filtering disabled
        Logging to 10.10.89.74  (udp port 514, audit disabled,
              link up),
              2 message lines logged,
              0 message lines rate-limited,
              0 message lines dropped-by-MD,
              xml disabled, sequence number disabled
              filtering disabled
        Logging Source-Interface:       VRF Name:
        GigabitEthernet0                Mgmt-intf