Entered correct wifi key, won't connect - iPod Touch 4G iOS6.0.1

I am attempting to connect to my work's wifi network with my new iPod Touch 4G iOS6.0.1. I entered the correct password and it just sits on the main wifi page with the loading wheel next to the network but never connecting. I tried doing a hard reset, resetting the network settings to factory settings, and the "renew lease" option. I am 100% sure I entered the key correctly, as I have successfully connected my old iPod touch 3G iOS4.2.1 to the network with the same network key and have been able to use the internet and such.
Why won't the network connect on my new iPod Touch? Is it the new iOS6.0.1 that is having issues? What can I do to remedy it besides what I've already tried?

I should add, I just now reset my network settings and tried to manually add the network (Typing in the network name, security type, etc.) and it did the same thing at first but now it is telling me "Unable to join network ____".

Similar Messages

  • When try to connect my iPod touch 4th gen to my house Wifi it won't connect, it used to work fine but now it dosen't work, but it does say that the internet is available, but when I tap on it it just loads. all other devices work fine.

    When try to connect my iPod touch 4th gen to my house Wifi it won't connect, it used to work fine but now it dosen't work, but it does say that the internet is available, but when I tap on it it just loads. all other devices work fine.

    Does the iOS device connect to other networks? If yes that tend to indicate a problem with your network.
    Does the iOS device see the network?
    Any error messages?
    Do other devices now connect?
    Did the iOS device connect before?
    Try the following to rule out a software problem:                
    - Reset the iOS device. Nothing will be lost
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Power off and then back on your router
    .- Reset network settings: Settings>General>Reset>Reset Network Settings
    - iOS: Troubleshooting Wi-Fi networks and connections
    - Wi-Fi: Unable to connect to an 802.11n Wi-Fi network      
    - iOS: Recommended settings for Wi-Fi routers and access points
    - Restore from backup. See:
    iOS: How to back up
    - Restore to factory settings/new iOS device.
    If still problem and it does not connect to any networks make an appointment at the Genius Bar of an Apple store since it appears you have a hardware problem.
    Apple Retail Store - Genius Bar

  • Hy won't my ipod touch 5G connect to my computer or itunes? I've tried new USB cables, different USB ports and uninstalling itunes and reinstalling.

    Why won't my ipod touch 5G connect to my computer or itunes? I've tried new USB cables, different USB ports and uninstalling itunes and reinstalling.

    See
    iOS: Device not recognized in iTunes for Windows
    - I would start with
    Removing and Reinstalling iTunes, QuickTime, and other software components for Windows XP
    or              
    Removing and reinstalling iTunes and other software components for Windows Vista, Windows 7, or Windows 8
    However, after your remove the Apple software components also remove the iCloud Control Panel via Windows Programs and Features app in the Window Control Panel. Then reinstall all the Apple software components
    - Then do the other actions of:
    iOS: Device not recognized in iTunes for Windows
    paying special attention to item #5
    - New cable and different USB port
    - Run this and see if the results help with determine the cause
    iTunes for Windows: Device Sync Tests
    Also see:
    iPod not recognised by windows iTunes
    Troubleshooting issues with iTunes for Windows updates
    - Try on another computer to help determine if computer or iPod problem

  • Why won't my ipod touch sync? It is all up to date and everything, and i know it is connected because when i plug it into my computer it charges, but it doesn't even show that it is connected so i can't sync all my new songs:(

    Why won't my ipod touch sync? It is all up to date and everything, and i know it is connected because when i plug it into my computer it charges, but it doesn't even show that it is connected so i can't sync all my new songs:(

    http://support.apple.com/kb/TS1538
    http://support.apple.com/kb/TS1591

  • Just updated to iOS 7. One of my wifi networks won't connect. How do I fix this?

    Just updated to iOS 7. One of my wifi networks won't connect. How do I fix this?

    I imagine the others work though?
    try unplugging the router for a few minutes (restarting it).
    While waiting for it to restart, turn Wi-Fi off/on on your iPhone, then reset network settings in Settings > General > Reset > Reset Network Settings

  • I bought a new ipod touch today and it connects to my wifi automatically... But I forgot my wifi password for my new iPod touch and I don't know how to find it in my old iPod?

    I bought a new ipod touch today and it connects to my wifi automatically... But I forgot my wifi password for my new iPod touch and I don't know how to find it in my old iPod?

    You can usually find the wi-fi password on your router itself if you know the router's ID and password (not the wi-fi password).  You can log into your router by putting its address (usually 192.168.1.1) into your browser's address window. 

  • What to do if an existing contact quits working. Goes to voicemail each time. I've deleted and re-entered it and it won't connect.

    What to do if an existing contact quits working. Goes to voicemail each time. I've deleted and re-entered it and it won't connect. Had this ph number stored in my phone for years. It shows as a missed call on the recipients phone.

    Have you activated any call blocking on your end? This should be the only reason a single caller cannot get through to you.

  • HT204053 why won't my ipod touch connect with itunes?

    Why won't my iPod Touch Gen 4 connect to itunes?

    If you  have iTunes 11 turn on the Sidebar.  Go to iTunes>View and click on Show Sidebar. You can also do a Crtl+S to show the sidebar.
    Then
    iOS: Device not recognized in iTunes for Windows

  • Unexpected "Connect iPod touch to iTunes" screen

    I powered off my 2G Touch before flying to Argentina; then powering up again on arrival brought up a new-to-me "Connect iPod touch to iTunes screen", which no amount of button presses would get past.
    Luckily there was a PC where we were staying, and with iTunes installed, and with USB, so I was able to get going again, esp. since I'd disabled automatic syncing, though now everything was in Spanish. But,
    Q1: does anyone know what this screen really means?, and why it might have come up? [a wifi router was nearby]
    Q2: would a hard reset [hold sleep/wake and home buttons for 10 sec] worked to get past this screen?

    I have the same problem, getting the 'connect' symbol or icon while travelling. I just got off the phone and an unsatisfying conversation with Apple support. Apparently, this is a "rare?" problem that is caused when there is some kind of software failure on the iPod Touch, and that there is no way to get around it except connecting to iTunes on some pc somewhere, ideally your own PC and iTunes. This happened once before for me but I was home and just plugged it in. The iPod recovered, connected and synced with no error message at all. The rep at Apple support said there is no log or trace that can be retrieved, so the mysterious iPod Touch software failure will remain unknown. He said I could take it in for warranty service, but who knows if they could reproduce the problem. Maybe the new iPhone/iPod Touch software version will run better (or worse). ps, I tried all possible combinations of hard reset on the unit, but nothing else works to recover.

  • Connect iPod touch 2G to Reciever using RCA's? It cannot be this difficult?

    Hello!
    Need to connect iPod touch 2G to my reciever using RCA's?
    But +I do not want to use the headphone jack....+ (I heard I will get higher sound quality using the bottom multi-pin connector on the bottom of the touch going to a left and right RCA's) +I have uncompressed (AIFF) files on my iPod touch and want the best sound quality possible.+
    I found a couple companies that make these cables with one being the Cables To Go 4-Feet RCA Stereo to Dock Connector Cable for iPod and also the Nyko Stereo Link for iPod, but from reading the reviews on Amazon neither of them will work with the Touch 2g (or the iPhone for that matter).
    I am also open to a simple dock of some sort that would provide me RCA outputs. Seems as if Apples universal dock would be great but it seems to have NO RCA outputs on the back of it.
    If anyone has a solution to this I would be very very happy!
    +I have looked high and low for a solution for this seemingly simple task.+
    All I want is a connector that goes from the bottom of the touch to 2 RCA's so I can input this into
    my home stereo so I can listen to my ripped CD's in high quality. A dock would also work too! I do not need charging or anything fancy....
    (already have try the Tekkeon NavDock for iPod which was cool because I could watch my videos on tv from my touch but i dont need that)
    +*just looking for something simple that works with the iPod Touch 2G.*+
    *It cannot be this difficult?*
    thanks, techo

    As I stated above, the docking connector is not a "true" line-out, it does have a volume-tap so the volume control will work. It probably is somewhat cleaner than the headphone out (haven't measured it), but it is not going to be a significant difference as any improvement you get from the connector is severely limited by the DAC in the iPod.
    You get no improvement in sound from using the pins on the 30 pin connector versus a 3.5 mm jack. If you buy a Universal Dock it is passing the signal from the 30 pin dock to a 3.5mm female jack, then you use the 3.5mm to RCA. Going directly from the dock connector to RCA will not improve the sound, the 3.5mm connector is not inferior in itself to the RCA connectors.
    The A/V kit will get you the ability to watch your videos on your TV and output the stereo signal to your receiver. If you want even better sound for your music, get an Apple TV and use the HDMI cable to transfer the video and sound:
    http://store.apple.com/us/browse/home/shopipod/family/appletv?mco=MTE4MTU

  • Connecting ipod touch to apple tv to watch filmon

    connecting ipod touch to apple tv to watch film on
    any info please

    See:
    Apple TV: How to use AirPlay Mirroring
    Troubleshooting AirPlay and AirPlay Mirroring
    Using AirPlay

  • How can you connect iPod touch or iPad to TV and watch it what kind of connection?

    How can you connect iPod touch or iPad to your tv and watch it

    Not really anything to do with Apple TV
    If you want to connect an iPad or iPod
    http://store.apple.com/us/product/MD098ZM/A/apple-digital-av-adapter
    http://store.apple.com/us/product/MD826ZM/A/lightning-digital-av-adapter

  • Any way to connect ipod touch 3G to other non apple devices via Bluetooth??

    Hey People,
    I was jus wondering ,
    can i connect ipod touch 3G to other non apple devices via Bluetooth??
    is there any special application which fullfill my wish,
    if it is there, then it will make my day,,,,,,,,,,,,,,,

    no
    bluetooth on the ipod touch only allows for the use of bluetooth stereo headphones and peer-to-peer gaming between two ipod touches (or presumably iphones)

  • Itunes won't recognise ipod touch

    When I try to connect ipod touch get error message that cannot be used as requires itunes version 10.5 or later. Tried to download latest as suggested but no change.  I have itunes on windows xp machine and no problem connecting to nano, classic or shuffle. Help!

    The Nano, classsic and shuffle use differnt drivers than the iPod touch.
    What version of iTunes is stalled on the computer?  In iTune go to Help and then About iTunes.
    Then try:
    iPhone, iPad, or iPod touch: Device not recognized in iTunes for Windows

  • Get iTunes to open automatically when I connect iPod Touch?

    Can I get iTunes to open automatically when I connect to my iMac with the USB connector? I upgraded my OS today to 10.6.8, and now it doesn't happen. (It's a 2nd generation iPod Touch.)
    Thanks a lot!

    Problem solved thanks to another post here on the same topic.
    1-Opened i Tunes & Connected iPod Touch
    2- Unchecked "Open iTunes when connected"
    3 - Synched iPod
    4- Hit "Apply"
    5- Checked "Open iTunes when connected"
    6- Synched iPod
    7 - Hit "Apply"
    8- Ejected iPod and closed iTunes
    9- Re-connected iPod Touch
    10- iTunes opened automatically!  

Maybe you are looking for

  • How to get Zoom value in scroll viewer in C# wpf Kinect SDK 2.0?

    I have recently started using the Kinect SDK 2.0 and am focusing on a zoom and pan functionality, as in the Control Basics-WPF sample. I have got the zoom and pan functionality up and running. The problem is that I wish to access the value of the amo

  • Backup a pc to time capsule

    Can a Windows XP PC be backed up to an Airport Time Capsule?  If so, what is the process?

  • Diff between oracle 8i sql Engine and oracle 9i sql Engine

    hi, 1)Can anyone tell me difference between oracle8i sql engine and 9i sql engine. 2)Does oracle 9i uses the index defaultly if any primary key is there in table Thanks Rama

  • FB03 - Short Dump - is not Unicode-compatable

    hi gurus, i have a short dump in PRODUCTION in TCODE : FB03. the short dump says that  syntax error in program : RK2RS001 is not UNICODE-COMPATABLE in program attributes... how can i resolve this one pls... thanks in advance, pasala.

  • Problem in ALE inbound With process code

    i want to give a function module to the in bound process code in transaction WE42 but i am not able to give the function module name .after giving the function module name if i say save system giving message "The ALE table is not yet maintained for p