Equium M50 will only connect to WLan router when security is off

MY Equium M50 will only connect to my wireless BELKIN G+ MIMO ROUTER when the security is turned off,
What is the reason for this please?
Blonde Bimbo!!

Hello
Did you mean the WLan encryption which secures the entry to the wireless LAN?
I suppose you have set the encryption (WPA, WEP, etc...) on your WLan router but didnt configure the WLan card.
Well, in my opinion you should check which WLan encryption does the card support and then choose it on the WLan router. The encryption key should be set on the router and on the notebook!

Similar Messages

HP Pavilion laptop only connect to the internet when security is turned off

My HP Pavilion laptop running windows vista sp2 connects to the internet only when wireless security is turned off on my airport extreme (brand new purchased last week). Once I set-up wireless security my laptop shows local network access only and I lose my internet connection. Also, when I try to get back into the setup utility I get the following error message “an error occurred while trying to access the apple wireless device” and I cannot make any changes to my airport extreme set-up. I have tried many restarts and resets, but have only been able to connect properly with my laptop when wireless security is off. Additionally, during my setup attempts, my iphone has always had internet access. Greatly appreciate if anyone can offer ideas on how to fix this.

Have you tried resetting the modem and restarting your computer?

My 3Gs iPhone will only connect to the WiFi when it's very close to the Time Machine., My 3Gs iPhone will only connect to the WiFi when it's very close to the Time Machine.

This has happen over the last few weeks' I've never had a problem in the past.
I have rebooted the 3Gs, Time Machine and router with no effect.
I have an iPad and my Wife's has a Iphone 4s which both connect with no problems.
Can anybody help?
OR does mean I will have to buy the new iphone in Sep!!!!

Well either way, get the new iPhone in september, and if this gives you a reason to do so, by all means go for it. Haha, but other wise your 3GS might be having a problem reading the wifi signal, that has happened to my first iPad and took it to apple and they said that the internal iPad part had gone bad.

HT3131 MY macbook pro will only connect to my TV when the lid is open. When I close it to enter clamshell mode my TV gives me a error message saying "resolution mismatch." i have tried switching cables and using different TV's. it works on all my other TV

It works all my other TV's except my Magnavox 39 inch. i have made sure that the resolutions are compatible.

Yay! Solved my own question; just did a hard shutdown, worked like a charm! Funny, didn't before. But who am I to question salvation?

My iPhone 5 will only connect and keep connected if I am about 5feet away from my router. It also will not pick up other wifi sources and will drop Bluetooth. What can I do to solve this problem?

My iPhone 5 will only connect and keep connected if I am about 5feet away from my router. It also will not pick up other wifi sources and will drop Bluetooth. What can I do to solve this problem?

Are there any other wireless devices that might cause interference?
Also are there any nearby Wi-Fi networks that might have the same name as yours? It amazing how many Linksys Wi-Fi networks are out there.

Ay suggestions to connect my iPhone 5 to the Internet, it will only connect when sat next to the rooter, I have reset signals on both ?

Ay suggestions to connect my iPhone 5 to the Internet, it will only connect when sat next to the rooter, I have reset signals on both ?

What version of iOS?
Is the router running the latest version of available firmware?
Are any other devices having issues connecting to the router?
Does the iPhone have the same issue with other Wi-Fi hot spots?

My ipod only connects to the wifi when i am in the room of the router. as soon as i go out of the room into some other room it disconnects and doesn't connect again. unless i go to the room of the router. i have an ipod 4 with ios 6.1.6

my ipod only connects to the wifi when i am in the room of the router. as soon as i go out of the room into some other room it disconnects and doesn't connect again. unless i go to the room of the router. i have an ipod 4 with ios 6.1.6

Does the iOS device connect to other networks? If yes that tend to indicate a problem with your network.
Does the iOS device see the network?
Any error messages?
Do other devices now have this problem?
Did the iPod stay connected before?
Try the following to rule out a software problem:
- Reset the iOS device. Nothing will be lost
Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Power off and then back on your router
.- Reset network settings: Settings>General>Reset>Reset Network Settings
- iOS: Troubleshooting Wi-Fi networks and connections
- Wi-Fi: Unable to connect to an 802.11n Wi-Fi network
- iOS: Recommended settings for Wi-Fi routers and access points
- Restore from backup. See:
iOS: How to back up
- Restore to factory settings/new iOS device.
If still problem and it does not connect to any networks make an appointment at the Genius Bar of an Apple store since it appears you have a hardware problem. Could be a loose antenna connectin
http://www.ifixit.com/Guide/iPod+Touch+4th+Generation+Wi-Fi+Antenna+Replacement/ 3640
Apple Retail Store - Genius Bar

I have a Iphone 4 gsm (8f190) and it will not connect to itunes and when i put it in recovery itunes will not work. It won't show up when plugged into the computer. Only charges when plugged in the wall or a car charger.

I have a Iphone 4 gsm (8f190) and it will not connect to itunes and when i put it in recovery itunes will not work. It won't show up when plugged into the computer. Only charges when plugged in the wall or a car charger. I've tried everything imaginable but I can't get the phone to register in iTunes at all.. The phone won't even reset.. when i try and reset EVERYTHING on the phone the apple logo with the progress bar starts to come up but the progress never moves.. PLEASE help me.. I'm at my wits end with this phone and I'm ready to just trash it.

martinfromdevon wrote:
Warning to iPhone users. Do not start the update of the iPhone software using iTunes.
Nonsense, and very misleading advice. I've updated iPhone 3G, 3Gs,and 4 through itunes many times, never had a problem once, not with one single update in nearly 5 years of iPhones. Of course, I've never jailbroken my phones either. Hack your phone and have update problems? I've got news for you, the problems are not a result of iTunes or Apple's updates.

I have a Iphone 4 gsm (8f190) and it will not connect to itunes and when i put it in recovery itunes will not work. It won't show up when plugged into the computer. Only charges when plugged in the wall or a car charger. I've tried everything imaginabl

I have a Iphone 4 gsm (8f190) and it will not connect to itunes and when i put it in recovery itunes will not work. It won't show up when plugged into the computer. Only charges when plugged in the wall or a car charger. I've tried everything imaginable but I can't get the phone to register in iTunes at all.. The phone won't even reset.. when i try and reset EVERYTHING on the phone the apple logo with the progress bar starts to come up but the progress never moves.. PLEASE help me.. I'm at my wits end with this phone and I'm ready to just trash it.

Dude you have a jailbroken phone as stated in your first post, no need to do a second post.
As per the forum term of service you can't get help here. Use google.
that's the downfall of jailbreaking your phone.

7510-e-all in one - c311a will not connect to my router dlink wbr-2310.

I just bought HP Photosmart 7510 e-All-in-One-C311A and it will not connect to my router which is a DLink WBR-2310. The diagnostic results are as follows:
Wireless On: PASS
Wireless Working: PASS
Connected: Not Run
Disconnect count total: 0
Disconnect count (last hour): 0
Disconnect count (last 24 hours): 0
Network Name (SSID) Found: PASS
Other Networks detected matching your network name (SSID) No
Wireless Networks Detected: 10
Printer Settings Consistent with Wireless Router Settings: PASS
No Filtering: FAIL
Channel: Not Run
Security: PASS
I have checked to make sure MAC addres is not enabled. I have tried turning off computer, router and printer. Please help. I have Windows 7.
Thanks very much!

Hi,
This is how I installed my printer last week (also a 7510).: Using USB cable to connect it to a computer on your network and setup from there. It will ask you to use similar setup for your computer, just accept this The setup was no longer than 5 mins.
Please also check this:
http://h10025.www1.hp.com/ewfrf/wc/document?docname=c02900814&lc=en&cc=us&dlc=en&product=5070121
Regards.
BH
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.

My iphone 4s will only connect to my home network.

My iphone 4s will only connect to my home network. Any other I join (eg:starbucks) internet says connection error. Even though the phone says it's connected.

Since I have upgraded the the latest iOS in my iPhone 4S , this problem started and eventually the white button for Wi-fi stopped working. The one day before switching off the phone , I took out the SIM and reset the Networking and didn't switch on. Then I wrapped the phone with tissue paper and kept it in the deep refrigerator for 25 to 30 minutes and after cleaning frosty layer, I turned on the phone.... Somehow the Wi-fi button started working and the Wi-fi network too. Then only I inserted the SIM . Magic..!! My phone is still working fine . But I have to do this process once or twice a month every time Wi-fi stops working. Good luck my friend....hope you get benefitted !!

Can only connect to Linksys E4200 when very close but PCs can connect at 50 feet. What's the solution?

Can only connect to Linksys E4200 when very close but PCs can connect at 50 feet. What's the solution?

If you're technically comfortable in getting to your Linksys settings - try changing the network mode or channel in your router's settings.
I still use my old Linksys router and when it's set to the default channel, which is 7, my Macbook Pro and Macbook Air sometimes have issues - changed the channel to 9 and have had no issues since.
Maybe it might work for you.
In any event - screenshots below are for your E4200 and play with those settings and see if any of the changes you've made improves how your Macbook connects. Before you change any settings, just remember what the old settings are in case you need to go back to your old settings.
Good luck.

Imac will not connect to Airport Extreme when configured WPA/WPA2

Imac will not connect to Airport Extreme when configured WPA/WPA2
Posted: Jul 5, 2007 8:22 PM Reply
I just got my Imac to connect to the internet using my Airport Extreme but only by using WEP. I had my Windows XP SP2 machines connecting using WPA/WPA2 with no problem. The Imac will not connect using anything other than WEP, and 1 of the XP machines will not connect using WEP.(I have not tried the other XP machines) I had to set the Airport Extreme for an open network in order to let both computers access the shared hard drive and access the internet.
I don't know what the problem might be and would appreciate any suggestions.
MacBookPro, Imac Mac OS X (10.3.9) Fujitsu tablet PC, 2 XP desktops

hehe...on the visuals. I figured it out already, and I have the old airport card. However, I did a chat with Apple support and while we were chatting I found a USB adapter with MAC drivers which will work. It is:
Hawking Technology HWUG1A Wireless-G USB Adapter with Removable Antenna for Macintosh
Manufacturer Part# HWUG1A
That is the only adapter that actually does WPA/WPA2 that I can find that is for a Mac and not just an older USB that only does WEP. It surprises me that Apple does not have a USB product like this. Anyway, for $56 including shipping, I will have it by Monday or Tuesday. Pretty cool.
Thank you so much for your assistance. It is appreciated.
Lynn

Both my iphone 4s and my ipad3 will not connect to the server when trying to access my email account. Why, and how do I fix it.

Since 29/10/2012 my iphone 4s and more recently my ipad 3 will not connect to the server when trying to access my email account. All I get is an error message saying that 'cannot get mail, connection to the server failed' I hadnt changed any settings it just happened. I have since done a complete re-boot on the ipad but to no avail. Anybody got any suggestions?

No. Everything was working fine and then it wasn't. I hadn't changed any settings or switched either one off. When the phone stopped working properly I ignored it because I always have my ipad with me but that just sopped working properly and now I am stuffed. I have tried most solutions suggested on here even wiping the ipad clean and re-booting. I did this exactly the same way as when I first got it but still no joy. The same with the phone.

IPhone 3G and iPhone 3GS won't connect wirelessly at home when PCs are off.

Dear Apple.com,
I have been using iPhone 3G and iPhone 3GS wirelessly at home no problems.
I use a MAC filter on an unsecured wireless network. Only entered MAC addresses can connect wirelessly.
However, when I turn off all the PCs at home the iPhone find the wireless network and show connected, but cannot browse websites.
The router Linksys WRT610N is always on, so the wireless connection and permission for the iPhone MAC addresses to access the wireless connection should work?
Any ideas?

Is your router a model that supports a/b/g/n? If you turn off N will it work? If your N is setup at 40MHz slots it may not work as well. Can you take your wireless router somewhere else for testing? I assume you might have some issue where you are at with your Mac and that router. When you open Apple Menu/About this Mac/More Info../Network/Airport does it show your network there? From a working machine can you see your Mac from your router web interface? FYI if your router was an Apple product(Airport Express or Airport Extreme/Time Capsule) you could see all your wireless clients via the Airport Utility, even signal strength and connection speed...

Equium M50 will only connect to WLan router when security is off

Similar Messages

Maybe you are looking for