Error -65581 when using 9146 in hybrid mode

Question

I have a 9146 cRIO Expansion Chassis and I have FPGA code that uses two modules and I'd like to use the scan engine to read the other two modules (ie hybrid mode).  When I try to read scan engine module data, I get error -65581:
"CompactRIO:  (Hex 0xFFFEFFD3) The bitfile currently running on the CompactRIO chassis is not configured to support using the RIO Scan Interface in this slot. In the LabVIEW Project window, move the module in the slot from under the FPGA target item to under the chassis item, then recompile the bitfile."
I recompiled my FPGA code and redeployed everything but it did not make a difference.
Here is a snapshot of my lvproj file:
I get the error (-65581) whether I read "Analog In" or "PV Read" IO variables.
Note that my scan engine looks OK from Distributed System Manager:
I can confirm the FPGA code is running (am blinking the FPGA LED in my FPGA code and can see it blink).  Also, if I switch from "FPGA" to "Scan Engine" mode, I can get the AI Readings to read without an error.
I'm using the software below on my RIO:
Thanks in advance!

Answer 1

Upgraded to cRIO 2013SP1 and still have the exact same errors.  Once I deploy in FPGA mode, the scan engine modules do not update their IO variables (in Distributed System Manager the variable status says "connecting" instead of displaying the current value.  Do you have any other suggestions?
Is Hybrid mode supported on cRIO 9146 (which is an Expansion Chassis)?