Error and weird behaviour in executable launch

Question

Hello folks,
This post is regarding a weird behaviour i am experiencing with an executable i built. 
LABVIEW version(Includes Runtime engine) LV2012 SP1 f3
DAQmx: 9.6.1
The behaviour is listed below in detail. 
In a nutshell, the exectuable runs on the development computer but does not run on the Target computer. Also, Irresepctive of which PC i run the executable on, i cannot access the block diagram even after enabling debugging everywhere. 
On the target PC, the app fires up but does not run further, no error codes appear on the screen, it's like the app freezes after firing up. And to add to the misery, i cannot access the block diagram to debug and know what's going on. 
Also, I have tried including the dynamic vis to my build script. No bueno. 
What I see on running the app is addressed below:
TARGET COMPUTER:
DAQmx 9.7 and LV2012 SP1 f4 RTE have been installed manually.
App does not run: No broken run button, the app launches but does nothing when the vi is run. No error messages.
The block diagram is still inaccessible, even after selecting the “Enable debugging” option in the build specifications.
DEVELOPMENT COMPUTER:
The app launches and runs perfectly.
The block diagram is still inaccessible, even after selecting the “Enable debugging” option in the build specifications.
DAQmx 9.7 and LV2012 SP1 f4 RTE were not installed as the app recognized the already installed Labview environment.
Additional steps that I have tried,
 Created and ran only an executable on the target PC, the attempt was unsuccessful. The vi showed similar characteristics as mentioned above in the target PC section.
 Created and ran an installer with additional install options(LV2012 f4 RTE and DAQmx 9.7)on the target PC, the attempt was again unsuccessful. The vi showed similar characteristics as mentioned above in the target PC section.  No error messages.
 Tried both the steps mentioned above on the development computer and the attempts were successful. .
To the best of my knowledge, I believe, the issue here is with the environment I am creating for the executable and the installer to run with/off of. After having carefully followed the installation procedure for the Run-Time Engine and the DAQmx drivers, I still do not know what I am missing. 
Please advise.
Thanks guys, 
RP.

Answer 1

Hey guys, 
So, got the application to work. Almost. 
The problem was that the executable was missing the hardware config from the Device. 
Now, the new issue is as following: 
The goal of the vi is to generate a report of the test conducted. So, the way the vi works is that, the second the vi is run, an empty word file is created with only the company logo,  
Field headings, which are populated after the test is conducted. 
The logo is a .jpg file, which has a relative path into the executable.
The field heading are String constants wired into a 'concatenate strings.vi' which are in turn wired to into the report generation vis.
What's happening is that when i run the app on the target pc, Only the logo appears on the word template. Even when i conduct the whole test and stop the vi, the results aren't populated in the word file. Which is a little weird.
Does any one know whats doing that?
Please refer to the attached word files.
Right - It is the file format desired. 
Wrong - It is the file format achieved. 
Please advise.
Thanks,
RP. 
Attachments:
Right.docx ‏17 KB
Wrong.docx ‏16 KB