Error during iPod update
Whenever I plug my 60Gb iPod in, it shows up just fine and everything that it should. Be soon after I click "Update iPod" it stops and says "Unknown disk error" now i have done everything, re-install, deleting, formatting.... like it doesnt help! It's not a particular song either cuz you'll then try again and it will work for acouple songs and then break down again. Can anyone give me advice? was it something I did on setup?
Welcome to Apple Discussions!
Make sure that everything on the CD was updated...
http://www.apple.com/ipod/download
http://www.apple.com/itunes/download
btabz
Similar Messages
-
In updating my iPod to 6.1.2, I received an error during the update. Now, my ipod is not rebooting. It continues to display a screen showing usb to Itunes picture. Turning off and back on, it goes back to this picture. I don't know how to reset so that I can restore from my backup.
A similar thing happened when I updated the ios on my ipad. But, I was able to reboot, and then restore from backup. How can I get my ipod to reboot and allow restore when it is not even recognized as I reconnect to my computer?Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
Hi,
I got an error during spam update. The version is ECC 6.0. It got terminated during the phase IMPORT_OBJECT_LIST. how it can rectified.
Pls help me in resolving the issue.
Regards,
KrisHi,
ERROR: No connect due to DbSl Load Lib Failure
ERROR: environment variable DIR_LIBRARY is not set.
ERROR: Connect to DEV failed (20071118181034).
This is the error i got when i checked the tp log
can any one suggest a resolution?
Regards,
Kris -
Error 1906? error with ipod updater
I installed itunes 5 , pc/itunes no longer recognizes ipod. tried to download the 9-06 ipod updater. installing it, it gets as far as registering the product then, i get this message:
error 1906. Failed to cache package C:\WINDOWS\Installer\1bab014.msi. Error -2147286775. contact your support personel.
retry or cancel.
retry gets same result.
cancelling gets:
error 1603 Fatal error during installation.
ANY HELP? PLEASE?anyone help? please??
-
Downloaded new iTunes/iPod updater, iTunes now crashes during iPod updating
I downloaded the new iTunes and iPod updater yesterday-- now when I plug my iPod into the USB, it recognizes my iPod, the "Updating iPod. Do not disconnect." message comes up, but as soon as "Updating Track 1 of 9." appears, I get a Send Error Report message "iTunes has encountered a problem and needs to close. We are sorry for the inconvenience. etc" (I wasn't sure what, if anything, I shoudl include here from the Error Report Contents.) Has anyone else encountered this or have any tips? I've tried the uninstall/reinstall trick to no avail.
Thanks!I fixed this for my Nano by using the iPod Updater Restore to revert the firmware to version 1.0 and removing iTunes 6.0.2 through Control Panel. I didn't delete the leftover directories. I then reinstalled iTunes version 6.0.1.3.
The Nano is now happily recopying all my music. Should be done by midnight.
Good luck. -
Internal Error in ipod updater!
ipod is brand new from the apple store...i plug it in, exact message...
"This ipod needs to be reformatted for use on PC. Click on updater button to run ipod updater blah blah blah..."
i click to update...updater runs for a second then a message says "ipod manager internal error"
what do i do!!!
i just got it replaced today!!Hello,
Please see if it helps
http://docs.info.apple.com/article.html?artnum=301907 -
After software download and update Adobe Application Manager gives the following errors:
Touch App Plugin Update
Installation failed. Error Code: U44M1P7
DPS Desktop Tools CS6 2.05.1 Update
There was an error installing this update. Please quit and try again later. Error Code: U44M1I200
What do I need to do?Hi there,
Please follow the instructions mentioned in the below document:
http://helpx.adobe.com/photoshop/kb/photoshop-cs6-updates-dont-install.html
Regards,
Jairaj -
Unkown error during software update... What's happening?
Last night I set my iphone up for an update. It first decided to backup itself... Which took ages, so I went to sleep leaving the process on.
When I woke up in the morning, it said "Update is failed due to an unkonwn error"... something along those lines anyway.
Now my iphone does not start, itunes does not recognize it as well.
Since I have got it, everyday, I am coming to realize another thing that is wrong with this phone... It really *****! It is the second last worst phone I had ever used in my life, if not the worst!
Itunes never sync properly, it is either my calender or songs that are left out...
Somebody please advice something so it starts to work out...
(For those who don't have an iphone yet; NEVER BUY ONE. IT IS A GREAT HARDWARE BUT SOFTWARE IS HORRIBLEHello,
Regarding the error in software update: It just means you lost your internet connection, but it was the fault of something on your side, not Apple's side. Try again later, or better yet, try it somewhere else. Sounds like your internet setup (your router, modem, etc) is having problems. -
Error during software update, slow browsing speed and maximum force quits ?
I have a mac book. Today i was doing software update, it gave me an error "operation could not be completed, connection reset by peer" ? now what does that mean?
I had recently downloaded open office application which i have deleted it. Further my internet browser are so slow that i feel surfing in stone age.
Besides, i have seen my system is getting pretty slow and i have to use force quit as some operation do not respond to the request.
What to do?Hello,
Regarding the error in software update: It just means you lost your internet connection, but it was the fault of something on your side, not Apple's side. Try again later, or better yet, try it somewhere else. Sounds like your internet setup (your router, modem, etc) is having problems. -
ITunes Quit During iPod Update Now I Get An Error Message
iTunes quit while i was updating my 1 gen iPod touch to the 2.2 firmware now I get an error message everytime i connect my iPod thay says.
An iPod has been detected, but it could not be identified properly. Please disconnect and reconnect the iPod, then try again. AN unknown error occurred (2001).
What do i do now? I tried everything and nothing worked can someone please helpI would start by removing and reinstalling iTunes: http://support.apple.com/kb/HT1747
Followed by a reset of the touch - hold down the Sleep/Wake key and the home button until the Apple logo appears (about 10 seconds). Try your update again. If you still have problems with the touch, you are going to have to reset it: http://support.apple.com/kb/HT1238 and try again. -
Backup error during iOS5 update
Just trying to update my ipad2 to iOS5 and iTunes gives me a message - unable to backup error -54, with the option to continue but lose all the data. Backs up perfectly during a normal sync - just won't do it for the update. Does anyone know why this error is hapenning and what to do about it please?
http://support.apple.com/kb/TS3694#error48
-
When I was trying to update my iPod to iOS4 I got an "Error 14"
After this, my iPod went into "Restore Mode" and I've tried restoring but I waited 3 hours and the restoring bar didn't move at all.
I have tried multiple things including trying different USB ports/cords, uninstalling/reinstalling iTunes, and putting the iPod into DFU mode.
I don't really know what to do now, and I'm really hoping to get my iPod working by Monday, the 28, because I'm leaving on vacation.Apple is not here. This is a user to user forum.
http://www.apple.com/feedback/ipad.html
Dah•veed -
Hi everyone. I got a big problem. I updated my iTouch 4 (32 GO) , and there was an error . And now, my ipod ask me to sync with iTunes, but Windows & iTunes doesn't recognize the ipod. I reboot my computer, iTunes, my iPod, and nothing change ! Can you help me please ?
Waht ws the wording of the error message? Most give an error number. The following list possible errros and their resolution.
http://support.apple.com/kb/TS3694
You might want to try placing the iPod in recovry mode and then try restoring the iPod via iTunes. This will erase the iPod. For recovery mode see:
iPhone and iPod touch: Unable to update or restore -
HT4623 Why does my iphone say "Activation Error" during the updating process?
after updating my iphone, the process is like asking the language, then the country, and then the wifi right? after i connected to the wifi, i pressed "next" then it says "Activating your Iphone" then suddenly it says "Activation Error". what does this mean? can i just restore the previous version of this iphone again?
You cannot install the previous version. "Activaton error" usually means that the phone was hacked or jailbroken to unlock it from the carrier it was locked to. It is now locked again to that carrier.
-
I tried to update the latest OS, error message appears in the middle of updating. iTune logo and connected appeared on iPad screen. iPad does not work since then. Any. Suggestion?
Connect the iPad to your computer and launch iTunes. Do as the message says. You probably have to restore the iPad now. Click on the summary tab when iTunes opens and click on restore. Restore from your backup when you are done.
Restoring iOS software. Pay attention to the very last part of the article as well.
http://support.apple.com/kb/HT1414
Maybe you are looking for
-
I have an iphone 4, all of a sudden it turned itself off and wont turn back on!!
I have looked on the internet for reasons why this would happen and nothing is adding up!e i have checked for water damage which came back negative, i have connected it to itunes whilst holding the home & on/off button, i have also left it to charge
-
Purchasing: gr/ir clearing not extracted with 2lis_02_itm
Hi, I hope anyone with experience with the extraction of purchasing can help: We want to determine the quantity to be delivered/quantity to be invoiced per vendor in BW (just like the R/3 ME2L report). We get wrong results, since items that are clear
-
How to simulate a mobile robot using labview
Hello, Is it possible to simulate the movement of a mobile robot using labview? I mean, is it possible to have a graphics window to show these movements? Thanks
-
I've looked under the 'more' tab in iTunes and the podcasts aren't there. The only way I can find them is if I search the individual podcasts. How do I get them back into my iTunes app?
-
Differences between rate routing and reference rate routings?
Hello PP members: I would like to differences between rate routing and reference rate routings Thanks for your time, Thanks Again, Suren R